- 您现在的位置：买卖IC网 > PDF目录1832 > LTC3852EUDD#PBF (Linear Technology)IC REG CTRLR DOUBLER PWM 24-QFN PDF资料下载
参数资料
| 型号： | LTC3852EUDD#PBF |
| 厂商： | Linear Technology |
| 文件页数： | 25/32页 |
| 文件大小： | 0K |
| 描述： | IC REG CTRLR DOUBLER PWM 24-QFN |
| 标准包装： | 73 |
| PWM 型： | 电流模式 |
| 输出数： | 1 |
| 频率 - 最大： | 810kHz |
| 占空比： | 99% |
| 电源电压： | 2.7 V ~ 38 V |
| 降压： | 是 |
| 升压： | 无 |
| 回扫： | 无 |
| 反相： | 无 |
| 倍增器： | 是 |
| 除法器： | 无 |
| Cuk： | 无 |
| 隔离： | 无 |
| 工作温度： | -40°C ~ 125°C |
| 封装/外壳： | 24-WFQFN 裸露焊盘 |
| 包装： | 管件 |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页当前第25页第26页第27页第28页第29页第30页第31页第32页
LTC3852
APPLICATIONS INFORMATION
can be computed using the duty cycle (D = V OUT /V IN ).
The effective MOSFET DC resistance is therefore:
R ON(EFF) = D ? R ON(TOP) + (1-D) ? R ON(BOT)
The effective MOSFET resistance can then be summed
with the DCR of the inductor and the sense resistor
to obtain the overall series resistance. For example,
consider a DC/DC converter with a 3.3V input voltage
and a 1.2V/15A output. The nominal duty cycle of this
converter is 36% (1.2V/3.3V). For a design with R ON(TOP)
= 8mΩ and R ON(BOT) = 2mΩ, the effective MOSFET DC
resistance is (0.36) ? 0.008 + (1-0.36) ? 0.002 = 4.2mΩ.
For an inductor DCR = 1mΩ and a 2mΩ sense resistor,
the total series resistance is 7.2mΩ. For an output
current range of 5A to 15A, the total I 2 R losses range
from 1% to 9% for a 1.2V output. It is worth noting that
the losses due to the sense resistor at full load (15A)
are 450mW, or 2.5%. If the same application used
a DCR current sensing scheme, the peak ef?ciency
would be 2.5% higher, an expensive component would
be eliminated from the bill of materials, and the
solution size would be smaller . The ef?ciency varies
as the inverse square of V OUT for the same external
components and output power level. The combined
effects of increasingly lower output voltages and higher
currents required by high performance digital systems
is not doubling but quadrupling the importance of loss
terms in the switching regulator system!
2. Since the LTC3852 was optimized for low supply voltage
applications, the transition losses for the top MOSFET
can normally be neglected. Transition losses for the
top MOSFET only become signi?cant when operating
at high input voltages (typically 15V or greater). This
condition can occur, however, when the input to the
charge pump is not the same voltage as the input to the
DC/DC converter power stage. For example, an auxiliary,
low current 3.3V supply could be connected to the input
of the charge pump (V IN1 ), while the DC/DC converter
power stage could draw power from a high current 12V
supply. Transition losses for the upper power MOSFET
can be estimated from the following equation:
Transition Loss = (1.7)V DS(MAX)2 ? I O(MAX)
? C RSS ? f SW
3. The INTV CC current is the sum of the MOSFET driver and
DC bias requirements of the internal circuitry. The gate
drive current results from charging the gate capacitance
of the power MOSFETs. Each time a MOSFET gate is
switched on, a packet of charge Q G moves from INTV CC
to the MOSFET gate. The resulting dQ/dt is a current
into INTV CC that is typically much larger than the DC
bias current for the internal control circuitry. In CCM
operation, I GATE = f SW ? (Q G(TOP) + Q G(BOT) ), where
Q G(TOP) and Q G(BOT) are the gate charges of the top
and bottom MOSFETs respectively. These parameters
are listed on most power MOSFET datasheets.
4. The DC bias current for the controller is speci?ed in the
Electrical Characteristics table, and is typically 1.2mA.
This current is almost always much smaller than the
gate charge current associated with the power MOSFETs
in CCM operation.
5. In most LTC3852 applications, the output of the charge
pump will be connected to the V IN2 and INTV CC pins of
the controller. The DC bias current into the controller
V IN2 pin, as well as the gate charge current associated
with the power MOSFETs, will typically be supplied by
the charge pump. Because the charge pump has a ?nite
power ef?ciency, the input current will be higher that
the output current when the charge pump is active.
For a 3.3V input application where the output of the
charge pump is 5.1V, this ef?ciency is approximately
72%, as shown in the graph in the Typical Performance
Characteristics. As a result, for every 1mA of current
required by the controller, about 1.4mA will be drawn
from the V IN1 pin.
The DC bias current of the charge pump within the LTC3852
is typically only 60μA. For the purposes of power losses, this
bias current is typically 2 orders of magnitude lower than
the gate drive current, and can therefore be neglected.
Other “hidden” losses such as copper trace and the battery
internal resistance can account for an additional several
percent ef?ciency degradation in portable systems. It is
very important to include these “system” level losses
during the design phase. The internal battery and fuse
resistance losses can be minimized by making sure that
C IN has adequate charge storage and very low ESR at the
switching frequency. A 25W supply will typically require
3852f
25
相关PDF资料 |
PDF描述 |
|---|---|
| LTC3853EUJ#PBF | IC REG CTRLR BUCK PWM CM 40-QFN |
| LTC3854EMSE#PBF | IC REG CTRLR BUCK PWM CM 12-MSOP |
| LTC3855IUJ#PBF | IC REG CTRLR BUCK PWM CM 40-QFN |
| LTC3856IFE#TRPBF | IC REG CTRLR BUCK PWM CM 38TSSOP |
| LTC3858IUH#TRPBF | IC REG CTRLR BUCK PWM CM 32-QFN |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LTC3852IUDD#PBF | 功能描述:IC REG CTRLR DOUBLER PWM 24-QFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:2,500 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:500kHz 占空比:96% 电源电压:4 V ~ 36 V 降压:无 升压:是 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:24-WQFN 裸露焊盘 包装:带卷 (TR) |
| LTC3852IUDD#TRPBF | 功能描述:IC REG CTRLR DOUBLER PWM 24-QFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:2,500 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:500kHz 占空比:96% 电源电压:4 V ~ 36 V 降压:无 升压:是 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:24-WQFN 裸露焊盘 包装:带卷 (TR) |
| LTC3853EUJ#PBF | 功能描述:IC REG CTRLR BUCK PWM CM 40-QFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:PolyPhase® 特色产品:LM3753/54 Scalable 2-Phase Synchronous Buck Controllers 标准包装:1 系列:PowerWise® PWM 型:电压模式 输出数:1 频率 - 最大:1MHz 占空比:81% 电源电压:4.5 V ~ 18 V 降压:是 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-5°C ~ 125°C 封装/外壳:32-WFQFN 裸露焊盘 包装:Digi-Reel® 产品目录页面:1303 (CN2011-ZH PDF) 其它名称:LM3754SQDKR |
| LTC3853EUJ#TRPBF | 功能描述:IC REG CTRLR BUCK PWM CM 40-QFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:PolyPhase® 特色产品:LM3753/54 Scalable 2-Phase Synchronous Buck Controllers 标准包装:1 系列:PowerWise® PWM 型:电压模式 输出数:1 频率 - 最大:1MHz 占空比:81% 电源电压:4.5 V ~ 18 V 降压:是 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-5°C ~ 125°C 封装/外壳:32-WFQFN 裸露焊盘 包装:Digi-Reel® 产品目录页面:1303 (CN2011-ZH PDF) 其它名称:LM3754SQDKR |
| LTC3853EUJPBF | 制造商:Linear Technology 功能描述:DC-DC Controller Triple Buck 24V QFN40 |
发布紧急采购，3分钟左右您将得到回复。