- 您现在的位置：买卖IC网 > PDF目录15242 > LTC3729LEUH-6#PBF (Linear Technology)IC REG CTRLR BUCK PWM CM 32-QFN PDF资料下载
参数资料
| 型号： | LTC3729LEUH-6#PBF |
| 厂商： | Linear Technology |
| 文件页数： | 10/28页 |
| 文件大小： | 0K |
| 描述： | IC REG CTRLR BUCK PWM CM 32-QFN |
| 标准包装： | 73 |
| 系列： | PolyPhase® |
| PWM 型： | 电流模式 |
| 输出数： | 1 |
| 频率 - 最大： | 620kHz |
| 占空比： | 99.5% |
| 电源电压： | 4 V ~ 30 V |
| 降压： | 是 |
| 升压： | 无 |
| 回扫： | 无 |
| 反相： | 无 |
| 倍增器： | 无 |
| 除法器： | 无 |
| Cuk： | 无 |
| 隔离： | 无 |
| 工作温度： | -40°C ~ 85°C |
| 封装/外壳： | 32-WFQFN 裸露焊盘 |
| 包装： | 管件 |
第1页第2页第3页第4页第5页第6页第7页第8页第9页当前第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页
LTC3729L-6
OPERATIO
Main Control Loop
(Refer to Functional Diagram)
Low Current Operation
The LTC3729L-6 uses a constant frequency, current mode
step-down architecture. During normal operation, the top
MOSFET is turned on each cycle when the oscillator sets
the RS latch, and turned off when the main current
comparator, I1, resets the RS latch. The peak inductor
current at which I1 resets the RS latch is controlled by the
voltage on the I TH pin, which is the output of the error
amplifier EA. The differential amplifier, A1, produces a
signal equal to the differential voltage sensed across the
output capacitor but re-references it to the internal signal
ground (SGND) reference. The EAIN pin receives a portion
of this voltage feedback signal at the DIFFOUT pin which
is compared to the internal reference voltage by the EA.
When the load current increases, it causes a slight de-
crease in the EAIN pin voltage relative to the 0.6V refer-
ence, which in turn causes the I TH voltage to increase until
the average inductor current matches the new load cur-
rent. After the top MOSFET has turned off, the bottom
MOSFET is turned on for the rest of the period.
The top MOSFET drivers are biased from floating boot-
strap capacitor C B , which normally is recharged during
each off cycle through an external Schottky diode. When
V IN decreases to a voltage close to V OUT , however, the loop
may enter dropout and attempt to turn on the top MOSFET
continuously. A dropout detector detects this condition
and forces the top MOSFET to turn off for about 400ns
every 10th cycle to recharge the bootstrap capacitor.
The main control loop is shut down by pulling Pin 1 (RUN/
SS) low. Releasing RUN/SS allows an internal 1.2 μ A
current source to charge soft-start capacitor C SS . When
C SS reaches 1.5V, the main control loop is enabled with the
I TH voltage clamped at approximately 30% of its maximum
value. As C SS continues to charge, I TH is gradually re-
leased allowing normal operation to resume. When the
RUN/SS pin is low, all LTC3729L-6 functions are shut
down. If V OUT has not reached 70% of its nominal value
when C SS has charged to 4.1V, an overcurrent latchoff can
be invoked as described in the Applications Information
section.
The LTC3729L-6 operates in a continuous, PWM control
mode. The resulting operation at low output currents
optimizes transient response at the expense of substantial
negative inductor current during the latter part of the
period. The level of ripple current is determined by the
inductor value, input voltage, output voltage, and fre-
quency of operation.
Frequency Synchronization
The phase-locked loop allows the internal oscillator to be
synchronized to an external source via the PLLIN pin. The
output of the phase detector at the PLLFLTR pin is also the
DC frequency control input of the oscillator that operates
over a 260kHz to 550kHz range corresponding to a DC
voltage input from 0V to 2.4V. When locked, the PLL aligns
the turn on of the top MOSFET to the rising edge of the
synchronizing signal. When PLLIN is left open, the PLLFLTR
pin goes low, forcing the oscillator to minimum frequency.
The internal master oscillator runs at a frequency twelve
times that of each controller’s frequency. The PHASMD
pin determines the relative phases between the internal
controllers as well as the CLKOUT signal as shown in
Table 1. The phases tabulated are relative to zero phase
being defined as the rising edge of the top gate (TG1)
driver output of controller 1.
Table 1.
V PHASMD GND OPEN INTV CC
Controller 2 180 ° 180 ° 240 °
CLKOUT 60 ° 90 ° 120 °
The CLKOUT signal can be used to synchronize additional
power stages in a multiphase power supply solution
feeding a single, high current output or separate outputs.
Input capacitance ESR requirements and efficiency losses
are substantially reduced because the peak current drawn
from the input capacitor is effectively divided by the
number of phases used and power loss is proportional to
the RMS current squared. A two stage, single output
voltage implementation can reduce input path power loss
by 75% and radically reduce the required RMS current
rating of the input capacitor(s).
sn3729l6 3729l6fs
10
相关PDF资料 |
PDF描述 |
|---|---|
| H2ABT-10106-A4-ND | JUMPER-H1502TR/A2015A/H1500TR 6" |
| LTC1628IUH#TRPBF | IC REG CTRLR BUCK PWM CM 32-QFN |
| H2AAT-10104-Y4-ND | JUMPER-H1502TR/A2015Y/H1502TR 4" |
| LTC1628IUH#TR | IC REG CTRLR BUCK PWM CM 32-QFN |
| H2AAT-10104-W4-ND | JUMPER-H1502TR/A2015W/H1502TR 4" |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LTC3730CG | 功能描述:IC SW REG CTRLR SYNC BUCK 36SSOP RoHS:否 类别:集成电路 (IC) >> PMIC - 稳压器 - 专用型 系列:- 标准包装:43 系列:- 应用:控制器，Intel VR11 输入电压:5 V ~ 12 V 输出数:1 输出电压:0.5 V ~ 1.6 V 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:48-VFQFN 裸露焊盘 供应商设备封装:48-QFN（7x7） 包装:管件 |
| LTC3730CG#PBF | 功能描述:IC SW REG CTRLR SYNC BUCK 36SSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - 专用型 系列:- 标准包装:43 系列:- 应用:控制器，Intel VR11 输入电压:5 V ~ 12 V 输出数:1 输出电压:0.5 V ~ 1.6 V 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:48-VFQFN 裸露焊盘 供应商设备封装:48-QFN（7x7） 包装:管件 |
| LTC3730CG#TR | 功能描述:IC CTRLR BUCK POLYPHASE 36-SSOP RoHS:否 类别:集成电路 (IC) >> PMIC - 稳压器 - 专用型 系列:- 标准包装:43 系列:- 应用:控制器，Intel VR11 输入电压:5 V ~ 12 V 输出数:1 输出电压:0.5 V ~ 1.6 V 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:48-VFQFN 裸露焊盘 供应商设备封装:48-QFN（7x7） 包装:管件 |
| LTC3730CG#TRPBF | 功能描述:IC SW REG CTRLR SYNC BUCK 36SSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - 专用型 系列:- 标准包装:43 系列:- 应用:控制器，Intel VR11 输入电压:5 V ~ 12 V 输出数:1 输出电压:0.5 V ~ 1.6 V 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:48-VFQFN 裸露焊盘 供应商设备封装:48-QFN（7x7） 包装:管件 |
| LTC3731CG | 功能描述:IC REG CTRLR BUCK PWM CM 36-SSOP RoHS:否 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:PolyPhase® 标准包装:4,500 系列:PowerWise® PWM 型:控制器 输出数:1 频率 - 最大:1MHz 占空比:95% 电源电压:2.8 V ~ 5.5 V 降压:是 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:6-WDFN 裸露焊盘 包装:带卷 (TR) 配用:LM1771EVAL-ND - BOARD EVALUATION LM1771 其它名称:LM1771SSDX |
发布紧急采购，3分钟左右您将得到回复。