- 您现在的位置：买卖IC网 > PDF目录1830 > LTC3568IDD#TRPBF (Linear Technology)IC REG BUCK SYNC ADJ 1.8A 10DFN PDF资料下载
参数资料
| 型号： | LTC3568IDD#TRPBF |
| 厂商： | Linear Technology |
| 文件页数： | 7/18页 |
| 文件大小： | 0K |
| 描述： | IC REG BUCK SYNC ADJ 1.8A 10DFN |
| 标准包装： | 2,500 |
| 类型： | 降压（降压） |
| 输出类型： | 可调式 |
| 输出数： | 1 |
| 输出电压： | 0.8 V ~ 5 V |
| 输入电压： | 2.5 V ~ 5.5 V |
| PWM 型： | 电流模式，混合 |
| 频率 - 开关： | 最高 4MHz |
| 电流 - 输出： | 1.8A |
| 同步整流器： | 是 |
| 工作温度： | -40°C ~ 125°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 10-WFDFN 裸露焊盘 |
| 包装： | 带卷 (TR) |
| 供应商设备封装： | 10-DFN（3x3） |
LTC3568
OPERATION
The LTC3568 uses a constant frequency, current mode
architecture. The operating frequency is determined by
the value of the R T resistor or can be synchronized to an
external oscillator. To suit a variety of applications, the
selectable Mode pin, allows the user to trade-off noise
for efficiency.
The output voltage is set by an external divider returned
to the V FB pin. An error amplfier compares the divided
output voltage with a reference voltage of 0.8V and adjusts
the peak inductor current accordingly. Overvoltage and
undervoltage comparators will pull the PGOOD output
low if the output voltage is not within ±7.5%.
Main Control Loop
During normal operation, the top power switch (P-channel
MOSFET) is turned on at the beginning of a clock cycle
when the V FB voltage is below the the reference voltage.
The current into the inductor and the load increases until
the current limit is reached. The switch turns off and
energy stored in the inductor flows through the bottom
switch (N-channel MOSFET) into the load until the next
clock cycle.
The peak inductor current is controlled by the voltage on
the I TH pin, which is the output of the error amplifier.This
amplifier compares the V FB pin to the 0.8V reference.
When the load current increases, the V FB voltage decreases
slightly below the reference. This decrease causes the er-
ror amplifier to increase the I TH voltage until the average
inductor current matches the new load current.
The main control loop is shut down by pulling the SHDN/R T
pin to SV IN . A digital soft-start is enabled after shutdown,
which will slowly ramp the peak inductor current up over
1024 clock cycles or until the output reaches regulation,
whichever is first. Soft-start can be lengthened by ramping
the voltage on the I TH pin (see Applications Information
section).
Low Current Operation
Three modes are available to control the operation of the
LTC3568 at low currents. All three modes automatically
switch from continuous operation to to the selected mode
when the load current is low.
To optimize efficiency, the Burst Mode operation can be
selected. When the load is relatively light, the LTC3568
automatically switches into Burst Mode operation in which
the PMOS switch operates intermittently based on load
demand. By running cycles periodically, the switching
losses which are dominated by the gate charge losses
of the power MOSFETs are minimized. The main control
loop is interrupted when the output voltage reaches the
desired regulated value. The hysteretic voltage comparator
B trips when I TH is below 0.24V, shutting off the switch and
reducing the power. The output capacitor and the inductor
supply the power to the load until I TH /RUN exceeds 0.31V,
turning on the switch and the main control loop which
starts another cycle.
For lower output voltage ripple at low currents, pulse
skipping mode can be used. In this mode, the LTC3568
continues to switch at a constant frequency down to
very low currents, where it will eventually begin skipping
pulses.
Finally, in forced continuous mode, the inductor current
is constantly cycled which creates a fixed output voltage
ripple at all output current levels. This feature is desirable
in telecommunications since the noise is at a constant
frequency and is thus easy to filter out. Another advan-
tage of this mode is that the regulator is capable of both
sourcing current into a load and sinking some current
from the output.
Dropout Operation
When the input supply voltage decreases toward the
output voltage, the duty cycle increases to 100% which
is the dropout condition. In dropout, the PMOS switch is
turned on continuously with the output voltage being equal
to the input voltage minus the voltage drops across the
internal P-channel MOSFET and the inductor.
Low Supply Operation
The LTC3568 incorporates an undervoltage lockout circuit
which shuts down the part when the input voltage drops
below about 2V.
3568fa
相关PDF资料 |
PDF描述 |
|---|---|
| LTC3569IFE#TRPBF | IC REG BUCK SYNC ADJ 16TSSOP |
| LTC3600EMSE#PBF | IC REG BUCK SYNC ADJ 1.5A 12MSOP |
| LTC3601IUD#TRPBF | IC REG BUCK SYNC ADJ 1.5A 16QFN |
| LTC3602IFE#TRPBF | IC REG BUCK SYNC ADJ 16TSSOP |
| LTC3603IUF#TRPBF | IC REG BUCK SYNC ADJ 2.5A 20QFN |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LTC3569 | 制造商:LINER 制造商全称:Linear Technology 功能描述:7-Channel Confi gurable High Power PMIC |
| LTC3569EFE | 制造商:Linear Technology 功能描述:DC/DC Converter Chip |
| LTC3569EFE#PBF | 功能描述:IC REG BUCK SYNC ADJ 16TSSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 开关稳压器 系列:- 标准包装:250 系列:- 类型:降压（降压） 输出类型:固定 输出数:1 输出电压:1.2V 输入电压:2.05 V ~ 6 V PWM 型:电压模式 频率 - 开关:2MHz 电流 - 输出:500mA 同步整流器:是 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:6-UFDFN 包装:带卷 (TR) 供应商设备封装:6-SON（1.45x1） 产品目录页面:1032 (CN2011-ZH PDF) 其它名称:296-25628-2 |
| LTC3569EFE#TRPBF | 功能描述:IC REG BUCK SYNC ADJ 16TSSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 开关稳压器 系列:- 标准包装:2,500 系列:- 类型:降压（降压） 输出类型:固定 输出数:1 输出电压:1.2V，1.5V，1.8V，2.5V 输入电压:2.7 V ~ 20 V PWM 型:- 频率 - 开关:- 电流 - 输出:50mA 同步整流器:是 工作温度:-40°C ~ 125°C 安装类型:表面贴装 封装/外壳:10-TFSOP，10-MSOP（0.118"，3.00mm 宽）裸露焊盘 包装:带卷 (TR) 供应商设备封装:10-MSOP 裸露焊盘 |
| LTC3569EFE-PBF | 制造商:LINER 制造商全称:Linear Technology 功能描述:Triple Buck Regulator With 1.2A and Two 600mA Outputs and Individual Programmable References |
发布紧急采购，3分钟左右您将得到回复。