- 您现在的位置：买卖IC网 > PDF目录1935 > LTC6605IDJC-14#TRPBF (Linear Technology)IC FILTER 14MHZ DUAL 22-DFN PDF资料下载
参数资料
| 型号： | LTC6605IDJC-14#TRPBF |
| 厂商： | Linear Technology |
| 文件页数： | 3/20页 |
| 文件大小： | 0K |
| 描述： | IC FILTER 14MHZ DUAL 22-DFN |
| 标准包装： | 2,500 |
| 滤波器类型： | 抗混迭 |
| 频率 - 截止或中心： | 5MHz |
| 滤波器数： | 2 |
| 滤波器阶数： | 2nd |
| 电源电压： | 2.7 V ~ 5.25 V |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 22-WFDFN 裸露焊盘 |
| 供应商设备封装： | 22-DFN（6x3）裸露焊盘 |
| 包装： | 带卷 (TR) |
LTC6605-14
11
660514f
APPLICATIONS INFORMATION
Setting the passband gain (GAIN = R2/R1) only requires
choosing a value for R1, since R2 is a xed internal 200Ω.
Therefore, the following three gains can be easily congured
without external components:
Table 1. Conguring the Passband Gain Without External
Components
GAIN
(V/V)
GAIN (dB)
R1 (Ω)
INPUT PINS TO USE
1
0
200
Drive the 200Ω Resistors. Tie
the 100Ω Resisters Together.
2
6
100
Drive the 100Ω Resistors.
3
9.5
66.7
Drive the 200Ω and 100Ω
Resistors in Parallel.
The resonant frequency, fO, is independent of R1, and
therefore independent of the gain. For any LTC6605-14 lter
conguration that conforms to Figure 3, the fO is xed at
16.1MHz. The f–3dB frequency depends on the combina-
tion of fO and Q. For any specic gain, Q is adjusted by
the selection of R4.
Setting the f–3dB Frequency
Using an external resistor (REXT), the f–3dB frequency is ad-
justable in the range of 12.4MHz to 20.0MHz (see Figure 3).
The minimum f–3dB is set for REXT equal to 0Ω and the
maximum f–3dB is arbitrarily set for a maximum passband
gain peak less than 1dB.
Table 2. REXT Selection GAIN = 1,
R1 = 200Ω, R4A = R4B = 100Ω
f–3dB (MHz)
REXT Ω
12.4
0
14
30.9
14.5
41.2
15
52.3
15.5
64.9
16
78.7
16.5
80.6
17
110
17.5
127
18
150
18.5
174
19
205
19.5
241
20
287
Figure 4 shows three filter configurations with an
f–3dB = 12.3MHz, without any external components. These
lters have a Q = 0.57, which is an almost ideal Bessel
characteristic with linear phase.
Figure 5 shows lter congurations that use some external
resistors, and are tailored for a very at passband.
Many other congurations are possible by using the equa-
tions in Figure 3. For example, external resistors can be
added to modify the value of R1 to congure GAIN ≠ 1. For
an even more exible lter IC with similar performance,
consider the LTC6601.
BIAS Pin
Each channel of the LTC6605-14 has a BIAS pin whose
function is to tailor both performance and power. The BIAS
pin can be modeled as a voltage source whose potential
is 1.15V above the V– supply and that has a Thevenin
equivalent resistance of 150k. This three-state pin has xed
logic levels relative to V– (see the Electrical Characteristics
table), and can be driven by any external source that can
drive the BIAS pin’s equivalent input impedance.
If the BIAS pin is tied to the positive supply, the part is
in a fully active state congured for highest performance
(lowest noise and lowest distortion).
If the BIAS pin is oated (left unconnected), the part is in
a fully active state, but with amplier currents reduced and
performance scaled back to preserve power consumption.
Care should be taken to limit external leakage currents
to this pin to under 1μA to avoid putting the part in an
unexpected state.
If the BIAS pin is tied to the most negative supply (V–),
the part is in a low power shutdown mode with amplier
outputs disabled. In shutdown, all internal biasing current
sources are shut off, and the output pins each appear as
open collectors with a non-linear capacitor in parallel and
steering diodes to either supply. Because of the non-linear
capacitance, the outputs can still sink and source small
amounts of transient current if exposed to signicant
voltage transients. Using this function to wire-OR outputs
together is not recommended.
相关PDF资料 |
PDF描述 |
|---|---|
| LTC6605IDJC-7#TRPBF | IC FILTER 7MHZ DUAL 22-DFN |
| LTK001ACN8 | IC THERMOCOUPL COMP& KIT 8DIP |
| LX64EV-5FN100I | IC SWITCH DIGITAL 100FPBGA |
| M-991 | IC GENERATOR TONE LP CMOS 14-DIP |
| M1A3P1000L-1FGG484I | IC FPGA M1 1KB FLASH 1M 484FBGA |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LTC6605IDJC-7#PBF | 功能描述:IC FILTER 7MHZ DUAL 22-DFN RoHS:是 类别:集成电路 (IC) >> 接口 - 滤波器 - 有源 系列:- 产品培训模块:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 标准包装:1,000 系列:- 滤波器类型:连续时间，带通低通 频率 - 截止或中心:150kHz 滤波器数:4 滤波器阶数:8th 电源电压:4.74 V ~ 11 V，±2.37 V ~ 5.5 V 安装类型:表面贴装 封装/外壳:28-SOIC（0.295"，7.50mm 宽） 供应商设备封装:28-SOIC W 包装:带卷 (TR) |
| LTC6605IDJC-7#TRPBF | 功能描述:IC FILTER 7MHZ DUAL 22-DFN RoHS:是 类别:集成电路 (IC) >> 接口 - 滤波器 - 有源 系列:- 产品培训模块:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 标准包装:1,000 系列:- 滤波器类型:连续时间，带通低通 频率 - 截止或中心:150kHz 滤波器数:4 滤波器阶数:8th 电源电压:4.74 V ~ 11 V，±2.37 V ~ 5.5 V 安装类型:表面贴装 封装/外壳:28-SOIC（0.295"，7.50mm 宽） 供应商设备封装:28-SOIC W 包装:带卷 (TR) |
| LTC6605IDJC-7-PBF | 制造商:LINER 制造商全称:Linear Technology 功能描述:Dual Matched 7MHz Filter with Low Noise, Low Distortion Differential Amplifi er |
| LTC6605IDJC-7-TRPBF | 制造商:LINER 制造商全称:Linear Technology 功能描述:Dual Matched 7MHz Filter with Low Noise, Low Distortion Differential Amplifi er |
| LTC660CN8 | 功能描述:IC REG DBL INV ADJ 0.1A 8DIP RoHS:否 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 开关稳压器 系列:- 标准包装:2,500 系列:- 类型:升压（升压） 输出类型:可调式 输出数:1 输出电压:1.24 V ~ 30 V 输入电压:1.5 V ~ 12 V PWM 型:电流模式，混合 频率 - 开关:600kHz 电流 - 输出:500mA 同步整流器:无 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:8-SOIC（0.154"，3.90mm 宽） 包装:带卷 (TR) 供应商设备封装:8-SOIC |
发布紧急采购，3分钟左右您将得到回复。