参数资料
型号: LTC3850IUF#TRPBF
厂商: Linear Technology
文件页数: 9/38页
文件大小: 0K
描述: IC REG CTRLR BUCK PWM CM 28-QFN
产品培训模块: LTC3850 Dual Output DC/DC Switching Regulator Controller
标准包装: 2,500
系列: PolyPhase®
PWM 型: 电流模式
输出数: 2
频率 - 最大: 860kHz
占空比: 97.2%
电源电压: 4 V ~ 30 V
降压:
升压:
回扫:
反相:
倍增器:
除法器:
Cuk:
隔离:
工作温度: -40°C ~ 85°C
封装/外壳: 28-WFQFN 裸露焊盘
包装: 带卷 (TR)
LTC3850/LTC3850-1
PIN FUNCTIONS
(GN/UF/UFD)
RUN1, RUN2 (Pins 1, 13/Pins 26, 9/Pins 27, 10): Run
Control Inputs. A voltage above 1.2V on either pin turns
on the IC. However, forcing either of these pins below 1.2V
causes the IC to shut down that particular channel. There
are 0.5μA pull-up currents for these pins. Once the RUN
pin rises above 1.2V, an additional 4.5μA pull-up current
is added to the pin.
SENSE1 + , SENSE2 + (Pins 2, 12/Pins 27, 8/Pins 28, 9):
Current Sense Comparator Inputs. The (+) inputs to the
current comparators are normally connected to DCR sens-
ing networks or current sensing resistors.
SENSE1 – , SENSE2 – (Pins 3, 11/Pins 28, 7/Pins 1, 8):
Current Sense Comparator Inputs. The (–) inputs to the
current comparators are connected to the outputs.
TK/SS1, TK/SS2 (Pins 4, 10/Pins 1, 6/Pins 2, 7): Output
Voltage Tracking and Soft-Start Inputs. When one channel
is configured to be master of the two channels, a capaci-
tor to ground at this pin sets the ramp rate for the master
channel’s output voltage. When the channel is configured
to be the slave of two channels, the V FB voltage of the
master channel is reproduced by a resistor divider and
applied to this pin. Internal soft-start currents of 1.3μA
charge the soft-start capacitors.
I TH1 , I TH2 (Pins 5, 9/Pins 2, 5/Pins 3, 6): Current Control
Thresholds and Error Amplifier Compensation Points.
Each associated channels’ current comparator tripping
threshold increases with its I TH control voltage.
V FB1 , V FB2 (Pins 6, 8/Pins 3, 4/Pins 4, 5): Error Amplifier
Feedback Inputs. These pins receive the remotely sensed
feedback voltages for each channel from external resistive
dividers across the outputs.
SGND (Pin 7/Pin 29/Pin 29): Signal Ground. All small-
signal components and compensation components should
connect to this ground, which in turn connects to PGND
at one point. Pin 29 is the Exposed Pad, only available on
the UF package.
EXTV CC (Pin 14, LTC3850-1 Only/Pin 11/Pin 12): External
Power Input to an Internal Switch Connected to INTV CC .
This switch closes and supplies the IC power, bypassing
the internal low dropout regulator, whenever EXTV CC is
higher than 4.7V. Do not exceed 6V on this pin and ensure
V IN > V EXTVCC at all times. On the GN package, EXTV CC
is the optional bonding in place of I LIM for LTC3850-1. In
the LTC3850-1, I LIM will default to 50mV.
I LIM (Pin 14, LTC3850 Only/Pin 10/Pin 11): Current
Comparator Sense Voltage Range Inputs. Tying this pin to
SGND, FLOAT or INTV CC sets the maximum current sense
threshold to three different levels for each comparator.
PGOOD (Pin 15/Pin 12/Pin 13): Power Good Indicator
Output. Open-drain logic out that is pulled to ground when
either channel output exceeds the ±7.5% regulation window,
after the internal 17μs power bad mask timer expires.
PGND (Pin 19/Pin 16/Pin 17): Power Ground Pin. Connect
this pin closely to the sources of the bottom N-channel
MOSFETs, the (–) terminal of CV CC and the (–) terminal
of C IN .
INTV CC (Pin 21/Pin 18/Pin 19): Internal 5V Regulator Output.
The control circuits are powered from this voltage.
Decouple this pin to PGND with a 4.7μF low ESR tantalum
or ceramic capacitor.
V IN (Pin 22/Pin 19/Pin 20): Main Input Supply. Decouple
this pin to PGND with a capacitor (0.1μF to 1μF). For ap-
plications where the main input power is 5V, tie the V IN
and INTV CC pins together.
BG1, BG2 (Pins 23, 20/Pins 20, 17/Pins 21, 18): Bottom
Gate Driver Outputs. These pins drive the gates of the
bottom N-Channel MOSFETs and swings between PGND
and INTV CC .
BOOST1, BOOST2 (Pins 24, 18/Pins 21, 15/Pins 22, 16):
Boosted Floating Driver Supplies. The (+) terminal of the
boost-strap capacitors connect to these pins. These pins
swing from a diode voltage drop below INTV CC up to V IN
+ INTV CC .
TG1, TG2 (Pins 25, 17/Pins 22, 14/Pins 23, 15): Top Gate
Driver Outputs. These are the outputs of floating drivers
with a voltage swing equal to INTV CC superimposed on
the switch nodes voltages.
SW1, SW2 (Pins 26, 16/Pins 23, 13/Pins 24, 14): Switch
Node Connections to Inductors. Voltage swing at these
pins are from a body diode voltage drop below ground
to V IN .
38501fc
9
相关PDF资料
PDF描述
LTC3850IGN#TRPBF IC REG CTRLR BUCK PWM CM 28-SSOP
VE-2WD-EY-F1 CONVERTER MOD DC/DC 85V 50W
RCM22DTAH CONN EDGECARD 44POS R/A .156 SLD
VE-2WB-EY-F4 CONVERTER MOD DC/DC 95V 50W
VE-2WB-EY-F3 CONVERTER MOD DC/DC 95V 50W
相关代理商/技术参数
参数描述
LTC3851AEGN#PBF 功能描述:IC REG CTRLR BUCK PWM CM 16-SSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 特色产品:LM3753/54 Scalable 2-Phase Synchronous Buck Controllers 标准包装:1 系列:PowerWise® PWM 型:电压模式 输出数:1 频率 - 最大:1MHz 占空比:81% 电源电压:4.5 V ~ 18 V 降压:是 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-5°C ~ 125°C 封装/外壳:32-WFQFN 裸露焊盘 包装:Digi-Reel® 产品目录页面:1303 (CN2011-ZH PDF) 其它名称:LM3754SQDKR
LTC3851AEGN#TRPBF 功能描述:IC REG CTRLR BUCK PWM CM 16-SSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:2,500 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:500kHz 占空比:96% 电源电压:4 V ~ 36 V 降压:无 升压:是 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:24-WQFN 裸露焊盘 包装:带卷 (TR)
LTC3851AEMSE#PBF 功能描述:IC REG CTRLR BUCK PWM CM 16-MSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 特色产品:LM3753/54 Scalable 2-Phase Synchronous Buck Controllers 标准包装:1 系列:PowerWise® PWM 型:电压模式 输出数:1 频率 - 最大:1MHz 占空比:81% 电源电压:4.5 V ~ 18 V 降压:是 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-5°C ~ 125°C 封装/外壳:32-WFQFN 裸露焊盘 包装:Digi-Reel® 产品目录页面:1303 (CN2011-ZH PDF) 其它名称:LM3754SQDKR
LTC3851AEMSE#TRPBF 功能描述:IC REG CTRLR BUCK PWM CM 16-MSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:2,500 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:500kHz 占空比:96% 电源电压:4 V ~ 36 V 降压:无 升压:是 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:24-WQFN 裸露焊盘 包装:带卷 (TR)
LTC3851AEMSE-1#PBF 功能描述:IC REG CTRLR BUCK PWM CM 16-MSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:2,500 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:500kHz 占空比:96% 电源电压:4 V ~ 36 V 降压:无 升压:是 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:24-WQFN 裸露焊盘 包装:带卷 (TR)