参数资料
型号: LTC3810HUH-5#TRPBF
厂商: Linear Technology
文件页数: 13/38页
文件大小: 0K
描述: IC REG CTRLR BUCK PWM CM 32-QFN
标准包装: 2,500
PWM 型: 电流模式
输出数: 1
频率 - 最大: 1MHz
占空比: 99%
电源电压: 4.35 V ~ 60 V
降压:
升压:
回扫:
反相:
倍增器:
除法器:
Cuk:
隔离:
工作温度: -40°C ~ 150°C
封装/外壳: 32-WFQFN 裸露焊盘
包装: 带卷 (TR)
LTC3810-5
OPERATION
SW
BG +
C OUT
FaultMonitoring/Protection
Constant on-time current mode architecture provides ac-
curate cycle-by-cycle current limit protection—a feature
that is very important for protecting the high voltage power
supply from output short circuits. The cycle-by-cycle cur-
rent monitor guarantees that the inductor current will never
exceed the value programmed on the V RNG pin.
Foldback current limiting provides further protection if the
output is shorted to ground. As V FB drops, the buffered
current threshold voltage I THB is pulled down and clamped
to 1V. This reduces the inductor valley current level to
one-sixth of its maximum value as V FB approaches 0V.
Foldback current limiting is disabled at start-up.
Overvoltage and undervoltage comparators OV and UV
pull the PGOOD output low if the output feedback voltage
exits a ±10% window around the regulation point after the
internal 120μs power bad mask timer expires. Furthermore,
in an overvoltage condition, M1 is turned off and M2 is
turned on immediately and held on until the overvoltage
condition clears.
The LTC3810-5 provides two undervoltage lockout com-
parators—one for the INTV CC /DRV CC supply and one for
the input supply V IN . The INTV CC UV threshold is 4.2V to
guarantee that the MOSFETs have sufficient gate drive
voltage before turning on. The V IN UV threshold (UVIN pin)
is 0.8V with 10% hysteresis which allows programming
the V IN threshold with the appropriate resistor divider
connected to V IN . If either comparator inputs are under
the UV threshold, the LTC3810-5 is shut down and the
drivers are turned off.
Strong Gate Drivers
The LTC3810-5 contains very low impedance drivers ca-
pable of supplying amps of current to slew large MOSFET
gates quickly. This minimizes transition losses and allows
paralleling MOSFETs for higher current applications. A
60V floating high side driver drives the top side MOSFET
and a low side driver drives the bottom side MOSFET
(see Figure 3). The bottom side driver is supplied directly
from the DRV CC pin. The top MOSFET drivers are biased
from floating bootstrap capacitor, C B , which normally is
recharged during each off cycle through an external diode
from DRV CC when the top MOSFET turns off. In pulse
skip mode operation, where it is possible that the bottom
MOSFET will be off for an extended period of time, an
internal timeout guarantees that the bottom MOSFET is
turned on at least once every 25μs for one on-time period
to refresh the bootstrap capacitor.
The bottom driver has an additional feature that helps
minimize the possibility of external MOSFET shoot-through.
When the top MOSFET turns on, the switch node dV/dt
pulls up the bottom MOSFET’s internal gate through the
Miller capacitance, even when the bottom driver is holding
the gate terminal at ground. If the gate is pulled up high
enough, shoot-through between the top side and bottom
side MOSFETs can occur. To prevent this from occurring,
the bottom driver return is brought out as a separate pin
(BGRTN) so that a negative supply can be used to reduce
the effect of the Miller pull-up. For example, if a –2V sup-
ply is used on BGRTN, the switch node dV/dt could pull
the gate up 2V before the V GS of the bottom MOSFET has
more than 0V across it.
DRV CC V IN
LTC3810-5 DRV CC D B +
BOOST C IN
TG C B
M1
L
V OUT
M2
BGRTN
38105 F03
0V TO –5V
Figure 3. Floating TG Driver Supply and Negative BG Return
IC/Driver Supply Power
The LTC3810-5’s internal control circuitry and top and
bottom MOSFET drivers operate from a supply voltage
(INTV CC , DRV CC pins) in the range of 4.5V to 14V. The
LTC3810-5 has two integrated linear regulator controllers
to easily generate this IC/driver supply from either the high
voltage input or from the output voltage. For best efficiency
the supply is derived from the input voltage during start-up
and then derived from the lower voltage output as soon
as the output is higher than 4.7V. Alternatively, the supply
can be derived from the input continuously if the output is
38105fd
13
相关PDF资料
PDF描述
LTC3834EUFD#TRPBF IC REG CTRLR BUCK PWM CM 20-QFN
LTC3834EFE#TRPBF IC REG CTRLR BUCK PWM CM 20TSSOP
VI-B2Z-EY-F2 CONVERTER MOD DC/DC 2V 20W
LTC1148CS IC REG CTRLR BUCK PWM CM 14-SOIC
VI-B2Z-EY-F1 CONVERTER MOD DC/DC 2V 20W
相关代理商/技术参数
参数描述
LTC3810IG 制造商:Linear Technology 功能描述:
LTC3810IG#PBF 功能描述:IC REG CTRLR BUCK PWM CM 28-SSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:2,500 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:500kHz 占空比:96% 电源电压:4 V ~ 36 V 降压:无 升压:是 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:24-WQFN 裸露焊盘 包装:带卷 (TR)
LTC3810IG#TRPBF 功能描述:IC REG CTRLR BUCK PWM CM 28-SSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:2,500 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:500kHz 占空比:96% 电源电压:4 V ~ 36 V 降压:无 升压:是 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:24-WQFN 裸露焊盘 包装:带卷 (TR)
LTC3810IUH-5#PBF 功能描述:IC REG CTRLR BUCK PWM CM 32-QFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:2,500 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:500kHz 占空比:96% 电源电压:4 V ~ 36 V 降压:无 升压:是 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:24-WQFN 裸露焊盘 包装:带卷 (TR)
LTC3810IUH-5#TRPBF 功能描述:IC REG CTRLR BUCK PWM CM 32-QFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:2,500 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:500kHz 占空比:96% 电源电压:4 V ~ 36 V 降压:无 升压:是 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:24-WQFN 裸露焊盘 包装:带卷 (TR)