- 您现在的位置：买卖IC网 > PDF目录13808 > LTC3609IWKG#PBF (Linear Technology)IC REG BUCK SYNC ADJ 6A 52QFN PDF资料下载
参数资料
| 型号： | LTC3609IWKG#PBF |
| 厂商： | Linear Technology |
| 文件页数： | 10/26页 |
| 文件大小： | 0K |
| 描述： | IC REG BUCK SYNC ADJ 6A 52QFN |
| 标准包装： | 45 |
| 类型： | 降压（降压） |
| 输出类型： | 可调式 |
| 输出数： | 1 |
| 输出电压： | 0.6 V ~ 36 V |
| 输入电压： | 4 V ~ 32 V |
| PWM 型： | 电流模式 |
| 电流 - 输出： | 6A |
| 同步整流器： | 是 |
| 工作温度： | -40°C ~ 125°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 52-VFQFN 裸露焊盘 |
| 包装： | 管件 |
| 供应商设备封装： | 52-QFN（7x8）裸露焊盘 |
LTC3609
OPERATION
Main Control Loop
The LTC3609 is a high efficiency monolithic synchronous,
step-down DC/DC converter utilizing a constant on-time,
current mode architecture. It operates from an input
voltage range of 4V to 32V/36V maximum and provides
a regulated output voltage at up to 6A of output current.
The internal synchronous power switch increases efficiency
and eliminates the need for an external Schottky diode. In
normal operation, the top MOSFET is turned on for a fixed
interval determined by a one-shot timer OST. When the
top MOSFET is turned off, the bottom MOSFET is turned
on until the current comparator I CMP trips, restarting the
one-shot timer and initiating the next cycle. Inductor current
is determined by sensing the voltage between the PGND
and SW pins using the bottom MOSFET on-resistance.
The voltage on the I TH pin sets the comparator threshold
corresponding to inductor valley current. The error ampli-
fier, EA, adjusts this voltage by comparing the feedback
signal V FB from the output voltage with an internal 0.6V
reference. If the load current increases, it causes a drop
in the feedback voltage relative to the reference. The I TH
voltage then rises until the average inductor current again
matches the load current.
At light load, the inductor current can drop to zero and
become negative. This is detected by current reversal
comparator I REV which then shuts off M2 (see Func-
tional Diagram), resulting in discontinuous operation. Both
switches will remain off with the output capacitor supplying
the load current until the I TH voltage rises above the zero
current level (0.8V) to initiate another cycle. Discontinu-
ous mode operation is disabled by comparator F when
the FCB pin is brought below 0.6V, forcing continuous
synchronous operation.
The operating frequency is determined implicitly by the
top MOSFET on-time and the duty cycle required to main-
tain regulation. The one-shot timer generates an on-time
that is proportional to the ideal duty cycle, thus holding
frequency approximately constant with changes in V IN .
The nominal frequency can be adjusted with an external
resistor, R ON .
Overvoltage and undervoltage comparators OV and UV
pull the PGOOD output low if the output feedback volt-
age exits a ±10% window around the regulation point.
Furthermore, in an overvoltage condition, M1 is turned
off and M2 is turned on and held on until the overvoltage
condition clears.
Foldback current limiting is provided if the output is
shorted to ground. As V FB drops, the buffered current
threshold voltage I THB is pulled down by clamp Q3 to
a 1V level set by Q4 and Q6. This reduces the inductor
valley current level to one sixth of its maximum value as
V FB approaches 0V.
Pulling the RUN/SS pin low forces the controller into its
shutdown state, turning off both M1 and M2. Releasing
the pin allows an internal 1.2μA current source to charge
up an external soft-start capacitor, C SS . When this voltage
reaches 1.5V, the controller turns on and begins switching,
but with the I TH voltage clamped at approximately 0.6V
below the RUN/SS voltage. As C SS continues to charge,
the soft-start current limit is removed.
INTV CC /EXTV CC Power
Power for the top and bottom MOSFET drivers and most of
the internal controller circuitry is derived from the INTV CC
pin. The top MOSFET driver is powered from a floating
bootstrap capacitor, C B . This capacitor is recharged from
INTV CC through an external Schottky diode, D B , when
the top MOSFET is turned off. When the EXTV CC pin is
grounded, an internal 5V low dropout regulator supplies
the INTV CC power from V IN . If EXTV CC rises above 4.7V,
the internal regulator is turned off, and an internal switch
connects EXTV CC to INTV CC . This allows a high efficiency
source connected to EXTV CC , such as an external 5V sup-
ply or a secondary output from the converter, to provide
the INTV CC power. Voltages up to 7V can be applied to
EXTV CC for additional gate drive. If the input voltage is
low and INTV CC drops below 3.5V, undervoltage lockout
circuitry prevents the power switches from turning on.
3609fb
0
相关PDF资料 |
PDF描述 |
|---|---|
| LT3511MPMS#TRPBF | IC REG FLYBK ISO ADJ .24A 16MSOP |
| V72B3V3C100BG2 | CONVERTER MOD DC/DC 3.3V 100W |
| GMA15DTAD | CONN EDGECARD 30POS R/A .125 SLD |
| AS1330-BTDT-AD | IC REG BST SYNC ADJ 0.15A 8TDFN |
| MAX6721AUTZGD1+T | IC SUPERVISOR MPU SOT23-6 |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LTC3610EWP#PBF | 功能描述:IC REG BUCK SYNC ADJ 12A 64QFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 开关稳压器 系列:- 标准包装:250 系列:- 类型:降压（降压） 输出类型:固定 输出数:1 输出电压:1.2V 输入电压:2.05 V ~ 6 V PWM 型:电压模式 频率 - 开关:2MHz 电流 - 输出:500mA 同步整流器:是 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:6-UFDFN 包装:带卷 (TR) 供应商设备封装:6-SON（1.45x1） 产品目录页面:1032 (CN2011-ZH PDF) 其它名称:296-25628-2 |
| LTC3610EWP#TRPBF | 功能描述:IC REG BUCK SYNC ADJ 12A 64QFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 开关稳压器 系列:- 设计资源:Design Support Tool 标准包装:1 系列:- 类型:升压（升压） 输出类型:固定 输出数:1 输出电压:3V 输入电压:0.75 V ~ 2 V PWM 型:- 频率 - 开关:- 电流 - 输出:100mA 同步整流器:是 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:SOT-23-5 细型，TSOT-23-5 包装:剪切带 (CT) 供应商设备封装:TSOT-23-5 其它名称:AS1323-BTTT-30CT |
| LTC3610EWPPBF | 制造商:Linear Technology 功能描述:12A 24V Synch Step Down Reg LTC3610 |
| LTC3610IWP#PBF | 功能描述:IC REG BUCK SYNC ADJ 12A 64QFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 开关稳压器 系列:- 设计资源:Design Support Tool 标准包装:1 系列:- 类型:升压（升压） 输出类型:固定 输出数:1 输出电压:3V 输入电压:0.75 V ~ 2 V PWM 型:- 频率 - 开关:- 电流 - 输出:100mA 同步整流器:是 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:SOT-23-5 细型，TSOT-23-5 包装:剪切带 (CT) 供应商设备封装:TSOT-23-5 其它名称:AS1323-BTTT-30CT |
| LTC3610IWP#TRPBF | 功能描述:IC REG BUCK SYNC ADJ 12A 64QFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 开关稳压器 系列:- 设计资源:Design Support Tool 标准包装:1 系列:- 类型:升压（升压） 输出类型:固定 输出数:1 输出电压:3V 输入电压:0.75 V ~ 2 V PWM 型:- 频率 - 开关:- 电流 - 输出:100mA 同步整流器:是 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:SOT-23-5 细型，TSOT-23-5 包装:剪切带 (CT) 供应商设备封装:TSOT-23-5 其它名称:AS1323-BTTT-30CT |
发布紧急采购，3分钟左右您将得到回复。