- 您现在的位置：买卖IC网 > PDF目录15314 > LTC3703EGN#TR (Linear Technology)IC REG CTRLR BST PWM VM 16-SSOP PDF资料下载
参数资料
| 型号： | LTC3703EGN#TR |
| 厂商： | Linear Technology |
| 文件页数： | 12/34页 |
| 文件大小： | 0K |
| 描述： | IC REG CTRLR BST PWM VM 16-SSOP |
| 标准包装： | 2,500 |
| PWM 型： | 电压模式 |
| 输出数： | 1 |
| 频率 - 最大： | 330kHz |
| 占空比： | 96% |
| 电源电压： | 9.3 V ~ 15 V |
| 降压： | 是 |
| 升压： | 是 |
| 回扫： | 无 |
| 反相： | 无 |
| 倍增器： | 无 |
| 除法器： | 无 |
| Cuk： | 无 |
| 隔离： | 无 |
| 工作温度： | -40°C ~ 85°C |
| 封装/外壳： | 16-SSOP（0.154"，3.90mm 宽） |
| 包装： | 带卷 (TR) |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页当前第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页
LTC3703
OPERATION
(Refer to Functional Diagram)
R SET (k ? ) =
BuckorBoostModeOperation
The LTC3703 has the capability of operating both as a
step-down (buck) and step-up (boost) controller. In boost
mode, output voltages as high as 80V can be tightly regu-
lated. With the INV pin grounded, the LTC3703 operates
in buck mode with TG driving the main (topside) switch
and BG driving the synchronous (bottom side) switch.
If the INV pin is pulled above 2V, the LTC3703 operates
in boost mode with BG driving the main (bottom side)
switch and TG driving the synchronous (topside) switch.
Internal circuit operation is very similar regardless of the
APPLICATIONS INFORMATION
The basic LTC3703 application circuit is shown in Figure 1.
External component selection is determined by the input
voltage and load requirements as explained in the following
sections. After the operating frequency is selected, R SET
and L can be chosen. The operating frequency and the
inductor are chosen for a desired amount of ripple current
and also to optimize efficiency and component size. Next,
the power MOSFETs and D1 are selected based on voltage,
load and efficiency requirements. C IN is selected for its
ability to handle the large RMS currents in the converter
and C OUT is chosen with low enough ESR to meet the
output voltage ripple and transient specifications. Finally,
the loop compensation components are chosen to meet
the desired transient specifications.
Operating Frequency
The choice of operating frequency and inductor value is
a trade-off between efficiency and component size. Low
frequency operation improves efficiency by reducing MOS-
FET switching losses and gate charge losses. However,
lower frequency operation requires more inductance for a
given amount of ripple current, resulting in a larger induc-
tor size and higher cost. If the ripple current is allowed
to increase, larger output capacitors may be required to
maintain the same output ripple. For converters with high
step-down V IN to V OUT ratios, another consideration is
the minimum on-time of the LTC3703 (see the Minimum
On-Time Considerations section). A final consideration for
operating mode with the following exceptions: in boost
mode, pulse-skip mode operation is always disabled
regardless of the level of the MODE/SYNC pin and the
line feedforward compensation is also disabled. The
overcurrent circuitry continues to monitor the load cur-
rent by looking at the drain voltage of the main (bottom
side) MOSFET. In boost mode, however, the peak MOS-
FET current does not equal the load current but instead
I D = I LOAD /(1 – D). This factor needs to be taken into ac-
count when programming the I MAX voltage.
operating frequency is that in noise-sensitive communica-
tions systems, it is often desirable to keep the switching
noise out of a sensitive frequency band.
The LTC3703 uses a constant frequency architecture that
can be programmed over a 100kHz to 600kHz range with
a single resistor from the f SET pin to ground, as shown
in Figure 1. The nominal voltage on the f SET pin is 1.2V,
and the current that flows from this pin is used to charge
and discharge an internal oscillator capacitor. The value
of R SET for a given operating frequency can be chosen
from Figure 7 or from the following equation:
7100
f(kHz) – 25
1000
100
10
1
0 200 400 600 800 1000
FREQUENCY (kHz)
3703 F07
Figure 7. Timing Resistor (R SET ) Value
3703fc
12
相关PDF资料 |
PDF描述 |
|---|---|
| VI-220-EY-B1 | CONVERTER MOD DC/DC 5V 50W |
| CDRH4D28NP-1R8NC | INDUCTOR POWER 1.8UH 2.20A SMD |
| EEC31DRAI-S734 | CONN EDGECARD 62POS .100 R/A PCB |
| LTC1735CS-1#PBF | IC REG CTRLR BUCK PWM CM 16-SOIC |
| ESA22DRMN-S288 | CONN EDGECARD 44POS .125 EXTEND |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LTC3703EGPBF | 制造商:Linear Technology 功能描述:LTC3703 100V SU/SD PS controller |
| LTC3703HGN | 制造商:Linear Technology 功能描述:DC DC Cntrlr Single-OUT Sync Step Down 9.3V to 100V Input 16-Pin SSOP N |
| LTC3703HGN#PBF | 功能描述:IC REG CTRLR BST PWM VM 16-SSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:2,500 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:500kHz 占空比:96% 电源电压:4 V ~ 36 V 降压:无 升压:是 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:24-WQFN 裸露焊盘 包装:带卷 (TR) |
| LTC3703HGN#TRPBF | 功能描述:IC REG CTRLR BST PWM VM 16-SSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:2,500 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:500kHz 占空比:96% 电源电压:4 V ~ 36 V 降压:无 升压:是 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:24-WQFN 裸露焊盘 包装:带卷 (TR) |
| LTC3703IG-5#PBF | 功能描述:IC REG CTRLR BST PWM VM 28-SSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:2,500 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:500kHz 占空比:96% 电源电压:4 V ~ 36 V 降压:无 升压:是 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:24-WQFN 裸露焊盘 包装:带卷 (TR) |
发布紧急采购，3分钟左右您将得到回复。