- 您现在的位置：买卖IC网 > PDF目录14798 > LTC3605EUF#PBF (Linear Technology)IC REG BUCK SYNC ADJ 5A 24QFN PDF资料下载
参数资料
| 型号： | LTC3605EUF#PBF |
| 厂商： | Linear Technology |
| 文件页数： | 6/22页 |
| 文件大小： | 0K |
| 描述： | IC REG BUCK SYNC ADJ 5A 24QFN |
| 标准包装： | 91 |
| 类型： | 降压（降压） |
| 输出类型： | 可调式 |
| 输出数： | 1 |
| 输出电压： | 0.6 V ~ 14.9 V |
| 输入电压： | 4 V ~ 15 V |
| PWM 型： | 电流模式 |
| 频率 - 开关： | 1MHz |
| 电流 - 输出： | 5A |
| 同步整流器： | 是 |
| 工作温度： | -40°C ~ 85°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 24-WFQFN 裸露焊盘 |
| 包装： | 管件 |
| 供应商设备封装： | 24-QFN（4x4） |
| 产品目录页面： | 1335 (CN2011-ZH PDF) |
LTC3605
PIN FUNCTIONS
RT (Pin 1): Oscillator Frequency Programming Pin. Con-
nect an external resistor (between 200k to 40k) from RT
to SGND to program the frequency from 800kHz to 4MHz.
Since the synchronization range is ±30% of set frequency,
be sure that the set frequency is within this percentage
range of the external clock to ensure frequency lock.
PHMODE (Pin 2): Control Input to Phase Selector. Deter-
mines the phase relationship between internal oscillator
and CLKOUT. Tie it to INTV CC for 2-phase operation, tie it
to SGND for 3-phase operation, and tie it to INTV CC /2 for
4-phase operation.
MODE (Pin 3): Operation Mode Select. Tie this pin to
INTV CC to force continuous synchronous operation at all
output loads. Tying it to SGND enables discontinuous mode
operation at light loads. Tying this pin to INTV CC /2 shuts
off the internal clock during discontinuous intervals.
FB (Pin 4): Output Feedback Voltage. Input to the error
amplifier that compares the feedback voltage to the internal
0.6V reference voltage. This pin is normally connected to
a resistive divider from the output voltage.
TRACK/SS (Pin 5): Output Tracking and Soft-Start Pin.
Allows the user to control the rise time of the output volt-
age. Putting a voltage below 0.6V on this pin bypasses
the internal reference input to the error amplifier, instead
it servos the FB pin to the TRACK voltage. Above 0.6V,
the tracking function stops and the internal reference
resumes control of the error amplifier. There’s an internal
2μA pull-up current from INTV CC on this pin, so putting a
capacitor here provides soft-start function.
ITH (Pin 6): Error Amplifier Output and Switching Regu-
lator Compensation Point. The current comparator’s trip
threshold is linearly proportional to this voltage, whose
normal range is from 0.3V to 1.8V. Tying this pin to INTV CC
activates internal compensation and output voltage po-
sitioning, raising V OUT to 1.5% higher than the nominal
value at I OUT = 0 and 1.5% lower at I OUT = 5A.
RUN (Pin 7): Run Control Input. Enables chip operation
by tying RUN above 1.2V. Tying it below 1.1V shuts down
the part.
PGOOD (Pin 8): Output Power Good with Open-Drain Logic.
PGOOD is pulled to ground when the voltage on the FB pin
is not within ±10% of the internal 0.6V reference.
6
V ON (Pin 9): On-Time Voltage Input. Voltage trip point for
the on-time comparator. Tying this pin to the output volt-
age makes the on-time proportional to V OUT and keeps the
switching frequency constant at different V OUT . However,
when V ON is <0.6V or >6V, then switching frequency will
no longer remain constant.
PGND (Pin 10, Exposed Pad Pin 25): Power Ground.
Return path of internal power MOSFETs. Connect this
pin to the negative terminals of the input capacitor and
output capacitor. The exposed pad must be soldered to
the PCB ground for electrical contact and rated thermal
performance.
SW (Pins 11 to 16): Switch Node Connection to External
Inductor. Voltage swing of SW is from a diode voltage
drop below ground to PV IN .
PV IN (Pins 17, 18): Power V IN . Input voltage to the on-
chip power MOSFETs.
SV IN (Pin 19): Signal V IN . Filtered input voltage to the
on-chip 3.3V regulator. Connect a (1Ω to 10Ω) resistor
between SV IN and PV IN and bypass to GND with a 0.1μF
capacitor.
BOOST (Pin 20): Boosted Floating Driver Supply for Inter-
nal Top Power MOSFET. The (+) terminal of the bootstrap
capacitor connects here. This pin swings from a diode
voltage drop below INTV CC up to PV IN + INTV CC .
INTV CC (Pin 21): Internal 3.3V Regulator Output. The
internal power drivers and control circuits are powered
from this voltage. Decouple this pin to power ground with
a minimum of 1μF low ESR ceramic capacitor.
SGND (Pin 22): Signal Ground Connection.
CLKOUT (Pin 23): Output Clock Signal for PolyPhase
Operation. The phase of CLKOUT with respect to CLKIN
is determined by the state of the PHMODE pin. CLKOUT’s
peak-to-peak amplitude is INTV CC to GND.
CLKIN (Pin 24): External Synchronization Input to Phase
Detector. This pin is internally terminated to SGND with 20k.
The phase-locked loop will force the top power NMOS’s
turn on signal to be synchronized with the rising edge of
the CLKIN signal.
3605fc
相关PDF资料 |
PDF描述 |
|---|---|
| LT3972EDD#PBF | IC REG BUCK ADJ 3.5A 10DFN |
| LT1956IGN#PBF | IC REG BUCK ADJ 1.5A 16SSOP |
| LTC3414EFE#PBF | IC REG BUCK SYNC ADJ 4A 20TSSOP |
| EBC40DRTI-S13 | CONN EDGECARD 80POS .100 EXTEND |
| LT1054IS8#PBF | IC REG SWITCHD CAP DBL INV 8SOIC |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LTC3605IUF#PBF | 功能描述:IC REG BUCK SYNC ADJ 5A 24QFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 开关稳压器 系列:- 设计资源:Design Support Tool 标准包装:1 系列:- 类型:升压（升压） 输出类型:固定 输出数:1 输出电压:3V 输入电压:0.75 V ~ 2 V PWM 型:- 频率 - 开关:- 电流 - 输出:100mA 同步整流器:是 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:SOT-23-5 细型，TSOT-23-5 包装:剪切带 (CT) 供应商设备封装:TSOT-23-5 其它名称:AS1323-BTTT-30CT |
| LTC3605IUF#TRPBF | 功能描述:IC REG BUCK SYNC ADJ 5A 24QFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 开关稳压器 系列:- 设计资源:Design Support Tool 标准包装:1 系列:- 类型:升压（升压） 输出类型:固定 输出数:1 输出电压:3V 输入电压:0.75 V ~ 2 V PWM 型:- 频率 - 开关:- 电流 - 输出:100mA 同步整流器:是 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:SOT-23-5 细型，TSOT-23-5 包装:剪切带 (CT) 供应商设备封装:TSOT-23-5 其它名称:AS1323-BTTT-30CT |
| LTC3606BEDD#PBF | 功能描述:IC REG BUCK SYNC ADJ 0.8A 8DFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 开关稳压器 系列:- 标准包装:250 系列:- 类型:降压（降压） 输出类型:固定 输出数:1 输出电压:1.2V 输入电压:2.05 V ~ 6 V PWM 型:电压模式 频率 - 开关:2MHz 电流 - 输出:500mA 同步整流器:是 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:6-UFDFN 包装:带卷 (TR) 供应商设备封装:6-SON（1.45x1） 产品目录页面:1032 (CN2011-ZH PDF) 其它名称:296-25628-2 |
| LTC3606BEDD#PBF | 制造商:Linear Technology 功能描述:IC SYNC STEP-DOWN DC/DC CONVERTER DFN8 |
| LTC3606BEDD#TRPBF | 功能描述:IC REG BUCK SYNC ADJ 0.8A 8DFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 开关稳压器 系列:- 标准包装:2,500 系列:- 类型:升压（升压） 输出类型:可调式 输出数:1 输出电压:1.24 V ~ 30 V 输入电压:1.5 V ~ 12 V PWM 型:电流模式，混合 频率 - 开关:600kHz 电流 - 输出:500mA 同步整流器:无 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:8-SOIC（0.154"，3.90mm 宽） 包装:带卷 (TR) 供应商设备封装:8-SOIC |
发布紧急采购，3分钟左右您将得到回复。