- 您现在的位置：买卖IC网 > PDF目录1833 > LTC4062EDD#TRPBF (Linear Technology)IC BATT CHARGER LI-ION 10-DFN PDF资料下载
参数资料
| 型号： | LTC4062EDD#TRPBF |
| 厂商： | Linear Technology |
| 文件页数： | 10/20页 |
| 文件大小： | 0K |
| 描述： | IC BATT CHARGER LI-ION 10-DFN |
| 标准包装： | 2,500 |
| 功能： | 充电管理 |
| 电池化学： | 锂离子（Li-Ion） |
| 电源电压： | 4.3 V ~ 8 V |
| 工作温度： | -40°C ~ 85°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 10-WFDFN 裸露焊盘 |
| 供应商设备封装： | 10-DFN（3x3） |
| 包装： | 带卷 (TR) |
LTC4062
OPERATIO
is being used). This feature eliminates the need for peri-
odic charge cycle initiations and ensures that the battery
is always fully charged. Automatic recharge is disabled in
user termination mode.
Thermal Regulation
An internal thermal feedback loop reduces the programmed
charge current if the die temperature attempts to rise
above a preset value of approximately 105 ° C. This feature
protects the LTC4062 from excessive temperature and
allows the user to push the limits of the power handling
capability of a given circuit board without risk of damaging
the LTC4062. The charge current can be set according to
If shutdown is not required, leaving the pin disconnected
continuously enables the circuit.
Trickle-Charge and Defective Battery Detection
When the BAT pin voltage is below the 2.9V trickle charge
threshold (V TRIKL ), the charger reduces the charge current
to 10% of the programmed value. If the battery remains in
trickle charge for more than 25% of the total programmed
charge time, the charger stops charging and enters a
FAULT state, indicating that the battery is defective 1 . The
LTC4062 indicates the FAULT state by driving the CHRG
open-drain output with a square wave. The duty cycle of
this oscillation is 50% and the frequency is set by C TIMER :
typical (not worst-case) ambient temperatures with the
assurance that the charger will automatically reduce the
current in worst-case conditions.
f CHRG =
0 . 1 μ F
C TIMER
? 6 Hz
Undervoltage Lockout (UVLO)
An internal undervoltage lockout circuit monitors the input
voltage and keeps the charger in shutdown mode until V CC
rises above the undervoltage lockout threshold (3.8V).
The UVLO circuit has a built-in hysteresis of 200mV.
Furthermore, to protect against reverse current in the
power MOSFET, the UVLO circuit keeps the charger in
shutdown mode if V CC falls to less than 45mV above the
battery voltage. Hysteresis of 145mV prevents the charger
from cycling in and out of shutdown.
Manual Shutdown
At any point in the charge cycle, the charger can be put into
shutdown mode by pulling the EN pin high. This reduces
the supply current to less than 50 μ A and the battery drain
current of the charger to less than 2 μ A. A new charge cycle
can be initiated by floating the EN pin or pulling it low.
A LED driven by the CHRG output exhibits a pulsing
pattern, indicating to the user that the battery needs
replacing. To exit the FAULT state, the charger must be
restarted either by toggling the EN input or removing and
reapplying power to V CC .
Charge Status Output (CHRG)
The charge status indicator pin has three states: pull-
down, pulse at 6Hz and high impedance. In the pull-down
state, an NMOS transistor pulls down on the CHRG pin
capable of sinking up to 10mA. A pull-down state indicates
that the LTC4062 is charging a battery and the charge
current is greater than I DETECT (which is set by the external
component R DET ). A high impedance state indicates that
the charge current has dropped below I DETECT . In the case
where the I DET pin is left unconnected (R DET = ∞ , I DETECT
= 0), a high impedance state on CHRG indicates that the
LTC4062 is not charging.
1 The Defective Battery Detection Feature is only available when time termination is being used.
4062fb
10
相关PDF资料 |
PDF描述 |
|---|---|
| LTC4063EDD#TRPBF | IC BATT CHRGR LI-ION LDO 10DFN |
| LTC4064EMSE#TRPBF | IC CHARGER BATT L-ION 4V 10-MSOP |
| LTC4065EDC#TRPBF | IC CHARGER BATT LI-ON 6-DFN |
| LTC4066EPF#TRPBF | IC USB POWER MANAGER 24-UTQFN |
| LTC4067EDE#TRPBF | IC USB POWER MANAGER 12-DFN |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LTC4063 | 制造商:LINER 制造商全称:Linear Technology 功能描述:Standalone Linear Li-lon Battery Charger with Thermistor Input |
| LTC4063EDD | 功能描述:IC BATT CHRGR LI-ION LDO 10DFN RoHS:否 类别:集成电路 (IC) >> PMIC - 电池管理 系列:- 标准包装:61 系列:- 功能:电源管理 电池化学:锂离子（Li-Ion）、锂聚合物（Li-Pol） 电源电压:4.35 V ~ 5.5 V 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:22-WFDFN 裸露焊盘 供应商设备封装:22-DFN（6x3）裸露焊盘 包装:管件 |
| LTC4063EDD#PBF | 功能描述:IC BATT CHRGR LI-ION LDO 10DFN RoHS:是 类别:集成电路 (IC) >> PMIC - 电池管理 系列:- 其它有关文件:STC3100 View All Specifications 特色产品:STC3100 - Battery Monitor IC 标准包装:4,000 系列:- 功能:燃料，电量检测计/监控器 电池化学:锂离子（Li-Ion） 电源电压:2.7 V ~ 5.5 V 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:8-TSSOP，8-MSOP（0.118"，3.00mm 宽） 供应商设备封装:8-MiniSO 包装:带卷 (TR) 其它名称:497-10526-2 |
| LTC4063EDD#TRPBF | 功能描述:IC BATT CHRGR LI-ION LDO 10DFN RoHS:是 类别:集成电路 (IC) >> PMIC - 电池管理 系列:- 标准包装:61 系列:- 功能:电源管理 电池化学:锂离子（Li-Ion）、锂聚合物（Li-Pol） 电源电压:4.35 V ~ 5.5 V 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:22-WFDFN 裸露焊盘 供应商设备封装:22-DFN（6x3）裸露焊盘 包装:管件 |
| LTC4064 | 制造商:LINER 制造商全称:Linear Technology 功能描述:Monolithic Linear Charger for Back-Up Li-Ion Batteries |
发布紧急采购，3分钟左右您将得到回复。