参数资料
| 型号： | LTC3813EG#PBF |
| 厂商： | Linear Technology |
| 文件页数： | 26/32页 |
| 文件大小： | 0K |
| 描述： | IC REG CTRLR BST PWM CM 28-SSOP |
| 标准包装： | 47 |
| PWM 型： | 电流模式 |
| 输出数： | 1 |
| 频率 - 最大： | 1MHz |
| 电源电压： | 7 V ~ 75 V |
| 降压： | 无 |
| 升压： | 是 |
| 回扫： | 无 |
| 反相： | 无 |
| 倍增器： | 无 |
| 除法器： | 无 |
| Cuk： | 无 |
| 隔离： | 无 |
| 工作温度： | -40°C ~ 85°C |
| 封装/外壳： | 28-SSOP（0.209"，5.30mm 宽） |
| 包装： | 管件 |
| 产品目录页面： | 1336 (CN2011-ZH PDF) |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页当前第26页第27页第28页第29页第30页第31页第32页
LTC3813
APPLICATIONS INFORMATION
self-consistency between the assumed MOSFET junction
temperature and the resulting value of I LIMIT which heats
the MOSFET switches.
Caution should be used when setting the current limit
based upon the R DS(ON) of the MOSFETs. The maximum
current limit is determined by the minimum MOSFET
on-resistance. Data sheets typically specify nominal
and maximum values for R DS(ON) , but not a minimum.
A reasonable assumption is that the minimum R DS(ON)
lies the same percentage below the typical value as the
maximum lies above it. Consult the MOSFET manufacturer
for further guidelines.
Note that in a boost mode architecture, it is only possible
to provide protection for “soft” shorts where V OUT > V IN .
For hard shorts, the inductor current is limited only by the
input supply capability.
Soft-Start
The LTC3813 has the ability to soft-start with a capacitor
connected to the SS pin. The LTC3813 is put in a low
quiescent current shutdown state (I Q ~240μA) if the
SHDN pin voltage is below 1.5V. The SS pin is actively
pulled to ground in this shutdown state. Once the SHDN
pin voltage is above 1.5V, the LTC3813 is powered up. A
soft-start current of 1.4μA then starts to charge the soft-
start capacitor C SS . Soft-start is achieved by limiting the
maximum output current of the controller by controlling
the ramp rate of the I TH voltage. The total soft-start time
can be calculated as:
The LTC3813 incorporates a pulse detection circuit that
will detect a clock on the SYNC pin. In turn, it will turn on
the phase-locked loop function. The pulse width of the
clock has to be greater than 400ns and the amplitude of
the clock should be greater than 2V.
The internal oscillator locks to the external clock after the
second clock transition is received. If an external clock
transition is not detected for three successive periods, the
internal oscillator will revert to the frequency programmed
by the R OFF resistor.
During the start-up phase, phase-locked loop function is
disabled. When LTC3813 is not in synchronization mode,
PLL/LPF pin voltage is set to around 1.215V. Frequency
synchronization is accomplished by changing the inter-
nal off-time current according to the voltage on the
PLL/LPF pin.
The phase detector used is an edge sensitive digital type
which provides zero degrees phase shift between the ex-
ternal and internal pulses. This type of phase detector will
not lock up on input frequencies close to the harmonics
of the V CO center frequency. The PLL hold-in range, Δf H ,
is equal to the capture range, Δf C:
Δf H = Δf C = ±0.3 f O
The output of the phase detector is a complementary pair of
current sources charging or discharging the external ?lter
network on the PLL/LPF pin. A simpli?ed block diagram
is shown in Figure 13 .
R LP
t SOFTSTART 2.4 ?
C SS
1.4 μ A
2.4V
PLL/LPF
C LP
Phase-Locked Loop and Frequency Synchronization
The LTC3813 has a phase-locked loop comprised of an
SYNC
DIGITAL
PHASE/
FREQUENCY
DETECTOR
VCO
internal voltage controlled oscillator and phase detector.
This allows the top MOSFET turn-on to be locked to the
rising edge of an external source. The frequency range
of the voltage controlled oscillator is ±30% around the
center frequency f O . The center frequency is the operating
3813 F13
Figure 13. Phase-Locked Loop Block Diagram
frequency discussed in the Operating Frequency section.
3813fb
26
相关PDF资料 |
PDF描述 |
|---|---|
| LTC3814EFE-5#PBF | IC REG CTRLR BST PWM CM 16-TSSOP |
| LTC3816IFE#TRPBF | IC CONTROLLER S-PHASE 38TSSOP |
| LTC3819EG#TRPBF | IC CNTRLR STEP DOWN 36-SSOP |
| LTC3822EGN-1#PBF | IC REG CTRLR BUCK PWM CM 16-SSOP |
| LTC3822EMSE#TRPBF | IC REG CTRLR BUCK PWM CM 10-MSOP |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LTC3813IG#PBF | 功能描述:IC REG CTRLR BST PWM CM 28-SSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:4,500 系列:PowerWise® PWM 型:控制器 输出数:1 频率 - 最大:1MHz 占空比:95% 电源电压:2.8 V ~ 5.5 V 降压:是 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:6-WDFN 裸露焊盘 包装:带卷 (TR) 配用:LM1771EVAL-ND - BOARD EVALUATION LM1771 其它名称:LM1771SSDX |
| LTC3813IG#TRPBF | 功能描述:IC REG CTRLR BST PWM CM 28-SSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:4,500 系列:PowerWise® PWM 型:控制器 输出数:1 频率 - 最大:1MHz 占空比:95% 电源电压:2.8 V ~ 5.5 V 降压:是 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:6-WDFN 裸露焊盘 包装:带卷 (TR) 配用:LM1771EVAL-ND - BOARD EVALUATION LM1771 其它名称:LM1771SSDX |
| LTC3814EFE-5#PBF | 功能描述:IC REG CTRLR BST PWM CM 16-TSSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 特色产品:LM3753/54 Scalable 2-Phase Synchronous Buck Controllers 标准包装:1 系列:PowerWise® PWM 型:电压模式 输出数:1 频率 - 最大:1MHz 占空比:81% 电源电压:4.5 V ~ 18 V 降压:是 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-5°C ~ 125°C 封装/外壳:32-WFQFN 裸露焊盘 包装:Digi-Reel® 产品目录页面:1303 (CN2011-ZH PDF) 其它名称:LM3754SQDKR |
| LTC3814EFE-5#TRPBF | 功能描述:IC REG CTRLR BST PWM CM 16-TSSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:2,500 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:500kHz 占空比:96% 电源电压:4 V ~ 36 V 降压:无 升压:是 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:24-WQFN 裸露焊盘 包装:带卷 (TR) |
| LTC3814IFE-5#PBF | 功能描述:IC REG CTRLR BST PWM CM 16-TSSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:2,500 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:500kHz 占空比:96% 电源电压:4 V ~ 36 V 降压:无 升压:是 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:24-WQFN 裸露焊盘 包装:带卷 (TR) |
发布紧急采购，3分钟左右您将得到回复。