- 您现在的位置：买卖IC网 > PDF目录15996 > LTC4009IUF-2#PBF (Linear Technology)IC CHARGER BATTERY MC 20-QFN PDF资料下载
参数资料
| 型号： | LTC4009IUF-2#PBF |
| 厂商： | Linear Technology |
| 文件页数： | 14/28页 |
| 文件大小： | 0K |
| 描述： | IC CHARGER BATTERY MC 20-QFN |
| 标准包装： | 91 |
| 功能： | 充电管理 |
| 电池化学： | 多化学 |
| 电源电压： | 6 V ~ 28 V |
| 工作温度： | -40°C ~ 125°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 20-WFQFN 裸露焊盘 |
| 供应商设备封装： | 20-QFN 裸露焊盘（4x4） |
| 包装： | 管件 |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页当前第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页
LTC4009
LTC4009-1/LTC4009-2
OPERATION
PWM Watchdog Timer
As input and output conditions vary, the LTC4009 may need
to utilize PWM duty cycles approaching 100%. In this case,
operating frequency may be reduced well below 550kHz.
An internal watchdog timer observes the activity on the
TGATE pin. If TGATE is on for more than 40μs, the watchdog
activates and forces the bottom NFET on (top NFET off)
for about 100ns. This avoids a potential source of audible
noise when using ceramic input or output capacitors and
prevents the boost supply capacitor for the top gate driver
from discharging. In low drop out operation, the actual
charge current may not be able to reach the programmed
full-scale value due to the watchdog function.
Overvoltage Protection
The LTC4009 also contains overvoltage detection that
prevents transient battery voltage overshoots of more than
about 6% above the programmed output voltage. When
battery overvoltage is detected, both external MOSFETs are
turned off until the overvoltage condition clears, at which
time a new soft start sequence begins. This is useful for
properly charging battery packs that use an internal switch
to disconnect themselves for performing functions such
as calibration or pulse mode charging.
Reverse Charge Current Protection (Anti-Boost)
Because the LTC4009 always attempts to operate synchro-
nously in full continuous mode (to avoid audible noise from
ceramic capacitors), reverse average charge current can
occur during some invalid operating conditions. To avoid
boosting a lightly loaded system supply during reverse
operation, the LTC4009 monitors the voltage on CLP to
determine if it rises 25mV above DCIN during charge.
However, under heavier system loads, CLP may not boost
above DCIN, even though reverse average current is flow-
ing. In this case a second circuit monitors indication of
reverse average current on PROG.
If the designer intends to replace the input diode with a
MOSFET for improved efficiency, using the ACP signal of
the LTC4009 to control the MOSFET is not recommended.
In this case, the LTC4012 is strongly suggested, because
it includes ideal diode control of the MOSFET, instead of
driving it as a simple switch. This solution is the most ef-
fective at detecting boost conditions and quickly shutting
down the IC. If for some reason the LTC4012 solution is
not acceptable, and a MOSFET with external control is
used to replace the input diode, and there are conditions
involving very low reverse current under no system load
with an AC adapter that cannot sink current, it may still
be possible to boost the DCIN input supply. To cover this
case, the LTC4009 monitors the resistor divider attached
to the DCDIV pin and sets an input overvoltage fault if that
voltage exceeds 1.825V.
If any of these circuits detects boost operation, The LTC4009
turns off both external MOSFETs until the reverse current
condition clears. Once DCIN-CLP > 25mV, a new soft-start
sequence begins.
4009fd
相关PDF资料 |
PDF描述 |
|---|---|
| M3RRK-3420K | IDC CABLE - MPR34K/MC34F/MPR34K |
| 450QXW39MEFC10X40 | CAP ALUM 39UF 450V 20% RADIAL |
| LT1571EGN-5#TRPBF | IC CHARGER BATT CONST V/I 16SSOP |
| 415-0009-030 | CABLE SMB-RA/SMB-RA 30" RG-179 |
| 63RX30330MG412.5X25 | CAP ALUM 330UF 63V 20% RADIAL |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LTC4010 | 制造商:LINEAR 制造商全称:LINEAR 功能描述:High Efficiency Standalone Nickel Battery Charger |
| LTC4010CFE | 制造商:Linear Technology 功能描述:Battery Charger NiCD/NiMH 16-Pin TSSOP EP |
| LTC4010CFE#PBF | 功能描述:IC CHARGER NIMH/NICD 16-TSSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 电池管理 系列:- 其它有关文件:STC3100 View All Specifications 特色产品:STC3100 - Battery Monitor IC 标准包装:4,000 系列:- 功能:燃料，电量检测计/监控器 电池化学:锂离子（Li-Ion） 电源电压:2.7 V ~ 5.5 V 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:8-TSSOP，8-MSOP（0.118"，3.00mm 宽） 供应商设备封装:8-MiniSO 包装:带卷 (TR) 其它名称:497-10526-2 |
| LTC4010CFE#PBF | 制造商:Linear Technology 功能描述:CHARGER BATT NICKEL 34V 16TSSOP 制造商:Linear Technology 功能描述:CHARGER, BATT, NICKEL, 34V, 16TSSOP |
| LTC4010CFE#TRPBF | 功能描述:IC CHARGER NIMH/NICD 16-TSSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 电池管理 系列:- 产品培训模块:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 标准包装:2,500 系列:- 功能:电池监控器 电池化学:碱性，锂离子，镍镉，镍金属氢化物 电源电压:1 V ~ 5.5 V 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:SOT-23-6 供应商设备封装:SOT-6 包装:带卷 (TR) |
发布紧急采购，3分钟左右您将得到回复。