- 您现在的位置：买卖IC网 > PDF目录1831 > LTC3735EUHF#TRPBF (Linear Technology)IC CTRLR DC/DC 2PH HI EFF 38-QFN PDF资料下载
参数资料
| 型号： | LTC3735EUHF#TRPBF |
| 厂商： | Linear Technology |
| 文件页数： | 22/32页 |
| 文件大小： | 0K |
| 描述： | IC CTRLR DC/DC 2PH HI EFF 38-QFN |
| 标准包装： | 2,500 |
| 应用： | 控制器，Intel 移动式 CPU |
| 输出数： | 1 |
| 输出电压： | 0.7 V ~ 1.71 V |
| 工作温度： | -40°C ~ 85°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 38-WFQFN 裸露焊盘 |
| 供应商设备封装： | 38-QFN（5x7） |
| 包装： | 带卷 (TR) |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页当前第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页
LTC3735
APPLICATIONS INFORMATION
(12)
R AVP ?
–1
V IN2 ? I OUT
per Phase
Rewritingthisequation,wecanestimatetheR AVP value
to be:
35.5 ? R3
m ? | AVP|
R SENSE
Typically the calculation results based on these equations
have ±10% tolerance. So the resistor values need to be
fine tuned.
Efficiency Considerations
The percent efficiency of a switching regulator is equal to
the output power divided by the input power times 100%.
It is often useful to analyze individual losses to determine
what is limiting the efficiency and which change would
produce the most improvement. Percent efficiency can
be expressed as:
%Efficiency = 100% – (L1 + L2 + L3 + ...)
where L1, L2, etc. are the individual losses as a percent-
age of input power.
Although all dissipative elements in the circuit produce
losses, four main sources usually account for most of
the losses in LTC3735 circuits: 1) I 2 R losses, 2) Topside
MOSFET transition losses, 3) PV CC supply current and
4) C IN loss.
1) I 2 R losses are predicted from the DC resistances of
the fuse (if used), MOSFET, inductor, and current sense
resistor. In continuous mode the average output current
flows through L and R SENSE , but is “chopped” between the
topside MOSFET and the synchronous MOSFET. If the two
MOSFETs have approximately the same R DS(ON) , then the
resistance of one MOSFET can simply be summed with
the resistances of L, R SENSE and ESR to obtain I 2 R losses.
For example, if each R DS(ON) = 10mΩ, R L = 10mΩ, and
R SENSE = 5mΩ, then the total resistance is 25mΩ. This
results in losses ranging from 2% to 8% as the output
current increases from 3A to 15A per output stage for a 5V
output, or a 3% to 12% loss per output stage for a 3.3V
output. Efficiency varies as the inverse square of V OUT for
the same external components and output power level.
The combined effects of increasingly lower output voltages
and higher currents required by high performance digital
systems is not doubling but quadrupling the importance
of loss terms in the switching regulator system!
2) Transition losses apply only to the topside MOSFET(s),
and are significant only when operating at high input volt-
ages (typically 12V or greater). Transition losses can be
estimated from:
Transition Loss = ? f ? C RSS ? R DR ?
4
? 1 1 ?
? + ?
? V DR – V TH(MIN) V TH(MIN) ?
3) PV CC drives both top and bottom MOSFETs. The MOSFET
driver current results from switching the gate capacitance
of the power MOSFETs. Each time a MOSFET gate is
switched from low to high to low again, a packet of charge
dQ moves from PV CC to ground. The resulting dQ/dt is a
current out of PV CC that is typically much larger than the
control circuit current. In continuous mode, I GATECHG =
(Q T + Q B )f, where Q T and Q B are the gate charges of the
topside and bottom side MOSFETs and f is the switching
frequency.
4) The input capacitor has the difficult job of filtering
the large RMS input current to the regulator. It must
have a very low ESR to minimize the AC I 2 R loss and
sufficient capacitance to prevent the RMS current from
causing additional upstream losses in fuses or batteries.
The LTC3735 2-phase architecture typically halves the
input and output capacitor requirements over 1-phase
solutions.
Other losses, including C OUT ESR loss, Schottky diode
conduction loss during dead time, inductor core loss and
internal control circuitry supply current generally account
for less than 2% additional loss.
Checking Transient Response
The regulator loop response can be checked by look-
ing at the load transient response. Switching regulators
take several cycles to respond to a step in DC (resistive)
3735fa
22
相关PDF资料 |
PDF描述 |
|---|---|
| LTC3736EUF-1#TRPBF | IC REG CTRLR BUCK PWM CM 24-QFN |
| LTC3736EUF#PBF | IC REG CTRLR BUCK PWM CM 24-QFN |
| LTC3737EUF#TRPBF | IC REG CTRLR BUCK PWM CM 24-QFN |
| LTC3738CUHF#TRPBF | IC CTRLR SW REG 3PH STPDWN 38QFN |
| LTC3770EUH#TRPBF | IC REG CTRLR BUCK PWM CM 32-QFN |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LTC3736EGN | 功能描述:IC REG CTRLR BUCK PWM CM 24-SSOP RoHS:否 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:PolyPhase® 标准包装:2,500 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:500kHz 占空比:96% 电源电压:4 V ~ 36 V 降压:无 升压:是 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:24-WQFN 裸露焊盘 包装:带卷 (TR) |
| LTC3736EGN#PBF | 功能描述:IC REG CTRLR BUCK PWM CM 24-SSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:PolyPhase® 特色产品:LM3753/54 Scalable 2-Phase Synchronous Buck Controllers 标准包装:1 系列:PowerWise® PWM 型:电压模式 输出数:1 频率 - 最大:1MHz 占空比:81% 电源电压:4.5 V ~ 18 V 降压:是 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-5°C ~ 125°C 封装/外壳:32-WFQFN 裸露焊盘 包装:Digi-Reel® 产品目录页面:1303 (CN2011-ZH PDF) 其它名称:LM3754SQDKR |
| LTC3736EGN#TR | 功能描述:IC REG CTRLR BUCK PWM CM 24-SSOP RoHS:否 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:PolyPhase® 标准包装:2,500 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:500kHz 占空比:96% 电源电压:4 V ~ 36 V 降压:无 升压:是 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:24-WQFN 裸露焊盘 包装:带卷 (TR) |
| LTC3736EGN#TRPBF | 功能描述:IC REG CTRLR BUCK PWM CM 24-SSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:PolyPhase® 标准包装:2,500 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:500kHz 占空比:96% 电源电压:4 V ~ 36 V 降压:无 升压:是 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:24-WQFN 裸露焊盘 包装:带卷 (TR) |
| LTC3736EGN-1 | 功能描述:IC REG CTRLR BUCK PWM CM 24-SSOP RoHS:否 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:PolyPhase® 标准包装:4,500 系列:PowerWise® PWM 型:控制器 输出数:1 频率 - 最大:1MHz 占空比:95% 电源电压:2.8 V ~ 5.5 V 降压:是 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:6-WDFN 裸露焊盘 包装:带卷 (TR) 配用:LM1771EVAL-ND - BOARD EVALUATION LM1771 其它名称:LM1771SSDX |
发布紧急采购，3分钟左右您将得到回复。