参数资料
型号: LTC3703EGN-5#TR
厂商: Linear Technology
文件页数: 11/32页
文件大小: 0K
描述: IC REG CTRLR BST PWM VM 16-SSOP
标准包装: 2,500
PWM 型: 电压模式
输出数: 1
频率 - 最大: 330kHz
占空比: 96%
电源电压: 4.1 V ~ 15 V
降压:
升压:
回扫:
反相:
倍增器:
除法器:
Cuk:
隔离:
工作温度: -40°C ~ 85°C
封装/外壳: 16-SSOP(0.154",3.90mm 宽)
包装: 带卷 (TR)
LTC3703-5
OPERATIO
(Refer to Functional Diagram)
For maximum protection, the LTC3703-5 current limit
consists of a steady-state limit circuit and an instanta-
neous limit circuit. The steady-state limit circuit is a g m
amplifier that pulls a current from the RUN/SS pin propor-
tional to the difference between the SW and I MAX voltages.
This current begins to discharge the capacitor at RUN/SS,
reducing the duty cycle and controlling the output voltage
until the current regulates at the limit. Depending on the
size of the capacitor, it may take many cycles to discharge
the RUN/SS voltage enough to properly regulate the
output current. This is where the instantaneous limit
circuit comes into play. The instantaneous limit circuit is
a cycle-by-cycle comparator which monitors the bottom
MOSFET’s drain voltage and keeps the top MOSFET from
turning on whenever the drain voltage is 50mV above the
programmed max drain voltage. Thus the cycle-by-cycle
skip cycles to maintain regulation. The frequency drops
but this further improves efficiency by minimizing gate
charge losses. In forced continuous mode, the bottom
MOSFET is always on when the top MOSFET is off,
allowing the inductor current to reverse at low currents.
This mode is less efficient due to resistive losses, but has
the advantage of better transient response at low currents,
constant frequency operation, and the ability to maintain
regulation when sinking current. See Figure 4 for a com-
parison of the effect on efficiency at light loads for each
mode. The MODE/SYNC threshold is 0.8V ± 7.5%, allow-
ing the MODE/SYNC to act as a feedback pin for regulating
a second winding. If the feedback voltage drops below
0.8V, the LTC3703-5 reverts to continuous operation to
maintain regulation in the secondary supply.
comparator will keep the inductor current under control
until the g m amplifier gains control.
Pulse Skip Mode
The LTC3703-5 can operate in one of two modes select-
100
90
80
70
60
V IN = 12V
V IN = 42V
able with the MODE/SYNC pin—Pulse Skip Mode or
forced continuous mode. Pulse Skip Mode is selected
when increased efficiency at light loads is desired. In this
mode, the bottom MOSFET is turned off when inductor
current reverses to minimize the efficiency loss due to
reverse current flow. As the load is decreased (see Fig-
ure 5), the duty cycle is reduced to maintain regulation
50
40
30
20
10
0
10
V IN = 12V
V IN = 42V
V OUT = 5V
FORCED CONTINUOUS
PULSE SKIP MODE
100 1000 10000
LOAD (mA)
37035 F04
until its minimum on-time (~200ns) is reached. When the
load decreases below this point, the LTC3703-5 begins to
PULSE SKIP MODE
Figure 4. Efficiency in Pulse Skip/Forced Continuous Modes
FORCED CONTINUOUS
DECREASING
LOAD
CURRENT
37035 F05
Figure 5. Comparison of Inductor Current Waveforms for Pulse Skip Mode and Forced Continuous Operation
37035fa
11
相关PDF资料
PDF描述
VI-22Y-EY-B1 CONVERTER MOD DC/DC 3.3V 33W
EBC36DREH-S734 CONN EDGECARD 72POS .100 EYELET
VI-22X-EY-B1 CONVERTER MOD DC/DC 5.2V 50W
LTC3703EGN#TRPBF IC REG CTRLR BST PWM VM 16-SSOP
CDRH4D28NP-220NC INDUCTOR POWER 22UH 0.70A SMD
相关代理商/技术参数
参数描述
LTC3703EGNPBF 制造商:Linear Technology 功能描述:100V Synch Sw. Reg. Controller SSOP16
LTC3703EGPBF 制造商:Linear Technology 功能描述:LTC3703 100V SU/SD PS controller
LTC3703HGN 制造商:Linear Technology 功能描述:DC DC Cntrlr Single-OUT Sync Step Down 9.3V to 100V Input 16-Pin SSOP N
LTC3703HGN#PBF 功能描述:IC REG CTRLR BST PWM VM 16-SSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:2,500 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:500kHz 占空比:96% 电源电压:4 V ~ 36 V 降压:无 升压:是 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:24-WQFN 裸露焊盘 包装:带卷 (TR)
LTC3703HGN#TRPBF 功能描述:IC REG CTRLR BST PWM VM 16-SSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:2,500 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:500kHz 占空比:96% 电源电压:4 V ~ 36 V 降压:无 升压:是 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:24-WQFN 裸露焊盘 包装:带卷 (TR)