- 您现在的位置：买卖IC网 > PDF目录1832 > LTC3778EF#PBF (Linear Technology)IC REG CTRLR BUCK PWM CM 20TSSOP PDF资料下载
参数资料
| 型号： | LTC3778EF#PBF |
| 厂商： | Linear Technology |
| 文件页数： | 9/24页 |
| 文件大小： | 0K |
| 描述： | IC REG CTRLR BUCK PWM CM 20TSSOP |
| 标准包装： | 74 |
| PWM 型： | 电流模式 |
| 输出数： | 1 |
| 电源电压： | 4 V ~ 36 V |
| 降压： | 是 |
| 升压： | 无 |
| 回扫： | 无 |
| 反相： | 无 |
| 倍增器： | 无 |
| 除法器： | 无 |
| Cuk： | 无 |
| 隔离： | 无 |
| 工作温度： | -40°C ~ 85°C |
| 封装/外壳： | 20-TSSOP（0.173"，4.40mm 宽） |
| 包装： | 管件 |
| 产品目录页面： | 1336 (CN2011-ZH PDF) |
LTC3778
OPERATIO
Main Control Loop
The LTC3778 is a current mode controller for DC/DC
step-down converters. In normal operation, the top
MOSFET is turned on for a fixed interval determined by a
one-shot timer OST. When the top MOSFET is turned off,
the bottom MOSFET is turned on until the current com-
parator I CMP trips, restarting the one-shot timer and initi-
ating the next cycle. Inductor current is determined by
sensing the voltage between the SENSE – and SENSE +
pins. The voltage on the I TH pin sets the comparator
threshold corresponding to inductor valley current. The
error amplifier EA adjusts this voltage by comparing the
feedback signal V FB from the output voltage with an
internal 0.6V reference. If the load current increases, it
causes a drop in the feedback voltage relative to the
reference. The I TH voltage then rises until the average
inductor current again matches the load current.
At low load currents, the inductor current can drop to zero
and become negative. This is detected by current reversal
comparator I REV which then shuts off M2, resulting in
discontinuous operation. Both switches will remain off
with the output capacitor supplying the load current until
the I TH voltage rises above the zero current level (0.8V) to
initiate another cycle. Discontinuous mode operation is
disabled by comparator F when the FCB pin is brought
below 0.6V, forcing continuous synchronous operation.
The operating frequency is determined implicitly by the
top MOSFET on-time and the duty cycle required to
maintain regulation. The one-shot timer generates an on-
time that is proportional to the ideal duty cycle, thus
holding frequency approximately constant with changes
in V IN and V OUT . The nominal frequency can be adjusted
with an external resistor R ON .
Overvoltage and undervoltage comparators OV and UV
pull the PGOOD output low if the output feedback voltage
exits a ± 10% window around the regulation point.
Furthermore, in an overvoltage condition, M1 is turned off
and M2 is turned on and held on until the overvoltage
condition clears.
Foldback current limiting is provided if the output is
shorted to ground. As V FB drops, the buffered current
threshold voltage I THB is pulled down by clamp Q3 to a 1V
level set by Q4 and Q6. This reduces the inductor valley
current level to one sixth of its maximum value as V FB
approaches 0V.
Pulling the RUN/SS pin low forces the controller into its
shutdown state, turning off both M1 and M2. Releasing
the pin allows an internal 1.2 μ A current source to charge
up an external soft-start capacitor C SS . When this voltage
reaches 1.5V, the controller turns on and begins switch-
ing, but with the I TH voltage clamped at approximately
0.6V below the RUN/SS voltage. As C SS continues to
charge, the soft-start current limit is removed.
EXTV CC /INTV CC /DRV CC Power
Power for the top and bottom MOSFET drivers is derived
from DRV CC and most of the internal controller circuitry
is powered from the INTV CC pin. The top MOSFET driver
is powered from a floating bootstrap capacitor C B . This
capacitor is recharged from DRV CC through an external
Schottky diode D B when the top MOSFET is turned off.
When the EXTV CC pin is grounded, an internal 5V low
dropout regulator supplies the INTV CC power from V IN . If
EXTV CC rises above 4.7V, the internal regulator is turned
off, and an internal switch connects EXTV CC to INTV CC .
This allows a high efficiency source connected to EXTV CC ,
such as an external 5V supply or a secondary output from
the converter, to provide the INTV CC power. Voltages up
to 7V can be applied to DRV CC for additional gate drive.
If the input voltage is low and INTV CC drops below 3.5V,
undervoltage lockout circuitry prevents the power
switches from turning on.
3778f
9
相关PDF资料 |
PDF描述 |
|---|---|
| LTC3780IUH#PBF | IC REG CTRLR BST PWM CM 32-QFN |
| LTC3785EUF-1#TRPBF | IC REG CTRLR BST PWM VM 24-QFN |
| LTC3785EUF#PBF | IC REG CTRLR BST PWM VM 24-QFN |
| LTC3786EUD#PBF | IC REG CTRLR BST PWM CM 16-QFN |
| LTC3787EUFD#PBF | IC REG CTRLR BST PWM CM 28-QFN |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LTC3780EG | 制造商:Linear Technology 功能描述:DC DC Cntrlr Dual-OUT Synchronous Boost/Buck Controller 4V to 36V Input 24-Pin SSOP |
| LTC3780EG#PBF | 功能描述:IC REG CTRLR BST PWM CM 24-SSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 特色产品:LM3753/54 Scalable 2-Phase Synchronous Buck Controllers 标准包装:1 系列:PowerWise® PWM 型:电压模式 输出数:1 频率 - 最大:1MHz 占空比:81% 电源电压:4.5 V ~ 18 V 降压:是 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-5°C ~ 125°C 封装/外壳:32-WFQFN 裸露焊盘 包装:Digi-Reel® 产品目录页面:1303 (CN2011-ZH PDF) 其它名称:LM3754SQDKR |
| LTC3780EG#TR | 制造商:Linear Technology 功能描述:DC DC Cntrlr Dual-OUT Synchronous Boost/Buck Controller 4V to 36V Input 24-Pin SSOP T/R |
| LTC3780EG#TRPBF | 功能描述:IC REG CTRLR BST PWM CM 24-SSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:4,500 系列:PowerWise® PWM 型:控制器 输出数:1 频率 - 最大:1MHz 占空比:95% 电源电压:2.8 V ~ 5.5 V 降压:是 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:6-WDFN 裸露焊盘 包装:带卷 (TR) 配用:LM1771EVAL-ND - BOARD EVALUATION LM1771 其它名称:LM1771SSDX |
| LTC3780EGPBF | 制造商:Linear Technology 功能描述:4-Switch Buck-Boost Controller SSOP24 |
发布紧急采购，3分钟左右您将得到回复。