- 您现在的位置：买卖IC网 > PDF目录1833 > LTC3879EUD#PBF (Linear Technology)IC REG CTRLR BUCK PWM CM 16-QFN PDF资料下载
参数资料
| 型号： | LTC3879EUD#PBF |
| 厂商： | Linear Technology |
| 文件页数： | 8/28页 |
| 文件大小： | 0K |
| 描述： | IC REG CTRLR BUCK PWM CM 16-QFN |
| 标准包装： | 121 |
| PWM 型： | 电流模式 |
| 输出数： | 1 |
| 频率 - 最大： | 2MHz |
| 占空比： | 90% |
| 电源电压： | 4 V ~ 38 V |
| 降压： | 是 |
| 升压： | 无 |
| 回扫： | 无 |
| 反相： | 无 |
| 倍增器： | 无 |
| 除法器： | 无 |
| Cuk： | 无 |
| 隔离： | 无 |
| 工作温度： | -40°C ~ 85°C |
| 封装/外壳： | 16-WFQFN 裸露焊盘 |
| 包装： | 管件 |
| 产品目录页面： | 1336 (CN2011-ZH PDF) |
第1页第2页第3页第4页第5页第6页第7页当前第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页
LTC3879
PIN FUNCTIONS
TRACK/SS (Pin 1): External Tracking and Soft-Start Input.
The LTC3879 regulates V FB to the smaller of 0.6V or the
voltage on the TRACK/SS pin. An internal 1μA pull-up
current source is connected to this pin. A capacitor to
ground at this pin sets the ramp time to the ?nal regulated
output voltage. Alternatively, a resistor divider on another
voltage supply connected to this pin allows the output to
track the other supply during start-up.
PGOOD (Pin 2): Power Good Output. This open-drain
logic output is pulled to ground when the output voltage is
outside of a ±10% window around the regulation point.
V RNG (Pin 3): V DS Sense Voltage Range Input. The maxi-
mum allowed bottom MOSFET V DS sense voltage between
SW and PGND is equal to (0.133)V RNG . The voltage applied
to V RNG can be any value between 0.2V and 2V. If V RNG is
tied to SGND, the device operates with a maximum valley
current sense threshold of 30mV typical. If V RNG is tied
to INTV CC , the device operates with a maximum valley
current sense threshold of 75mV typical.
MODE (Pin 4): MODE Input. Connect this pin to INTV CC to
enable discontinuous mode for light load operation. Con-
nect this pin to SGND to force continuous mode operation
in all conditions.
I TH (Pin 5): Current Control Threshold and Error Ampli?er
Compensation Point. The current comparator threshold
increases with this control voltage. The voltage ranges
from 0V to 2.4V, with 0.8V corresponding to zero sense
voltage (zero current).
SGND (Pin 6): Signal Ground. All small-signal components
should be connected to SGND. Connect SGND to PGND
using a single PCB trace.
I ON (Pin 7): On-Time Current Input. Tie a resistor from
V IN to this pin to set the one-shot timer current and thus
the switching frequency.
RUN (Pin 9): Run Control Input. RUN below 1.5V disables
switching by forcing TG and BG low. RUN less than 1.5V
but greater than 0.7V enables all internal bias including
the INTV CC output. RUN below 0.7V shuts down all bias
and places the LTC3879 into micropower shutdown mode
of approximately 18μA. There is an internal 1.2μA pull-up
current source for operation with an open-collector RUN
signal.
V IN (Pin 10): Main Input Supply. The supply voltage can
range from 4V to 38V. For increased noise immunity de-
couple this pin to PGND with an RC ?lter.
INTV CC (Pin 11): Internal 5.3V Regulator Output. The
driver and control circuits are powered from this voltage.
Decouple this pin to PGND with a minimum of 1μF, 10V
X5R or X7R ceramic capacitor.
BG (Pin 12): Bottom Gate Drive. This pin drives the gate
of the bottom N-Channel power MOSFET between PGND
and INTV CC .
PGND (Pin 13): Power Ground. Connect this pin as close
as practical to the source of the bottom N-channel power
MOSFET, the (–) terminal of C INTVCC and the (–) terminal
of C VIN .
SW (Pin 14): Switch Node. The (–) terminal of the bootstrap
capacitor, C B , connects to this node. This pin swings from
a diode voltage below ground up to V IN .
TG (Pin 15): Top Gate Drive. This pin drives the gate of the
top N-channel power MOSFET between SW and BOOST.
BOOST (Pin 16): Boosted Floating Driver Supply. The (+)
terminal of the bootstrap capacitor, C B , connects to this
node. This node swings from (INTV CC – V SCHOTTKY ) to
V IN + (INT VCC – V SCHOTTKY ).
Exposed Pad (Pin 17): The Exposed Pad is SGND and
must be soldered to the PCB.
V FB (Pin 8): Error Ampli?er Feedback Input. This pin con-
nects the error ampli?er to an external resistive divider
from V OUT .
3879f
8
相关PDF资料 |
PDF描述 |
|---|---|
| LTC3880EUJ-1#PBF | IC REG CTRLR BUCK PWM CM 40-QFN |
| LTC3890EUH#PBF | IC REG CTRLR BUCK PWM CM 32-QFN |
| LTC3891EFE#PBF | IC REG CTRLR BUCK PWM CM 20TSSOP |
| LTC4000IGN#TRPBF | IC CHARGER BATTERY 28-SSOP |
| LTC4001EUF#TRPBF | IC CHARGER LI-ION BUCK 16-QFN |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LTC3879IMSE#PBF | 功能描述:IC REG CTRLR BUCK PWM CM 16-MSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:2,500 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:500kHz 占空比:96% 电源电压:4 V ~ 36 V 降压:无 升压:是 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:24-WQFN 裸露焊盘 包装:带卷 (TR) |
| LTC3879IMSE#TRPBF | 功能描述:IC REG CTRLR BUCK PWM CM 16-MSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:2,500 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:500kHz 占空比:96% 电源电压:4 V ~ 36 V 降压:无 升压:是 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:24-WQFN 裸露焊盘 包装:带卷 (TR) |
| LTC3879IUD#PBF | 功能描述:IC REG CTRLR BUCK PWM CM 16-QFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:2,500 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:500kHz 占空比:96% 电源电压:4 V ~ 36 V 降压:无 升压:是 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:24-WQFN 裸露焊盘 包装:带卷 (TR) |
| LTC3879IUD#TRPBF | 功能描述:IC REG CTRLR BUCK PWM CM 16-QFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:2,500 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:500kHz 占空比:96% 电源电压:4 V ~ 36 V 降压:无 升压:是 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:24-WQFN 裸露焊盘 包装:带卷 (TR) |
| LTC3880EUJ#PBF | 功能描述:IC REG CTRLR BUCK PWM CM 40-QFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:PolyPhase® 特色产品:LM3753/54 Scalable 2-Phase Synchronous Buck Controllers 标准包装:1 系列:PowerWise® PWM 型:电压模式 输出数:1 频率 - 最大:1MHz 占空比:81% 电源电压:4.5 V ~ 18 V 降压:是 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-5°C ~ 125°C 封装/外壳:32-WFQFN 裸露焊盘 包装:Digi-Reel® 产品目录页面:1303 (CN2011-ZH PDF) 其它名称:LM3754SQDKR |
发布紧急采购，3分钟左右您将得到回复。