参数资料
型号: LTC6605IDJC-14#TRPBF
厂商: Linear Technology
文件页数: 8/20页
文件大小: 0K
描述: IC FILTER 14MHZ DUAL 22-DFN
标准包装: 2,500
滤波器类型: 抗混迭
频率 - 截止或中心: 5MHz
滤波器数: 2
滤波器阶数: 2nd
电源电压: 2.7 V ~ 5.25 V
安装类型: 表面贴装
封装/外壳: 22-WFDFN 裸露焊盘
供应商设备封装: 22-DFN(6x3)裸露焊盘
包装: 带卷 (TR)
LTC6605-14
16
660514f
Board Layout and Bypass Capacitors
For single-supply applications it is recommended that a
high quality X5R or X7R, 0.1μF bypass capacitor be placed
directly between V+ and the adjacent Vpin. The Vpins,
including the Exposed Pad, should be tied directly to a
low impedance ground plane with minimal routing.
For split power supplies, it is recommended that addi-
tional high quality X5R or X7R, 0.1μF capacitors be used
to bypass pin V+ to ground and Vto ground, again with
minimal routing.
For driving heavy differential loads (< 200Ω), additional
bypass capacitance may be needed between V+ and Vfor
optimal performance. Keep in mind that small geometry
(e.g., 0603) surface mount ceramic capacitors have a much
higher self-resonant frequency than do leaded capacitors,
and perform best in high speed applications.
The VOCM pins should be bypassed to ground with a high
quality ceramic capacitor (at least 0.01μF). In split-sup-
ply applications, the VOCM pin can be either bypassed to
ground or directly hard wired to ground.
Stray parasitic capacitances to any unused input pins
should be kept to a minimum to prevent deviations from the
ideal frequency response. The best approach is to remove
the solder pads for the unused component pins and strip
APPLICATIONS INFORMATION
away any ground plane underneath. Floating unused pins
does not reduce the reliability of the part.
At the output, always keep in mind the differential nature
of the LTC6605-14, because it is important that the load
impedances seen by both outputs (stray or intended) be
as balanced and symmetric as possible. This will help pre-
serve the balanced operation that minimizes the generation
of even-order harmonics and maximizes the rejection of
common mode signals and noise.
Driving ADCs
The LTC6605-14’s rail-to-rail differential output and ad-
justable output common mode voltage make it ideal for
interfacing to differential input ADCs. These ADCs are
typically supplied from a single-supply voltage which can
be as low as 3V (2.7V minimum), and have an optimal com-
mon mode input range near mid-supply. The LTC6605-14
makes interfacing to these ADCs easy, by providing
antialiasing, single-ended to differential conversion and
common mode level shifting.
The sampling process of ADCs creates a transient that is
caused by the switching in of the ADC sampling capaci-
tor. This momentarily “shorts” the output of the amplier
as charge is transferred between amplier and sampling
capacitor. The amplier must recover and settle from this
相关PDF资料
PDF描述
LTC6605IDJC-7#TRPBF IC FILTER 7MHZ DUAL 22-DFN
LTK001ACN8 IC THERMOCOUPL COMP& KIT 8DIP
LX64EV-5FN100I IC SWITCH DIGITAL 100FPBGA
M-991 IC GENERATOR TONE LP CMOS 14-DIP
M1A3P1000L-1FGG484I IC FPGA M1 1KB FLASH 1M 484FBGA
相关代理商/技术参数
参数描述
LTC6605IDJC-7#PBF 功能描述:IC FILTER 7MHZ DUAL 22-DFN RoHS:是 类别:集成电路 (IC) >> 接口 - 滤波器 - 有源 系列:- 产品培训模块:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 标准包装:1,000 系列:- 滤波器类型:连续时间,带通低通 频率 - 截止或中心:150kHz 滤波器数:4 滤波器阶数:8th 电源电压:4.74 V ~ 11 V,±2.37 V ~ 5.5 V 安装类型:表面贴装 封装/外壳:28-SOIC(0.295",7.50mm 宽) 供应商设备封装:28-SOIC W 包装:带卷 (TR)
LTC6605IDJC-7#TRPBF 功能描述:IC FILTER 7MHZ DUAL 22-DFN RoHS:是 类别:集成电路 (IC) >> 接口 - 滤波器 - 有源 系列:- 产品培训模块:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 标准包装:1,000 系列:- 滤波器类型:连续时间,带通低通 频率 - 截止或中心:150kHz 滤波器数:4 滤波器阶数:8th 电源电压:4.74 V ~ 11 V,±2.37 V ~ 5.5 V 安装类型:表面贴装 封装/外壳:28-SOIC(0.295",7.50mm 宽) 供应商设备封装:28-SOIC W 包装:带卷 (TR)
LTC6605IDJC-7-PBF 制造商:LINER 制造商全称:Linear Technology 功能描述:Dual Matched 7MHz Filter with Low Noise, Low Distortion Differential Amplifi er
LTC6605IDJC-7-TRPBF 制造商:LINER 制造商全称:Linear Technology 功能描述:Dual Matched 7MHz Filter with Low Noise, Low Distortion Differential Amplifi er
LTC660CN8 功能描述:IC REG DBL INV ADJ 0.1A 8DIP RoHS:否 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 开关稳压器 系列:- 标准包装:2,500 系列:- 类型:升压(升压) 输出类型:可调式 输出数:1 输出电压:1.24 V ~ 30 V 输入电压:1.5 V ~ 12 V PWM 型:电流模式,混合 频率 - 开关:600kHz 电流 - 输出:500mA 同步整流器:无 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:8-SOIC(0.154",3.90mm 宽) 包装:带卷 (TR) 供应商设备封装:8-SOIC