- 您现在的位置：买卖IC网 > PDF目录80496 > M37478E8TXXXSP 8-BIT, OTPROM, 8 MHz, MICROCONTROLLER, PDIP42 PDF资料下载
参数资料
| 型号： | M37478E8TXXXSP |
| 元件分类： | 微控制器/微处理器 |
| 英文描述： | 8-BIT, OTPROM, 8 MHz, MICROCONTROLLER, PDIP42 |
| 封装： | PLASTIC, SDIP-42 |
| 文件页数： | 13/48页 |
| 文件大小： | 720K |
| 代理商： | M37478E8TXXXSP |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页当前第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页第37页第38页第39页第40页第41页第42页第43页第44页第45页第46页第47页第48页
19
MITSUBISHI MICROCOMPUTERS
7477/ 7478 GROUP
SINGLE-CHIP 8-BIT CMOS MICROCOMPUTER
buffers have the same address in memory. Since the shift register
cannot be written to or read from directly, transmit data is written
to the transmit buffer, and receive data is read from the receive
buffer. The transmit buffer can also hold the next data to be trans-
mitted, and the receive buffer can hold a character while the next
character is being received.
Asynchronous Serial I/O (UART) Mode
Clock asynchronous serial I/O mode (UART) can be selected by
clearing the serial I/O mode selection bit of the serial I/O control
register to “0”.
Eight serial data transfer formats can be selected, and the transfer
formats used by a transmitter and receiver must be identical. The
transmit and receive shift registers each have a buffer, but the two
Fig. 10 UART serial I/O block diagram
Fig. 11 Operation of UART serial I/O function
Receive buffer register
Clock control circuit
Serial I/O control register
Baud rate generator
Serial I/O status register
1/4
Transmit shift completion flag (TSC)
Transmit interrupt request (TI)
Transmit buffer empty flag (TBE)
Receive buffer full flag (RBF)
Receive interrupt request (RI)
Frequency dividing ratio 1/(n+1)
P14
P15
P16
Receive shift register
Transmit shift register
Transmit buffer register
TXD
SCLK
RXD
f(XIN)
Address 00E016
Address 00E216
Address 00E016
Address 00E116
7-bit
1/16
UART control register
ST/SP/PA generation
Serial I/O synchronous clock
selection bit
OE
SP detection
8-bit
PE
FE
ST detection
Address 00E316
Character
length
selection
bit
Data bus
RE
TE
TIC
ST
D0
D1
SP
ST
D0
D1
SP
Transmit or receive clock
Transmit buffer write signal
Serial output TxD
Receive buffer read signal
Serial input RxD
TBE=0
TSC=0
TBE=0
TBE=1
RBF=0
RBF=1
TSC=1
1 start bit
7 or 8 data bits
1 or 0 parity bit
1 or 2 stop bit(s)
ST
D0
D1
SP
ST
D1
SP
V
VGenerated at 2nd bit in 2-stop-bit mode
Notes 1 : Error flag detection occurs at the same time that the RBF flag becomes “1” (at 1st stop bit during reception).
2 : The transmit interrupt (TI) can be selected to occur when either the TBE or TSC flag becomes “1,” depending on the
setting of the transmit interrupt source selection bit (TIC) of the serial I/O control register.
3 : The receive interrupt (RI) is set when the RBF flag becomes “1”.
TBE=1
D0
相关PDF资料 |
PDF描述 |
|---|---|
| M38223E4FS | 8-BIT, OTPROM, 4 MHz, MICROCONTROLLER, CQCC80 |
| M38227M8HXXXFP | 8-BIT, MROM, 4 MHz, MICROCONTROLLER, PQFP80 |
| MC68HC908GR4AVFA | 8-BIT, FLASH, 8.2 MHz, MICROCONTROLLER, PDIP28 |
| MSP430G2001IRSA16 | 16-BIT, FLASH, RISC MICROCONTROLLER, PQCC16 |
| MC9S08SG32VTJ | 8-BIT, FLASH, 40 MHz, MICROCONTROLLER, PDSO20 |
相关代理商/技术参数 |
参数描述 |
|---|---|
| M37478E8TXXXSP/FP | 制造商:RENESAS 制造商全称:Renesas Technology Corp 功能描述:SINGLE-CHIP 8-BIT CMOS MICROCOMPUTER |
| M37478E8-XXXFP | 制造商:RENESAS 制造商全称:Renesas Technology Corp 功能描述:8-BIT SINGLE-CHIP MICROCOMPUTER 740 FAMILY / 7470 SERIES |
| M37478E8-XXXSP | 制造商:RENESAS 制造商全称:Renesas Technology Corp 功能描述:8-BIT SINGLE-CHIP MICROCOMPUTER 740 FAMILY / 7470 SERIES |
| M37478E8-XXXSP/FP | 制造商:RENESAS 制造商全称:Renesas Technology Corp 功能描述:SINGLE-CHIP 8-BIT CMOS MICROCOMPUTER |
| M37478M2TXXXFP | 制造商:RENESAS 制造商全称:Renesas Technology Corp 功能描述:8-BIT SINGLE-CHIP MICROCOMPUTER 740 FAMILY / 7470 SERIES |
发布紧急采购，3分钟左右您将得到回复。