参数资料
型号: LTC3879EUD#PBF
厂商: Linear Technology
文件页数: 16/28页
文件大小: 0K
描述: IC REG CTRLR BUCK PWM CM 16-QFN
标准包装: 121
PWM 型: 电流模式
输出数: 1
频率 - 最大: 2MHz
占空比: 90%
电源电压: 4 V ~ 38 V
降压:
升压:
回扫:
反相:
倍增器:
除法器:
Cuk:
隔离:
工作温度: -40°C ~ 85°C
封装/外壳: 16-WFQFN 裸露焊盘
包装: 管件
产品目录页面: 1336 (CN2011-ZH PDF)
LTC3879
APPLICATIONS INFORMATION
Fault Conditions: Current Limit and Foldback
The maximum inductor current is inherently limited in a
current mode controller by the maximum sense voltage.
In the LTC3879, the maximum sense voltage is controlled
by the voltage on the V RNG pin. With valley current mode
control, the maximum sense voltage and the sense re-
sistance determine the maximum allowed inductor valley
current. The corresponding output current limit is:
Applications using large MOSFETs with a high input voltage
and high frequency of operation may cause the LTC3879
to exceed its maximum junction temperature rating or
RMS current rating. In continuous mode operation, this
current is I GATECHG = f OP (Q g(TOP) + Q g(BOT) ). The junction
temperature can be estimated from the equations given
in Note 2 of the Electrical Characteristics. For example,
with a 30V input supply, the LTC3879 in the MSE16 is
limited to less than:
I LIMIT =
V SNS ( MAX )
R DS ( ON ) ? ρ T
+
1
2
? Δ I L
T J = 70°C + (46mA)(30)(40°C/W) = 125°C
Using the INTV CC regulator to supply external loads greater
The current limit value should be checked to ensure that
I LIMIT(MIN) > I OUT(MAX) . The current limit value should
be greater than the inductor current required to produce
maximum output power at the worst-case ef?ciency.
Worst-case ef?ciency typically occurs at the highest V IN
and highest ambient temperature. It is important to check
for consistency between the assumed MOSFET junction
temperatures and the resulting value of I LIMIT which heats
the MOSFET switches.
Caution should be used when setting the current limit based
on the R DS(ON) of the MOSFETs. The maximum current
limit is determined by the minimum MOSFET on-resistance.
Data sheets typically specify nominal and maximum values
for R DS(ON) but not a minimum. A reasonable assumption
is that the minimum R DS(ON) lies the same amount below
the typical value as the maximum lies above it. Consult the
MOSFET manufacturer for further guidelines.
To further limit current in the event of a short circuit to
ground, the LTC3879 includes foldback current limiting.
If the output falls by more than 50%, then the maximum
sense voltage is progressively lowered to about one-sixth
of its full value.
INTV CC Regulator
An internal P-channel low dropout regulator produces the
5.3V supply that powers the drivers and internal circuitry
within the LTC3879. The INTV CC pin can supply up to 50mA
RMS and must be bypassed to ground with a minimum of
1μF low ESR tantalum or ceramic capacitor (10V, X5R or
than 5mA is discouraged. INTV CC is designed to supply
the LTC3879 with minimal external loading. When using
the regulator to supply larger external loads, carefully
consider all operating load conditions. During load steps
and soft-start, transient current requirements signi?cantly
exceed the RMS values. Additional loading on INTV CC takes
away from the drive available to source gate charge during
high frequency transient load steps.
Soft-Start with the TRACK/SS Pin
The LTC3879 has the ability to either soft-start by itself
with a capacitor or track the output of another channel
or external supply. When the LTC3879 is con?gured to
soft-start by itself, a capacitor should be connected to the
TRACK/SS pin. The LTC3879 is in the shutdown state when
the RUN pin is below 0.7V. When RUN is greater than 0.7V
but less than 1.5V, all internal circuitry is enabled while
M T and M B are forced off. The TRACK/SS pin is actively
pulled to ground when RUN is less than 1.5V.
When the RUN pin voltage is greater than 1.5V, the LTC3879
powers up. When not tracking, a soft-start current of 1μA
is used to charge a soft-start capacitor placed on the
TRACK/SS pin. Note that soft-start or tracking is achieved
not by limiting the maximum output current of the control-
ler, but instead by controlling the output voltage according
to the ramp rate on the TRACK/SS pin. Current foldback
is disabled during start-up to ensure smooth soft-start or
tracking. The soft-start or tracking range is determined to be
the voltage range from 0V to 0.6V on the TRACK/SS pin.
X7R). Output capacitance greater than 10μF is discouraged.
Good bypassing is necessary to supply the high transient
currents required by the MOSFET gate drivers.
t SOFT ? START = 0 . 6 ?
C SS
1 μA
3879f
16
相关PDF资料
PDF描述
LTC3880EUJ-1#PBF IC REG CTRLR BUCK PWM CM 40-QFN
LTC3890EUH#PBF IC REG CTRLR BUCK PWM CM 32-QFN
LTC3891EFE#PBF IC REG CTRLR BUCK PWM CM 20TSSOP
LTC4000IGN#TRPBF IC CHARGER BATTERY 28-SSOP
LTC4001EUF#TRPBF IC CHARGER LI-ION BUCK 16-QFN
相关代理商/技术参数
参数描述
LTC3879IMSE#PBF 功能描述:IC REG CTRLR BUCK PWM CM 16-MSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:2,500 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:500kHz 占空比:96% 电源电压:4 V ~ 36 V 降压:无 升压:是 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:24-WQFN 裸露焊盘 包装:带卷 (TR)
LTC3879IMSE#TRPBF 功能描述:IC REG CTRLR BUCK PWM CM 16-MSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:2,500 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:500kHz 占空比:96% 电源电压:4 V ~ 36 V 降压:无 升压:是 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:24-WQFN 裸露焊盘 包装:带卷 (TR)
LTC3879IUD#PBF 功能描述:IC REG CTRLR BUCK PWM CM 16-QFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:2,500 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:500kHz 占空比:96% 电源电压:4 V ~ 36 V 降压:无 升压:是 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:24-WQFN 裸露焊盘 包装:带卷 (TR)
LTC3879IUD#TRPBF 功能描述:IC REG CTRLR BUCK PWM CM 16-QFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:2,500 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:500kHz 占空比:96% 电源电压:4 V ~ 36 V 降压:无 升压:是 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:24-WQFN 裸露焊盘 包装:带卷 (TR)
LTC3880EUJ#PBF 功能描述:IC REG CTRLR BUCK PWM CM 40-QFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:PolyPhase® 特色产品:LM3753/54 Scalable 2-Phase Synchronous Buck Controllers 标准包装:1 系列:PowerWise® PWM 型:电压模式 输出数:1 频率 - 最大:1MHz 占空比:81% 电源电压:4.5 V ~ 18 V 降压:是 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-5°C ~ 125°C 封装/外壳:32-WFQFN 裸露焊盘 包装:Digi-Reel® 产品目录页面:1303 (CN2011-ZH PDF) 其它名称:LM3754SQDKR