- 您现在的位置：买卖IC网 > PDF目录15314 > LTC3703EGN-5#TR (Linear Technology)IC REG CTRLR BST PWM VM 16-SSOP PDF资料下载
参数资料
| 型号： | LTC3703EGN-5#TR |
| 厂商： | Linear Technology |
| 文件页数： | 10/32页 |
| 文件大小： | 0K |
| 描述： | IC REG CTRLR BST PWM VM 16-SSOP |
| 标准包装： | 2,500 |
| PWM 型： | 电压模式 |
| 输出数： | 1 |
| 频率 - 最大： | 330kHz |
| 占空比： | 96% |
| 电源电压： | 4.1 V ~ 15 V |
| 降压： | 是 |
| 升压： | 是 |
| 回扫： | 无 |
| 反相： | 无 |
| 倍增器： | 无 |
| 除法器： | 无 |
| Cuk： | 无 |
| 隔离： | 无 |
| 工作温度： | -40°C ~ 85°C |
| 封装/外壳： | 16-SSOP（0.154"，3.90mm 宽） |
| 包装： | 带卷 (TR) |
第1页第2页第3页第4页第5页第6页第7页第8页第9页当前第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页
LTC3703-5
OPERATIO
(Refer to Functional Diagram)
MOSFETs can occur. To prevent this from occuring, the
bottom driver return is brought out as a separate pin
(BGRTN) so that a negative supply can be used to reduce
the effect of the Miller pull-up. For example, if a –2V supply
is used on BGRTN, the switch node dV/dt could pull the
gate up 2V before the V GS of the bottom MOSFET has more
than 0V across it.
DRV CC V IN
cycle control set to 0%. As C SS continues to charge, the
duty cycle is gradually increased, allowing the output
voltage to rise. This soft-start scheme smoothly ramps the
output voltage to its regulated value, with no overshoot.
The RUN/SS voltage will continue ramping until it reaches
an internal 4V clamp. Then the MIN feedback comparator
is enabled and the LTC3703-5 is in full operation. When the
RUN/SS is low, the supply current is reduced to 25 μ A.
LTC3703-5
DRV CC
BOOST
D B
+
C IN
V OUT
TG
C B
M1
0V
SW
BG
M2
L
+
V OUT
C OUT
4V
SHUTDOWN START-UP
NORMAL OPERATION
MIN COMPARATOR ENABLED
OUTPUT VOLTAGE
IN REGULATION
CURRENT
LIMIT
BGRTN
0V TO –5V
37035 F02
3V
V RUN/SS
1.4V
RUN/SS SOFT-STARTS
OUTPUT VOLTAGE AND
INDUCTOR CURRENT
1V
Figure 2. Floating TG Driver Supply and Negative BG Return
0V
MINIMUM
DUTY CYCLE
Constant Frequency
LTC3703-5 POWER
ENABLE DOWN MODE
37035 F03
The internal oscillator can be programmed with an exter-
nal resistor connected from f SET to ground to run between
100kHz and 600kHz, thereby optimizing component size,
efficiency, and noise for the specific application. The
internal oscillator can also be synchronized to an external
clock applied to the MODE/SYNC pin and can lock to a
frequency in the 100kHz to 600kHz range. When locked to
an external clock, Pulse Skip Mode operation is automati-
cally disabled. Constant frequency operation brings with it
a number of benefits: Inductor and capacitor values can be
chosen for a precise operating frequency and the feedback
loop can be similarly tightly specified. Noise generated by
the circuit will always be at known frequencies.
Subharmonic oscillation and slope compensation, com-
mon headaches with constant frequency current mode
switchers, are absent in voltage mode designs like the
LTC3703-5.
Shutdown/Soft-Start
The main control loop is shut down by pulling RUN/SS pin
low. Releasing RUN/SS allows an internal 4 μ A current
source to charge the soft-start capacitor C SS . When C SS
reaches 1V, the main control loop is enabled with the duty
Figure 3. Soft-Start Operation in Start Up and Current Limit
Current Limit
The LTC3703-5 includes an onboard current limit circuit
that limits the maximum output current to a user-pro-
grammed level. It works by sensing the voltage drop across
the bottom MOSFET and comparing that voltage to a user-
programmed voltage at the I MAX pin. Since the bottom
MOSFET looks like a low value resistor during its on-time,
the voltage drop across it is proportional to the current
flowing in it. In a buck converter, the average current in the
inductor is equal to the output current. This current also
flows through the bottom MOSFET during its on-time.
Thus by watching the drain-to-source voltage when the
bottom MOSFET is on, the LTC3703-5 can monitor the
output current. The LTC3703-5 senses this voltage and
inverts it to allow it to compare the sensed voltage (which
becomes more negative as peak current increases) with a
positive voltage at the I MAX pin. The I MAX pin includes a
12 μ A pull-up, enabling the user to set the voltage at I MAX
with a single resistor (R IMAX ) to ground. See the Current
Limit Programming section for R IMAX selection.
37035fa
10
相关PDF资料 |
PDF描述 |
|---|---|
| VI-22Y-EY-B1 | CONVERTER MOD DC/DC 3.3V 33W |
| EBC36DREH-S734 | CONN EDGECARD 72POS .100 EYELET |
| VI-22X-EY-B1 | CONVERTER MOD DC/DC 5.2V 50W |
| LTC3703EGN#TRPBF | IC REG CTRLR BST PWM VM 16-SSOP |
| CDRH4D28NP-220NC | INDUCTOR POWER 22UH 0.70A SMD |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LTC3703EGNPBF | 制造商:Linear Technology 功能描述:100V Synch Sw. Reg. Controller SSOP16 |
| LTC3703EGPBF | 制造商:Linear Technology 功能描述:LTC3703 100V SU/SD PS controller |
| LTC3703HGN | 制造商:Linear Technology 功能描述:DC DC Cntrlr Single-OUT Sync Step Down 9.3V to 100V Input 16-Pin SSOP N |
| LTC3703HGN#PBF | 功能描述:IC REG CTRLR BST PWM VM 16-SSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:2,500 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:500kHz 占空比:96% 电源电压:4 V ~ 36 V 降压:无 升压:是 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:24-WQFN 裸露焊盘 包装:带卷 (TR) |
| LTC3703HGN#TRPBF | 功能描述:IC REG CTRLR BST PWM VM 16-SSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:2,500 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:500kHz 占空比:96% 电源电压:4 V ~ 36 V 降压:无 升压:是 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:24-WQFN 裸露焊盘 包装:带卷 (TR) |
发布紧急采购，3分钟左右您将得到回复。