- 您现在的位置：买卖IC网 > PDF目录80071 > LTC3851AHMSE-1#PBF (LINEAR TECHNOLOGY CORP) 0.05 A SWITCHING CONTROLLER, 810 kHz SWITCHING FREQ-MAX, PDSO16 PDF资料下载
参数资料
| 型号： | LTC3851AHMSE-1#PBF |
| 厂商： | LINEAR TECHNOLOGY CORP |
| 元件分类： | 稳压器 |
| 英文描述： | 0.05 A SWITCHING CONTROLLER, 810 kHz SWITCHING FREQ-MAX, PDSO16 |
| 封装： | LEAD FREE, PLASTIC, MSOP-16 |
| 文件页数： | 5/30页 |
| 文件大小： | 0K |
| 代理商： | LTC3851AHMSE-1#PBF |
第1页第2页第3页第4页当前第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页
LTC3851A-1
13
3851a1fa
applicaTions inForMaTion
The Typical Application on the first page of this data sheet
is a basic LTC3851A-1 application circuit. The LTC3851A-1
can be configured to use either DCR (inductor resistance)
sensing or low value resistor sensing. The choice of the
two current sensing schemes is largely a design trade-off
between cost, power consumption and accuracy. DCR
sensing is becoming popular because it saves expensive
current sensing resistors and is more power efficient,
especially in high current applications. However, current
sensing resistors provide the most accurate current limits
for the controller. Other external component selection
is driven by the load requirement, and begins with the
selection of RSENSE (if RSENSE is used) and the inductor
value. Next, the power MOSFETs and Schottky diodes are
selected. Finally, input and output capacitors are selected.
The circuit shown on the first page can be configured for
operation up to 38V at VIN.
SENSE+ and SENSE– Pins
The SENSE+ and SENSE– pins are the inputs to the current
comparators. The common mode input voltage range of
the current comparators is 0V to 5.5V. Both SENSE pins
are high impedance inputs with small base currents of
less than 1μA. When the SENSE pins ramp up from 0V
to 1.4V, the small base currents flow out of the SENSE
pins. When the SENSE pins ramp down from 5V to 1.1V,
the small base currents flow into the SENSE pins. The
high impedance inputs to the current comparators allow
accurate DCR sensing. However, care must be taken not
to float these pins during normal operation.
Low Value Resistors Current Sensing
A typical sensing circuit using a discrete resistor is shown
in Figure 1. RSENSE is chosen based on the required output
current.
The current comparator has a maximum threshold,
VMAX = 53mV. The current comparator threshold sets the
maximumpeakoftheinductorcurrent,yieldingamaximum
average output current, IMAX, equal to the peak value less
halfthepeak-to-peakripplecurrent,IL.Allowingamargin
of 20% for variations in the IC and external component
values yields:
RSENSE = 0.8
VMAX
IMAX + IL/2
Inductor DCR Sensing
For applications requiring the highest possible efficiency,
the LTC3851A-1 is capable of sensing the voltage drop
across the inductor DCR, as shown in Figure 2. The
DCR of the inductor represents the small amount of
DC winding resistance of the copper, which can be less
than 1mΩ for today’s low value, high current inductors.
If the external R1||R2 C1 time constant is chosen to
be exactly equal to the L/DCR time constant, the voltage
drop across the external capacitor is equal to the voltage
dropacrosstheinductorDCRmultipliedbyR2/(R1+R2).
Therefore, R2 may be used to scale the voltage across the
sense terminals when the DCR is greater than the target
sense resistance. Check the manufacturer’s data sheet
for specifications regarding the inductor DCR, in order
to properly dimension the external filter components.
The DCR of the inductor can also be measured using a
good RLC meter.
Figure 1. Using a Resistor to Sense Current with the LTC3851A-1
VIN
INTVCC
BOOST
TG
SW
BG
GND
FILTER COMPONENTS
PLACED NEAR SENSE PINS
SENSE+
SENSE–
LTC3851A-1
VOUT
RSENSE
3851A1 F01
相关PDF资料 |
PDF描述 |
|---|---|
| LPD48SP | 1-OUTPUT 75 W DC-DC REG PWR SUPPLY MODULE |
| LM2575S-12 | 3.2 A SWITCHING REGULATOR, 62 kHz SWITCHING FREQ-MAX, PSSO5 |
| LK1601-7ERD0TB1 | 1-OUTPUT 150 W AC-DC REG PWR SUPPLY MODULE |
| LT1074HVCV | 5.5 A SWITCHING REGULATOR, 200 kHz SWITCHING FREQ-MAX, PSIP11 |
| LES010YE | 1-OUTPUT 15 W DC-DC REG PWR SUPPLY MODULE |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LTC3851AIGN#PBF | 功能描述:IC REG CTRLR BUCK PWM CM 16-SSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:2,500 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:500kHz 占空比:96% 电源电压:4 V ~ 36 V 降压:无 升压:是 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:24-WQFN 裸露焊盘 包装:带卷 (TR) |
| LTC3851AIGN#TRPBF | 功能描述:IC REG CTRLR BUCK PWM CM 16-SSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:2,500 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:500kHz 占空比:96% 电源电压:4 V ~ 36 V 降压:无 升压:是 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:24-WQFN 裸露焊盘 包装:带卷 (TR) |
| LTC3851AIMSE#PBF | 功能描述:IC REG CTRLR BUCK PWM CM 16-MSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:2,500 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:500kHz 占空比:96% 电源电压:4 V ~ 36 V 降压:无 升压:是 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:24-WQFN 裸露焊盘 包装:带卷 (TR) |
| LTC3851AIMSE#TRPBF | 功能描述:IC REG CTRLR BUCK PWM CM 16-MSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:2,500 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:500kHz 占空比:96% 电源电压:4 V ~ 36 V 降压:无 升压:是 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:24-WQFN 裸露焊盘 包装:带卷 (TR) |
| LTC3851AIMSE-1#PBF | 功能描述:IC REG CTRLR BUCK PWM CM 16-MSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:2,500 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:500kHz 占空比:96% 电源电压:4 V ~ 36 V 降压:无 升压:是 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:24-WQFN 裸露焊盘 包装:带卷 (TR) |
发布紧急采购，3分钟左右您将得到回复。