- 您现在的位置：买卖IC网 > PDF目录15283 > LTC3855IFE#TRPBF (Linear Technology)IC REG CTRLR BUCK PWM CM 38TSSOP PDF资料下载
参数资料
| 型号： | LTC3855IFE#TRPBF |
| 厂商： | Linear Technology |
| 文件页数： | 21/44页 |
| 文件大小： | 0K |
| 描述： | IC REG CTRLR BUCK PWM CM 38TSSOP |
| 标准包装： | 2,000 |
| 系列： | PolyPhase® |
| PWM 型： | 电流模式 |
| 输出数： | 2 |
| 频率 - 最大： | 850kHz |
| 占空比： | 95% |
| 电源电压： | 4.5 V ~ 38 V |
| 降压： | 是 |
| 升压： | 无 |
| 回扫： | 无 |
| 反相： | 无 |
| 倍增器： | 无 |
| 除法器： | 无 |
| Cuk： | 无 |
| 隔离： | 无 |
| 工作温度： | -40°C ~ 125°C |
| 封装/外壳： | 38-TFSOP （0.173"，4.40mm 宽）裸露焊盘 |
| 包装： | 带卷 (TR) |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页当前第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页第37页第38页第39页第40页第41页第42页第43页第44页
LTC3855
APPLICATIONS INFORMATION
V IN – V OUT V
L MIN >
V OUT
V OUT
V IN
Areasonablestartingpointistochoosearipplecurrent
that is about 40% of I OUT(MAX) for a duty cycle less than
40%. Note that the largest ripple current occurs at the
highest input voltage. To guarantee that ripple current does
not exceed a specified maximum, the inductor should be
chosen according to:
L ≥ ? OUT
f OSC ?I RIPPLE V IN
For duty cycles greater than 40%, the 10mV current
sense ripple voltage requirement is relaxed because the
slope compensation signal aids the signal-to-noise ratio
and because a lower limit is placed on the inductor value
to avoid subharmonic oscillations. To ensure stability for
duty cycles up to the maximum of 95%, use the following
equation to find the minimum inductance.
? 1 . 4
f SW ? I LOAD ( MAX )
where
L MIN is in units of μH
f SW is in units of MHz
Inductor Core Selection
Once the inductance value is determined, the type of in-
ductor must be selected. Core loss is independent of core
size for a fixed inductor value, but it is very dependent
on inductance selected. As inductance increases, core
losses go down. Unfortunately, increased inductance
requires more turns of wire and therefore copper losses
will increase.
Ferrite designs have very low core loss and are preferred
at high switching frequencies, so design goals can con-
centrate on copper loss and preventing saturation. Ferrite
core material saturates “hard,” which means that induc-
tance collapses abruptly when the peak design current is
exceeded. This results in an abrupt increase in inductor
ripple current and consequent output voltage ripple. Do
not allow the core to saturate!
Power MOSFET and Schottky Diode
(Optional) Selection
Two external power MOSFETs must be selected for each
controller in the LTC3855: one N-channel MOSFET for the
top (main) switch, and one N-channel MOSFET for the
bottom (synchronous) switch.
The peak-to-peak drive levels are set by the INTV CC
voltage. This voltage is typically 5V during start-up
(see EXTV CC Pin Connection). Consequently, logic-level
threshold MOSFETs must be used in most applications.
The only exception is if low input voltage is expected (V IN
< 5V); then, sub-logic level threshold MOSFETs (V GS(TH)
< 3V) should be used. Pay close attention to the BV DSS
specification for the MOSFETs as well; most of the logic
level MOSFETs are limited to 30V or less.
Selection criteria for the power MOSFETs include the
on-resistance R DS(ON) , Miller capacitance C MILLER , input
voltage and maximum output current. Miller capacitance,
C MILLER , can be approximated from the gate charge curve
usually provided on the MOSFET manufacturers’ data
sheet. C MILLER is equal to the increase in gate charge
along the horizontal axis while the curve is approximately
flat divided by the specified change in V DS . This result is
then multiplied by the ratio of the application applied V DS
to the gate charge curve specified V DS . When the IC is
operating in continuous mode the duty cycles for the top
and bottom MOSFETs are given by:
Main Switch Duty Cycle =
Synchronous Switch Duty Cycle =
V IN – V OUT
V IN
3855f
相关PDF资料 |
PDF描述 |
|---|---|
| LT3748HMS#TRPBF | IC REG CTRLR FLYBK ISO CM 16MSOP |
| LTC1628CG | IC REG CTRLR BUCK PWM CM 28-SSOP |
| VI-271-EW-F2 | CONVERTER MOD DC/DC 12V 100W |
| LTC1929CG-PG#TR | IC REG CTRLR BUCK PWM CM 28-SSOP |
| VI-271-EW-F1 | CONVERTER MOD DC/DC 12V 100W |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LTC3855IUJ#PBF | 功能描述:IC REG CTRLR BUCK PWM CM 40-QFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:PolyPhase® 特色产品:LM3753/54 Scalable 2-Phase Synchronous Buck Controllers 标准包装:1 系列:PowerWise® PWM 型:电压模式 输出数:1 频率 - 最大:1MHz 占空比:81% 电源电压:4.5 V ~ 18 V 降压:是 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-5°C ~ 125°C 封装/外壳:32-WFQFN 裸露焊盘 包装:Digi-Reel® 产品目录页面:1303 (CN2011-ZH PDF) 其它名称:LM3754SQDKR |
| LTC3855IUJ#PBF-ES | 制造商:Linear Technology 功能描述: |
| LTC3855IUJ#TRPBF | 功能描述:IC REG CTRLR BUCK PWM CM 40-QFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:PolyPhase® 标准包装:2,500 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:500kHz 占空比:96% 电源电压:4 V ~ 36 V 降压:无 升压:是 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:24-WQFN 裸露焊盘 包装:带卷 (TR) |
| LTC3856EFE#PBF | 功能描述:IC REG CTRLR BUCK PWM CM 38TFSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:PolyPhase® 标准包装:2,000 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:1MHz 占空比:50% 电源电压:9 V ~ 10 V 降压:无 升压:是 回扫:是 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 85°C 封装/外壳:8-TSSOP（0.173"，4.40mm 宽） 包装:带卷 (TR) |
| LTC3856EFE#TRPBF | 功能描述:IC REG CTRLR BUCK PWM CM 38TSSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:PolyPhase® 标准包装:2,500 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:500kHz 占空比:96% 电源电压:4 V ~ 36 V 降压:无 升压:是 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:24-WQFN 裸露焊盘 包装:带卷 (TR) |
发布紧急采购，3分钟左右您将得到回复。