- 您现在的位置：买卖IC网 > PDF目录15286 > LTC3810HUH-5#TRPBF (Linear Technology)IC REG CTRLR BUCK PWM CM 32-QFN PDF资料下载
参数资料
| 型号： | LTC3810HUH-5#TRPBF |
| 厂商： | Linear Technology |
| 文件页数： | 27/38页 |
| 文件大小： | 0K |
| 描述： | IC REG CTRLR BUCK PWM CM 32-QFN |
| 标准包装： | 2,500 |
| PWM 型： | 电流模式 |
| 输出数： | 1 |
| 频率 - 最大： | 1MHz |
| 占空比： | 99% |
| 电源电压： | 4.35 V ~ 60 V |
| 降压： | 是 |
| 升压： | 无 |
| 回扫： | 无 |
| 反相： | 无 |
| 倍增器： | 无 |
| 除法器： | 无 |
| Cuk： | 无 |
| 隔离： | 无 |
| 工作温度： | -40°C ~ 150°C |
| 封装/外壳： | 32-WFQFN 裸露焊盘 |
| 包装： | 带卷 (TR) |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页当前第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页第37页第38页
LTC3810-5
APPLICATIONS INFORMATION
+
V IN
+
?
+
FCB
R4
R3
V IN
C IN
1N4148
TG
LTC3810-5
SW
T1
1:N
BG
SGND PGND
Figure 14. Secondary Output Loop
V OUT2
C OUT2
1μF
V OUT1
C OUT
38105 F14
ambient temperature, conditions that cause the largest
power loss in the converter. Note that it is important to
check for self-consistency between the assumed MOSFET
junction temperature and the resulting value of I LIMIT
which heats the MOSFET switches.
Caution should be used when setting the current limit based
upon the R DS(ON) of the MOSFETs. The maximum current
limit is determined by the minimum MOSFET on-resistance.
Data sheets typically specify nominal and maximum values
for R DS(ON) , but not a minimum. A reasonable assumption
is that the minimum R DS(ON) lies the same percentage
below the typical value as the maximum lies above it.
Consult the MOSFET manufacturer for further guidelines.
V OUT2(MIN) = 0.8V ? 1 +
I LIMIT =
+ ? I L
In addition to providing a logic input to force continu-
ous operation, the MODE/SYNC pin provides a mean to
maintain a flyback winding output when the primary is
operating in pulse skip mode. The secondary output V OUT2
is normally set as shown in Figure 14 by the turns ratio
N of the transformer. However, if the controller goes into
pulse skip mode and halts switching due to a light primary
load current, then V OUT2 will droop. An external resistor
divider from V OUT2 to the MODE/SYNC pin sets a minimum
voltage V OUT2(MIN) below which continuous operation is
forced until V OUT2 has risen above its minimum.
? R4 ?
?
? R3 ?
Fault Conditions: Current Limit and Foldback
The maximum inductor current is inherently limited in a
current mode controller by the maximum sense voltage. In
the LTC3810-5, the maximum sense voltage is controlled
by the voltage on the V RNG pin. With valley current control,
the maximum sense voltage and the sense resistance
determine the maximum allowed inductor valley current.
The corresponding output current limit is:
V SNS(MAX) 1
R DS(ON) ρ T 2
The current limit value should be checked to ensure that
I LIMIT(MIN) > I OUT(MAX) . The minimum value of current
limit generally occurs with the largest V IN at the highest
To further limit current in the event of a short-circuit to
ground, the LTC3810-5 includes foldback current limiting.
If the output falls by more than 50%, then the maximum
sense voltage is progressively lowered to about one-tenth
of its full value.
Be aware also that when the fault timeout is enabled for
the external NMOS regulator, an over current limit may
cause the output to fall below the minimum 4.5V UV
threshold. This condition will cause a linear regulator time-
out/restart sequence as described in the Linear Regulator
Timeout section if this condition persists.
Soft-Start and Tracking
The LTC3810-5 has the ability to either soft-start by itself
with a capacitor or track the output of another supply.
When the device is configured to soft-start by itself, a
capacitor should be connected to the TRACK/SS pin. The
LTC3810-5 is put in a low quiescent current shutdown
state (I Q ~240μA) if the SHDN pin voltage is below 1.5V.
The TRACK/SS pin is actively pulled to ground in this
shutdown state. Once the SHDN pin voltage is above
1.5V, the LTC3810-5 is powered up. A soft-start current
of 1.4μA then starts to charge the soft-start capacitor C SS .
Note that soft-start is achieved not by limiting the maxi-
mum output current of the controller but by controlling
the ramp rate of the output voltage. Current foldback is
disabled during this soft-start phase. During the soft-start
phase, the LTC3810-5 is ramping the reference voltage
until it reaches 0.8V. The force continuous mode is also
38105fd
27
相关PDF资料 |
PDF描述 |
|---|---|
| LTC3834EUFD#TRPBF | IC REG CTRLR BUCK PWM CM 20-QFN |
| LTC3834EFE#TRPBF | IC REG CTRLR BUCK PWM CM 20TSSOP |
| VI-B2Z-EY-F2 | CONVERTER MOD DC/DC 2V 20W |
| LTC1148CS | IC REG CTRLR BUCK PWM CM 14-SOIC |
| VI-B2Z-EY-F1 | CONVERTER MOD DC/DC 2V 20W |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LTC3810IG | 制造商:Linear Technology 功能描述: |
| LTC3810IG#PBF | 功能描述:IC REG CTRLR BUCK PWM CM 28-SSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:2,500 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:500kHz 占空比:96% 电源电压:4 V ~ 36 V 降压:无 升压:是 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:24-WQFN 裸露焊盘 包装:带卷 (TR) |
| LTC3810IG#TRPBF | 功能描述:IC REG CTRLR BUCK PWM CM 28-SSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:2,500 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:500kHz 占空比:96% 电源电压:4 V ~ 36 V 降压:无 升压:是 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:24-WQFN 裸露焊盘 包装:带卷 (TR) |
| LTC3810IUH-5#PBF | 功能描述:IC REG CTRLR BUCK PWM CM 32-QFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:2,500 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:500kHz 占空比:96% 电源电压:4 V ~ 36 V 降压:无 升压:是 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:24-WQFN 裸露焊盘 包装:带卷 (TR) |
| LTC3810IUH-5#TRPBF | 功能描述:IC REG CTRLR BUCK PWM CM 32-QFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:2,500 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:500kHz 占空比:96% 电源电压:4 V ~ 36 V 降压:无 升压:是 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:24-WQFN 裸露焊盘 包装:带卷 (TR) |
发布紧急采购，3分钟左右您将得到回复。