参数资料
型号: LTC3829EFE#PBF
厂商: Linear Technology
文件页数: 21/40页
文件大小: 0K
描述: IC REG CTRLR BUCK PWM CM 38TSSOP
标准包装: 50
系列: PolyPhase®
PWM 型: 电流模式
输出数: 1
频率 - 最大: 850kHz
占空比: 94%
电源电压: 4.5 V ~ 38 V
降压:
升压:
回扫:
反相:
倍增器:
除法器:
Cuk:
隔离:
工作温度: -40°C ~ 125°C
封装/外壳: 38-TFSOP (0.173",4.40mm 宽)裸露焊盘
包装: 管件
LTC3829
APPLICATIONS INFORMATION
V OUT
V IN
Synchronous Switch Duty Cycle = ? IN
V
? I
?
P MAIN = OUT ? MAX ? ( 1 + δ ) R DS(ON) +
PowerMOSFETandSchottkyDiode
(Optional) Selection
At least two external power MOSFETs must be selected for
each of the three output sections: One N-channel MOSFET
for the top (main) switch and one or more N-channel
MOSFET(s) for the bottom (synchronous) switch. The
number, type and on-resistance of all MOSFETs selected
take into account the voltage step-down ratio as well as
the actual position (main or synchronous) in which the
MOSFET will be used. A much smaller and much lower
input capacitance MOSFET should be used for the top
MOSFET in applications that have an output voltage that
is less than 1/3 of the input voltage. In applications where
V IN >> V OUT , the top MOSFETs’ on-resistance is normally
less important for overall efficiency than its input capaci-
tance at operating frequencies above 300kHz. MOSFET
manufacturers have designed special purpose devices that
provide reasonably low on-resistance with significantly
reduced input capacitance for the main switch application
in switching regulators.
The peak-to-peak MOSFET gate drive levels are set by the
voltage, V CC , requiring the use of logic-level threshold
MOSFETs in most applications. Pay close attention to the
BV DSS specification for the MOSFETs as well; many of the
logic-level MOSFETs are limited to 30V or less. Selection
criteria for the power MOSFETs include the on-resistance,
R DS(ON) , input capacitance, input voltage and maximum
output current. MOSFET input capacitance is a combination
of several components but can be taken from the typical
gate charge curve included on most data sheets (Figure 9).
The curve is generated by forcing a constant input current
into the gate of a common source, current source loaded
stage and then plotting the gate voltage versus time.
The initial slope is the effect of the gate-to-source and
the gate-to-drain capacitance. The flat portion of the
curve is the result of the Miller multiplication effect of the
drain-to-gate capacitance as the drain drops the voltage
across the current source load. The upper sloping line is
due to the drain-to-gate accumulation capacitance and
the gate-to-source capacitance. The Miller charge (the
increase in coulombs on the horizontal axis from a to b
while the curve is flat) is specified for a given V DS drain
voltage, but can be adjusted for different V DS voltages by
multiplying the ratio of the application V DS to the curve
specified V DS values. A way to estimate the C MILLER term
is to take the change in gate charge from points a and b
on a manufacturer’s data sheet and divide by the stated
V DS voltage specified. C MILLER is the most important se-
lection criteria for determining the transition loss term in
the top MOSFET but is not directly specified on MOSFET
data sheets. C RSS and C OS are specified sometimes but
definitions of these parameters are not included. When the
controller is operating in continuous mode the duty cycles
for the top and bottom MOSFETs are given by:
Main Switch Duty Cycle =
? V – V OUT ?
?
? V IN ?
The power dissipation for the main and synchronous
MOSFETs at maximum output current are given by:
2
V IN ? N ?
? ? 2 ? ?
( V IN ) 2 ? I MAX ? ( R DR ) ( C MILLER ) ?
? ? V CC – V TH(IL)
V TH(IL) ? ?
V GS
MILLER EFFECT
V
V IN
? 1
?
+
1 ?
? ? f
P SYNC = IN
? ?
V – V OUT ? I MAX ?
N ?
V IN
a b
Q IN
C MILLER = (Q B – Q A )/V DS
+
V GS
+ V DS
3729 F09
?
2
( 1 + δ ) R DS(ON)
Figure 9. Gate Charge Characteristic
3829fa
For more information www.linear.com/LTC3829
21
相关PDF资料
PDF描述
LTC3830ES8#PBF IC REG CTRLR BUCK PWM VM 8-SOIC
LTC3831EGN IC SW REG CONTROLLR SYNC 16-SSOP
LTC3832-1ES8#PBF IC REG CTRLR BUCK PWM VM 8-SOIC
LTC3833EFE#PBF IC REG CTRLR BUCK PWM CM 20TSSOP
LTC3834EFE#PBF IC REG CTRLR BUCK PWM CM 20TSSOP
相关代理商/技术参数
参数描述
LTC3829EUHF#PBF 功能描述:IC REG CTRLR BUCK PWM CM 38-QFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:PolyPhase® 标准包装:2,500 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:500kHz 占空比:96% 电源电压:4 V ~ 36 V 降压:无 升压:是 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:24-WQFN 裸露焊盘 包装:带卷 (TR)
LTC3829EUHF#TRPBF 功能描述:IC REG CTRLR BUCK PWM CM 38-QFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:PolyPhase® 标准包装:4,500 系列:PowerWise® PWM 型:控制器 输出数:1 频率 - 最大:1MHz 占空比:95% 电源电压:2.8 V ~ 5.5 V 降压:是 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:6-WDFN 裸露焊盘 包装:带卷 (TR) 配用:LM1771EVAL-ND - BOARD EVALUATION LM1771 其它名称:LM1771SSDX
LTC3829IFE#PBF 功能描述:IC REG CTRLR BUCK PWM CM 38TSSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:PolyPhase® 标准包装:4,500 系列:PowerWise® PWM 型:控制器 输出数:1 频率 - 最大:1MHz 占空比:95% 电源电压:2.8 V ~ 5.5 V 降压:是 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:6-WDFN 裸露焊盘 包装:带卷 (TR) 配用:LM1771EVAL-ND - BOARD EVALUATION LM1771 其它名称:LM1771SSDX
LTC3829IFE#TRPBF 功能描述:IC REG CTRLR BUCK PWM CM 38TSSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:PolyPhase® 标准包装:4,500 系列:PowerWise® PWM 型:控制器 输出数:1 频率 - 最大:1MHz 占空比:95% 电源电压:2.8 V ~ 5.5 V 降压:是 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:6-WDFN 裸露焊盘 包装:带卷 (TR) 配用:LM1771EVAL-ND - BOARD EVALUATION LM1771 其它名称:LM1771SSDX
LTC3829IUHF#PBF 功能描述:IC REG CTRLR BUCK PWM CM 38-QFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:PolyPhase® 标准包装:4,500 系列:PowerWise® PWM 型:控制器 输出数:1 频率 - 最大:1MHz 占空比:95% 电源电压:2.8 V ~ 5.5 V 降压:是 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:6-WDFN 裸露焊盘 包装:带卷 (TR) 配用:LM1771EVAL-ND - BOARD EVALUATION LM1771 其它名称:LM1771SSDX