- 您现在的位置：买卖IC网 > PDF目录15273 > LTC3802EGN#TR (Linear Technology)IC REG CTRLR BUCK PWM VM 28-SSOP PDF资料下载
参数资料
| 型号： | LTC3802EGN#TR |
| 厂商： | Linear Technology |
| 文件页数： | 15/28页 |
| 文件大小： | 0K |
| 描述： | IC REG CTRLR BUCK PWM VM 28-SSOP |
| 标准包装： | 2,500 |
| 系列： | PolyPhase® |
| PWM 型： | 电压模式 |
| 输出数： | 2 |
| 频率 - 最大： | 850kHz |
| 占空比： | 92% |
| 电源电压： | 3 V ~ 30 V |
| 降压： | 是 |
| 升压： | 无 |
| 回扫： | 无 |
| 反相： | 无 |
| 倍增器： | 无 |
| 除法器： | 无 |
| Cuk： | 无 |
| 隔离： | 无 |
| 工作温度： | -40°C ~ 85°C |
| 封装/外壳： | 28-SSOP（0.154"，3.90mm 宽） |
| 包装： | 带卷 (TR) |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页当前第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页
LTC3802
APPLICATIO S I FOR ATIO
The current limit detector is connected to an internal
100 μ A current source. Once current limit occurs, this
current begins to discharge the soft-start capacitor at
RUN/SS, reducing the duty cycle and controlling the
output voltage until the current drops below the limit. The
soft-start capacitor needs to move a fair amount before it
has any effect on the duty cycle, adding a delay until the
current limit takes effect. This allows the LTC3802 to
experience brief overload conditions without affecting the
output voltage regulation. The delay also acts as a pole in
the current limit loop to enhance loop stability.
Under severe short-circuit conditions, if the load current is
1.5 times larger than the programmed current limit thresh-
old, the LTC3802 shuts off the top MOSFET immediately.
This stops the increase in the inductor current. At this
moment, if CMPIN is 10% lower than its nominal value, the
LTC3802 hard current limit latches and discharges the
RUN/SS capacitor with a current source of more than 1mA
until RUN/SS hits its shutdown threshold. Once RUN/SS
is completely discharged, the LTC3802 cycles its soft-
start again.
Programming the current limit on the LTC3802 is straight-
forward. To set the current limit, calculate the expected
voltage drop across QB at the maximum desired current:
V PROG = (I LIMIT )(R DS(ON) )
I LIMIT should be set much higher than the expected oper-
ating current, to allow for MOSFET R DS(ON) changes with
temperature. Power MOSFET R DS(ON) varies from MOSFET
to MOSFET, limiting the accuracy obtainable from the
LTC3802 current limit loop. Setting I LIMIT to 150% of the
maximum normal operating current is usually safe and will
adequately protect the power components if they are
chosen properly. Note that ringing on the switch node can
cause an error for the current limit threshold. This factor
will change depending on the layout. The SW node should
have minimum routing from the MOSFETs to the LTC3802
to reduce parasitic inductor and hence ringing. V PROG is
then programmed at the I MAX pin using the internal 10 μ A
pull-up current and an external resistor:
The resulting value of R IMAX should be checked in an
actual circuit to ensure that the current circuit kicks in as
expected. Circuits that use very low values for R IMAX
(<25k) should be checked carefully, since small changes
in R IMAX can cause large I LIMIT changes when the switch
node ringing makes up a large percentage of the total
V PROG value. If V PROG is set too low, the LTC3802 may fail
to start up. The LTC3802 current limit is designed prima-
rily as a disaster preventing, “no blow up” circuit, and is
not useful as a precision current regulator.
The LTC3802 bottom MOSFET V DS current sensing archi-
tecture not only eliminates the external current sense
resistors and the corresponding power losses in the high
current paths, it allows a wide range of output voltage
setting, including extremely low duty cycle operation. On
the other hand, for high input voltage with small output
inductance applications, care must be taken to avoid
inductor saturation during dead-short conditions. As soon
as the output short circuits, the controller instantaneously
enters maximum duty cycle operation.
During the top MOSFET on interval, the current compara-
tor is not monitoring the current and there is no current
limit action until the bottom MOSFET turns on and the
inductor current exceeds its hard current limit threshold.
Typically, the top MOSFET and the inductor need to
withstand one clock period of transient high current op-
eration until the hard current limit operation engages.
Peak currents can exceed 6 times the maximum DC output
current during this period. Most MOSFETs allow 10 μ s of
high current and this short duration of current should not
damage the MOSFET. Nevertheless, it is a good idea to
reduce the peak inductor current. This can be achieved by
having a larger inductance to limit the short-circuit current
slew rate, or an inductor with a saturation current that is
higher than the hard current limit threshold. Alternatively,
an inductor core material with a softer saturation charac-
teristic such as iron powder can be used.
Shutdown/Soft-Start
The RUN/SS pin performs two functions: when pulled to
R IMAX =
5 ? V PROG
10 μ A
ground it shuts down the LTC3802, and it acts as a
conventional soft-start pin, enforcing a maximum duty
cycle limit proportional to the voltage at RUN/SS. An
3802f
15
相关PDF资料 |
PDF描述 |
|---|---|
| VI-J5K-EW-F4 | CONVERTER MOD DC/DC 40V 100W |
| H2BXG-10108-L4-ND | JUMPER-H1501TR/A2015L/X 8" |
| VI-J5K-EW-F3 | CONVERTER MOD DC/DC 40V 100W |
| LTC3731HG#TRPBF | IC REG CTRLR BUCK PWM CM 36-SSOP |
| VI-J5K-EW-F2 | CONVERTER MOD DC/DC 40V 100W |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LTC3802EUH | 功能描述:IC REG CTRLR BUCK PWM VM 32-QFN RoHS:否 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:PolyPhase® 标准包装:4,500 系列:PowerWise® PWM 型:控制器 输出数:1 频率 - 最大:1MHz 占空比:95% 电源电压:2.8 V ~ 5.5 V 降压:是 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:6-WDFN 裸露焊盘 包装:带卷 (TR) 配用:LM1771EVAL-ND - BOARD EVALUATION LM1771 其它名称:LM1771SSDX |
| LTC3802EUH#PBF | 功能描述:IC REG CTRLR BUCK PWM VM 32-QFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:PolyPhase® 标准包装:4,500 系列:PowerWise® PWM 型:控制器 输出数:1 频率 - 最大:1MHz 占空比:95% 电源电压:2.8 V ~ 5.5 V 降压:是 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:6-WDFN 裸露焊盘 包装:带卷 (TR) 配用:LM1771EVAL-ND - BOARD EVALUATION LM1771 其它名称:LM1771SSDX |
| LTC3802EUH#TR | 功能描述:IC REG CTRLR BUCK PWM VM 32-QFN RoHS:否 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:PolyPhase® 标准包装:4,500 系列:PowerWise® PWM 型:控制器 输出数:1 频率 - 最大:1MHz 占空比:95% 电源电压:2.8 V ~ 5.5 V 降压:是 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:6-WDFN 裸露焊盘 包装:带卷 (TR) 配用:LM1771EVAL-ND - BOARD EVALUATION LM1771 其它名称:LM1771SSDX |
| LTC3802EUH#TRPBF | 功能描述:IC REG CTRLR BUCK PWM VM 32-QFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:PolyPhase® 标准包装:4,500 系列:PowerWise® PWM 型:控制器 输出数:1 频率 - 最大:1MHz 占空比:95% 电源电压:2.8 V ~ 5.5 V 降压:是 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:6-WDFN 裸露焊盘 包装:带卷 (TR) 配用:LM1771EVAL-ND - BOARD EVALUATION LM1771 其它名称:LM1771SSDX |
| LTC3803ES6 | 制造商:Linear Technology 功能描述:DC DC Cntrlr Single-OUT Flyback Controller 9.2V to 75V Input 6-Pin TSOT-23 |
发布紧急采购，3分钟左右您将得到回复。