- 您现在的位置：买卖IC网 > PDF目录15239 > LTC3722IGN-2#PBF (Linear Technology)IC REG CTRLR DIV ISO PWM 24SSOP PDF资料下载
参数资料
| 型号： | LTC3722IGN-2#PBF |
| 厂商： | Linear Technology |
| 文件页数： | 24/28页 |
| 文件大小： | 0K |
| 描述： | IC REG CTRLR DIV ISO PWM 24SSOP |
| 标准包装： | 55 |
| PWM 型： | 电压模式，全桥 |
| 输出数： | 1 |
| 频率 - 最大： | 1MHz |
| 占空比： | 98.5% |
| 电源电压： | 3.8 V ~ 10.3 V |
| 降压： | 无 |
| 升压： | 无 |
| 回扫： | 无 |
| 反相： | 无 |
| 倍增器： | 无 |
| 除法器： | 是 |
| Cuk： | 无 |
| 隔离： | 是 |
| 工作温度： | -40°C ~ 85°C |
| 封装/外壳： | 24-SSOP（0.154"，3.90mm 宽） |
| 包装： | 管件 |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页当前第24页第25页第26页第27页第28页
LTC3722-1/LTC3722-2
OPERATION
V OUT
C P2
V OUT
R f
R L
–
loopisveryhelpfultooltoquicklyevaluatethefrequency
response of various compensation networks.
Polymer Electrolytic (see Figure 13) 1/(2πC C R I ) sets a
low frequency pole. 1/(2πC C R F ) sets the low frequency
zero. The zero frequency should coincide with the worst-
case lowest output pole frequency. The pole frequency
and mid frequency gain (R F /R I ) should be set such so
that the loop crosses over zero dB with a –1 slope at a
frequency lower than (f SW /8). Use a bode plot to graphi-
cally display the frequency response. An optional higher
frequency pole set by CP2 and R f is used to attenuate
switching frequency noise.
Aluminum Electrolytic (see Figure 13) the goal of this
compensator will be to cross over the output minimum
pole frequency. Set a low frequency pole with C C and R IN
at a frequency that will cross over the loop at the output
pole minimum F, place the zero formed by C C and R f at
the output pole F.
COMP
OPTO
OPTIONAL
C C
C O R I
REF
COLL
improve transient response, particularly overshoot, and
improve ZVS ability at light loads.
Programming the Synchronous Rectifier Turn-Off Delay
The LTC3722-1/LTC3722-2 controllers include a feature to
program the turn-off edge of the secondary side synchro-
nous rectifier MOSFETs relative to the beginning of a new
primary side power delivery pulse. This feature provides
optimized timing for the synchronous MOSFETs which
improves efficiency. At higher load currents it becomes
more advantageous to delay the turn-off of the synchro-
nous rectifiers until the transformer core has been reset
to begin the new power pulse. This allows for secondary
freewheeling current to flow through the synchronous
MOSFET channel instead of its body diode.
The turn-off delay is programmed with a resistor from
SPRG to GND (see Figure 14). The nominal regulated
voltage on SPRG is 2V. The external resistor programs a
current which flows out of SPRG. The delay can be adjusted
from approximately 20ns to 200ns, with resistor values of
10k to 200k. Do not leave SPRG floating. The amount of
delay can also be modulated based on an external current
source that sinks current out of SPRG. Care must be taken
to limit the current out of SPRG to 350μA or less.
ESR
R D
2.5V
+
SPRG
LT1431 OR EQUIVALENT
PRECISION ERROR
AMP AND REFERENCE 372212 F13
Figure 13. Compensation for Polymer Electrolytic
R SPRG
+
V 2V
–
+
–
TURN-OFF
SYNC OUT
372212 F14
Synchronous Rectification
The LTC3722-1/LTC3722-2 produces the precise timing
signals necessary to control current doubler secondary side
synchronous MOSFETs on OUTE and OUTF. Synchronous
rectifiers are used in place of Schottky or Silicon diodes
on the secondary side of the power supply. As MOSFET
R DS(ON) levels continue to drop, significant efficiency im-
provements can be realized with synchronous rectification,
provided that the MOSFET switch timing is optimized. An
additional benefit realized with synchronous rectifiers is
bipolar output current capability. These characteristics
Figure 14. Synchronous Delay Circuitry
Current Doubler
The current doubler secondary employs two output induc-
tors that equally share the output load current. The trans-
former secondary is not center-tapped. This configuration
provides 2x higher output current capability compared to
similarly sized single output inductor modules, hence the
name. Each output inductor is twice the inductance value
as the equivalent single inductor configuration and the
transformer turns ratio is one-half that of a single inductor
372212fb
24
For more information www.linear.com/LTC3722
相关PDF资料 |
PDF描述 |
|---|---|
| LTC3722IGN-1#PBF | IC REG CTRLR DIV ISO PWM 24SSOP |
| ISC1210BN120J | INDUCTOR WW 12UH 5% 1210 |
| VI-25Z-EU-F2 | CONVERTER MOD DC/DC 2V 80W |
| SRP1040-R80M | INDUCTOR 800NH 21A SMD |
| LT3724MPFE#PBF | IC REG CTRLR BST INV PWM 16TSSOP |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LTC3723EGN-1 | 功能描述:IC REG CTRLR FLYBK ISO CM 16SSOP RoHS:否 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:4,500 系列:PowerWise® PWM 型:控制器 输出数:1 频率 - 最大:1MHz 占空比:95% 电源电压:2.8 V ~ 5.5 V 降压:是 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:6-WDFN 裸露焊盘 包装:带卷 (TR) 配用:LM1771EVAL-ND - BOARD EVALUATION LM1771 其它名称:LM1771SSDX |
| LTC3723EGN-1#2EYPBF | 制造商:Linear Technology 功能描述: |
| LTC3723EGN-1#PBF | 功能描述:IC REG CTRLR FLYBK ISO CM 16SSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 特色产品:LM3753/54 Scalable 2-Phase Synchronous Buck Controllers 标准包装:1 系列:PowerWise® PWM 型:电压模式 输出数:1 频率 - 最大:1MHz 占空比:81% 电源电压:4.5 V ~ 18 V 降压:是 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-5°C ~ 125°C 封装/外壳:32-WFQFN 裸露焊盘 包装:Digi-Reel® 产品目录页面:1303 (CN2011-ZH PDF) 其它名称:LM3754SQDKR |
| LTC3723EGN-1#TR | 功能描述:IC REG CTRLR FLYBK ISO CM 16SSOP RoHS:否 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:4,500 系列:PowerWise® PWM 型:控制器 输出数:1 频率 - 最大:1MHz 占空比:95% 电源电压:2.8 V ~ 5.5 V 降压:是 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:6-WDFN 裸露焊盘 包装:带卷 (TR) 配用:LM1771EVAL-ND - BOARD EVALUATION LM1771 其它名称:LM1771SSDX |
| LTC3723EGN-1#TRPBF | 功能描述:IC REG CTRLR FLYBK ISO CM 16SSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:4,500 系列:PowerWise® PWM 型:控制器 输出数:1 频率 - 最大:1MHz 占空比:95% 电源电压:2.8 V ~ 5.5 V 降压:是 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:6-WDFN 裸露焊盘 包装:带卷 (TR) 配用:LM1771EVAL-ND - BOARD EVALUATION LM1771 其它名称:LM1771SSDX |
发布紧急采购，3分钟左右您将得到回复。