- 您现在的位置：买卖IC网 > Datasheet目录868 > LTM4608IV#PBF (Linear Technology)IC DC/DC UMODULE 8A 68-LGA Datasheet资料下载
参数资料
| 型号： | LTM4608IV#PBF |
| 厂商： | Linear Technology |
| 文件页数： | 7/26页 |
| 文件大小： | 0K |
| 描述： | IC DC/DC UMODULE 8A 68-LGA |
| 产品培训模块： | Power Module vs. Discrete DC to DC |
| 软件下载： | LTM4608 Spice Model |
| 产品目录绘图： | LTM Series_9x15x2.8 |
| 设计资源： | LTM4608IV#PBF Footprint.bxl |
| 特色产品： | μModule Products |
| 标准包装： | 170 |
| 系列： | µModule® |
| 类型： | 非隔离（POL） |
| 输出数： | 1 |
| 电压 - 输入（最小）： | 2.7V |
| 电压 - 输入（最大）： | 5.5V |
| Voltage - Output 1： | 0.6 ~ 5 V |
| 电流 - 输出（最大）： | 8A |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 68-LGA |
| 尺寸/尺寸： | 0.59" L x 0.35" W x 0.11" H（15.0mm x 9.0mm x 2.8mm） |
| 包装： | 托盘 |
| 工作温度： | -40°C ~ 85°C |
| 效率： | 98% |
| 产品目录页面： | 2711 (CN2011-ZH PDF) |
LTM4608
PIN FUNCTIONS
V IN (C1, C8, C9, D1, D3-D5, D7-D9 and E8): Power Input
Pins. Apply input voltage between these pins and GND
pins. Recommend placing input decoupling capacitance
directly between V IN pins and GND pins.
V OUT (C10-C11, D10-D11, E9-E11, F9-F11, G9-G11):
Power Output Pins. Apply output load between these pins
and GND pins. Recommend placing output decoupling
capacitance directly between these pins and GND pins.
See Table 1.
GND (A1-A11, B1, B9-B11, F3, F7-F8, G1-G8): Power
Ground Pins for Both Input and Output Returns.
SV IN (F4): Signal Input Voltage. This pin is internally con-
nected to V IN through a lowpass filter.
SGND (E1): Signal Ground Pin. Return ground path for all
analog and low power circuitry. Tie a single connection to
GND in the application.
MODE (B5): Mode Select Input. Tying this pin high enables
Burst Mode ? operation. Tying this pin low enables forced
continuous operation. Floating this pin or tying it to V IN /2
enables pulse-skipping operation.
CLKIN (B3): External Synchronization Input to Phase
Detector. This pin is internally terminated to SGND with a
50k resistor. The phase-locked loop will force the internal
top power PMOS turn on to be synchronized with the
rising edge of the CLKIN signal. Connect this pin to SV IN
to enable spread spectrum modulation. During external
synchronization, make sure the PLLLPF pin is not tied to
V IN or GND.
PLLLPF (E3): Phase-Locked Loop Lowpass Filter. An in-
ternal lowpass filter is tied to this pin. In spread spectrum
mode, placing a capacitor here to SGND controls the slew
rate from one frequency to the next. Alternatively, floating
this pin allows normal running frequency at 1.5MHz, tying
this pin to SV IN forces the part to run at 1.33 times its
normal frequency (2MHz), tying it to ground forces the
frequency to run at 0.67 times its normal frequency (1MHz).
PHMODE (B4): Phase Selector Input. This pin determines
the phase relationship between the internal oscillator and
CLKOUT. Tie it high for 2-phase operation, tie it low for
3-phase operation, and float or tie it to V IN /2 for 4-phase
operation.
MGN (B8): Margining Pin. Increases or decreases the
output voltage by the amount specified by the BSEL pin.
To disable margining, tie the MGN pin to a voltage divider
with 50k resistors from V IN to ground. See the Applications
Information section and Figure 20.
BSEL (B7): Margining Bit Select Pin. Tying BSEL low se-
lects ±5%, tying it high selects ±10%. Floating it or tying
it to V IN /2 selects ±15%.
TRACK (E5): Output Voltage Tracking Pin. Voltage track-
ing is enabled when the TRACK voltage is below 0.57V.
If tracking is not desired, then connect the TRACK pin to
SV IN . If TRACK is not tied to SV IN , then the TRACK pin’s
voltage needs to be below 0.18V before the chip shuts
down even though RUN is already low. Do not float this
pin. A resistor divider and capacitor can be applied to the
TRACK pin to increase the soft-start time of the regulator.
See the Applications Information section. Can tie together
for parallel operation and tracking. Load current needs to
be present during track down.
4608fd
7
相关PDF资料 |
PDF描述 |
|---|---|
| LTM4609IV#PBF | IC BUCK/BOOST SYNC ADJ 4A 141LGA |
| LTM4612IV#PBF | IC BUCK SYNC ADJ 5A 133LGA |
| LTM4613MPV#PBF | IC UMODULE DC/DC 8A 133-LGA |
| LTM4614IV#PBF | IC UMODULE DC/DC DUAL 4A 144LGA |
| LTM4615IV#PBF | IC SWIT REG BUCK 4A ADJ 144LGA |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LTM4608V | 制造商:LINER 制造商全称:Linear Technology 功能描述:Low VIN, 8A DC/DC μModuleTM with Tracking, Margining, and Frequency Synchronization |
| LTM4609 | 制造商:LINER 制造商全称:Linear Technology 功能描述:High Efficiency, Synchronous, 4-Switch Buck-Boost Controller |
| LTM4609_12 | 制造商:LINER 制造商全称:Linear Technology 功能描述:36VIN, 34VOUT High Efficiency Buck-Boost DC/DC |
| LTM4609EV | 制造商:LINER 制造商全称:Linear Technology 功能描述:36VIN, 34VOUT High Effi ciency Buck-Boost DC/DC μModule |
| LTM4609EV#PBF | 功能描述:IC UMODULE BUCK-BOOST 141-LGA RoHS:是 类别:电源 - 板载 >> DC DC Converters 系列:µModule® 设计资源:VI-200, VI-J00 Design Guide, Appl Manual 标准包装:1 系列:* 类型:隔离 输出数:1 电压 - 输入（最小）:66V 电压 - 输入（最大）:160V Voltage - Output 1:12V Voltage - Output 2:- Voltage - Output 3:- 电流 - 输出（最大）:* 电源（瓦） - 制造商系列:50W 电压 - 隔离:* 特点:* 安装类型:通孔 封装/外壳:9-FinMod 尺寸/尺寸:4.60" L x 1.86" W x 0.79" H（116.8mm x 47.2mm x 20.1mm） 包装:散装 工作温度:-25°C ~ 85°C 效率:* 电源（瓦特）- 最大:* |
发布紧急采购，3分钟左右您将得到回复。