- 您现在的位置：买卖IC网 > PDF目录80040 > LTC3851AEGN#TRPBF (LINEAR TECHNOLOGY CORP) SWITCHING REGULATOR, PDSO16 PDF资料下载
参数资料
| 型号： | LTC3851AEGN#TRPBF |
| 厂商： | LINEAR TECHNOLOGY CORP |
| 元件分类： | 稳压器 |
| 英文描述： | SWITCHING REGULATOR, PDSO16 |
| 封装： | 0.150 INCH, LEAD FREE, PLASTIC, SSOP-16 |
| 文件页数： | 29/30页 |
| 文件大小： | 430K |
| 代理商： | LTC3851AEGN#TRPBF |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页当前第29页第30页
LTC3851A
8
3851afa
pin FuncTions (GN and MSE/UD)
MODE/PLLIN (Pin 1/Pin 15): Forced Continuous Mode,
Burst Mode or Pulse-Skipping Mode Selection Pin and Ex-
ternalSynchronizationInputtoPhaseDetectorPin.Connect
this pin to INTVCC to force continuous conduction mode
of operation. Connect to GND to enable pulse-skipping
mode of operation. To select Burst Mode operation, tie
this pin to INTVCC through a resistor no less than 50k,
but no greater than 250k. A clock on the pin will cause
the controller to operate in forced continuous mode of
operation and synchronize the internal oscillator.
FREQ/PLLFLTR (Pin 2/Pin 16): The phase-locked loop’s
lowpass filter is tied to this pin. Alternatively, a resistor
can be connected between this pin and GND to vary the
frequency of the internal oscillator.
RUN (Pin 3/Pin 1): Run Control Input. A voltage above
1.22V on this pin turns on the IC. However, forcing this
pin below 1.1V causes the IC to shut down the IC. There
is a 2μA pull-up current on this pin.
TK/SS(Pin4/Pin2):OutputVoltageTrackingandSoft-Start
Input. A capacitor to ground at this pin sets the ramp rate
for the output voltage. An internal soft-start current of of
1μA charges this capacitor.
ITH (Pin 5/Pin 3): Current Control Threshold and Error
Amplifier Compensation Point. The current comparator
tripping threshold increases with its ITH control voltage.
FB (Pin 6/Pin 4): Error Amplifier Feedback Input. This pin
receives the remotely sensed feedback voltage from an
external resistive divider across the output.
SENSE–(Pin7/Pin5):CurrentSenseComparatorInverting
Input.The(–)inputtothecurrentcomparatorisconnected
to the output.
SENSE+ (Pin 8/Pin 6): Current Sense Comparator Non-
inverting Input. The (+) input to the current comparator
is normally connected to the DCR sensing network or
current sensing resistor.
ILIM (Pin 9/Pin 7): Current Comparator Sense Voltage
Range Input. Tying this pin to GND, FLOAT or INTVCC
selects the maximum current sense threshold from three
different levels.
GND (Pin 10/Pin 8, Exposed Pad Pin 17): Ground. All
small-signal components and compensation components
shouldbeKelvinconnectedtothisground.The(–)terminal
of CVCC and the (–) terminal of CIN should be closely con-
nected to this pin. The exposed pad should be soldered
to ground for good thermal conductivity.
BG (Pin 11/Pin 9): Bottom Gate Driver Output. This pin
drives the gate of the bottom N-channel MOSFET between
GND and INTVCC.
INTVCC(Pin12/Pin10):Internal5VRegulatorOutput.The
control circuit is powered from this voltage. Decouple this
pin to GND with a minimum 2.2μF low ESR tantalum or
ceramic capacitor.
VIN (Pin 13/Pin 11): Main Input Supply. Decouple this pin
to GND with a capacitor.
BOOST (Pin 14/Pin 12): Boosted Floating Driver Supply.
The (+) terminal of the boost-strap capacitor is connected
to this pin. This pin swings from a diode voltage drop
below INTVCC up to VIN + INTVCC.
TG (Pin 15/Pin 13): Top Gate Driver Output. This is the
output of a floating driver with a voltage swing equal to
INTVCC superimposed on the switch node voltage.
SW (Pin 16/Pin 14): Switch Node Connection to the In-
ductor. Voltage swing at this pin is from a Schottky diode
(external) voltage drop below ground to VIN.
相关PDF资料 |
PDF描述 |
|---|---|
| LQS50A48-2V5AKJ | 1-OUTPUT 200 W DC-DC REG PWR SUPPLY MODULE |
| LQS50A48-3V3RAKJ | 1-OUTPUT 200 W DC-DC REG PWR SUPPLY MODULE |
| LQS80A48-1V5EKJ | 1-OUTPUT 200 W DC-DC REG PWR SUPPLY MODULE |
| LM4040DIZ-10.0AP | 1-OUTPUT TWO TERM VOLTAGE REFERENCE, 10 V, PBCY3 |
| LM4040DIZ-10.0T&R | 1-OUTPUT TWO TERM VOLTAGE REFERENCE, 10 V, PBCY3 |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LTC3851AEMSE#PBF | 功能描述:IC REG CTRLR BUCK PWM CM 16-MSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 特色产品:LM3753/54 Scalable 2-Phase Synchronous Buck Controllers 标准包装:1 系列:PowerWise® PWM 型:电压模式 输出数:1 频率 - 最大:1MHz 占空比:81% 电源电压:4.5 V ~ 18 V 降压:是 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-5°C ~ 125°C 封装/外壳:32-WFQFN 裸露焊盘 包装:Digi-Reel® 产品目录页面:1303 (CN2011-ZH PDF) 其它名称:LM3754SQDKR |
| LTC3851AEMSE#TRPBF | 功能描述:IC REG CTRLR BUCK PWM CM 16-MSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:2,500 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:500kHz 占空比:96% 电源电压:4 V ~ 36 V 降压:无 升压:是 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:24-WQFN 裸露焊盘 包装:带卷 (TR) |
| LTC3851AEMSE-1#PBF | 功能描述:IC REG CTRLR BUCK PWM CM 16-MSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:2,500 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:500kHz 占空比:96% 电源电压:4 V ~ 36 V 降压:无 升压:是 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:24-WQFN 裸露焊盘 包装:带卷 (TR) |
| LTC3851AEMSE-1#TRPBF | 功能描述:IC REG CTRLR BUCK PWM CM 16-MSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:2,500 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:500kHz 占空比:96% 电源电压:4 V ~ 36 V 降压:无 升压:是 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:24-WQFN 裸露焊盘 包装:带卷 (TR) |
| LTC3851AEUD#PBF | 功能描述:IC REG CTRLR BUCK PWM CM 16-QFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:2,500 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:500kHz 占空比:96% 电源电压:4 V ~ 36 V 降压:无 升压:是 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:24-WQFN 裸露焊盘 包装:带卷 (TR) |
发布紧急采购，3分钟左右您将得到回复。