- 您现在的位置：买卖IC网 > PDF目录102740 > M41T93RMY6E (STMICROELECTRONICS) 1 TIMER(S), REAL TIME CLOCK, PDSO18 PDF资料下载
参数资料
| 型号： | M41T93RMY6E |
| 厂商： | STMICROELECTRONICS |
| 元件分类： | 时钟/数据恢复及定时提取 |
| 英文描述： | 1 TIMER(S), REAL TIME CLOCK, PDSO18 |
| 封装： | 0.300 INCH, ROHS COMPLIANT, PLASTIC, SOP-18 |
| 文件页数： | 21/49页 |
| 文件大小： | 719K |
| 代理商： | M41T93RMY6E |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页当前第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页第37页第38页第39页第40页第41页第42页第43页第44页第45页第46页第47页第48页第49页
Clock operation
M41T93
Doc ID 12615 Rev 5
3.7
Watchdog timer
The watchdog timer can be used to detect an out-of-control microprocessor. The user
programs the watchdog timer by setting the desired amount of time-out into the watchdog
register, address 09h. Bits BMB4-BMB0 store a binary multiplier and the two lower order bits
RB1-RB0 select the resolution, where 00 = 1/16 second, 01 = 1/4 second, 10 = 1 second,
and 11 = 4 seconds. The amount of time-out is then determined to be the multiplication of
the five-bit multiplier value with the resolution. (For example: writing 00001110 in the
watchdog register = 3*1, or 3 seconds). If the processor does not reset the timer within the
specified period, the M41T93 sets the WDF (watchdog flag) and generates a watchdog
interrupt.
The watchdog timer can be reset by having the microprocessor perform a WRITE of the
watchdog register. The time-out period then starts over.
Should the watchdog timer time-out, a value of 00h needs to be written to the watchdog
register in order to clear the IRQ/FT/OUT pin. This will also disable the watchdog function
until it is again programmed correctly. A READ of the flags register will reset the watchdog
flag (bit D7; register 0Fh).
The watchdog function is automatically disabled upon power-up and the watchdog register
is cleared. If the watchdog function is set, the frequency test function is activated, and the
SQWE bit is '0,' the watchdog function prevails and the frequency test function is denied.
3.8
8-bit (countdown) timer
The timer value register is an 8-bit binary countdown timer. It is enabled and disabled via the
timer control register (11h) TE bit. Other timer properties such as the source clock, or
interrupt generation are also selected in the timer control register (see Table 7). For
accurate read back of the countdown value, the serial clock (SCL) must be operating at a
frequency of at least twice the selected timer clock.
The timer control register selects one of four source clock frequencies for the timer (4096,
64, 1, or 1/60 Hz), and enables/disables the timer. The timer counts down from a software-
loaded 8-bit binary value. At the end of every countdown, the timer sets the timer flag (TF)
bit. The TF bit can only be cleared by software. When asserted, the timer flag (TF) can also
be used to generate an interrupt (IRQ/FT/OUT) on the M41T93. The interrupt may be
generated as a pulsed signal every countdown period or as a permanently active signal
which follows the condition of TF. The timer interrupt/timer pulse (TI/TP) bit is used to control
this mode selection. When reading the timer, the current countdown value is returned.
Note:
Bit positions labeled with ‘0’ should always be written with logic '0.'
Table 7.
Timer control register map
Addr
D7
D6
D5
D4
D3
D2
D1
D0
Function
0Fh
WDF
AF1
AF2
BL
TF
OF
0
Flags
10h
Timer countdown value
Timer value
11h
TE
TI/TP
TIE
0
TD1
TD0
Timer control
相关PDF资料 |
PDF描述 |
|---|---|
| MN101CA5F | 8-BIT, MROM, 20 MHz, MICROCONTROLLER, PQFP112 |
| MC68HC908QY8MDTE | 8-BIT, FLASH, 32 MHz, MICROCONTROLLER, PDSO16 |
| MC9S12C64MFAE25 | 16-BIT, FLASH, 25 MHz, MICROCONTROLLER, PQFP48 |
| MC312XDP512F0VAG | 16-BIT, FLASH, 40 MHz, MICROCONTROLLER, PQFP144 |
| MC912XDP512F0CAA | 16-BIT, FLASH, 40 MHz, MICROCONTROLLER, PQFP80 |
相关代理商/技术参数 |
参数描述 |
|---|---|
| M41T93RMY6F | 功能描述:实时时钟 Serial SPI bus RTC RoHS:否 制造商:Microchip Technology 功能:Clock, Calendar. Alarm RTC 总线接口:I2C 日期格式:DW:DM:M:Y 时间格式:HH:MM:SS RTC 存储容量:64 B 电源电压-最大:5.5 V 电源电压-最小:1.8 V 最大工作温度:+ 85 C 最小工作温度: 安装风格:Through Hole 封装 / 箱体:PDIP-8 封装:Tube |
| M41T93RMY6F-CUT TAPE | 制造商:ST 功能描述:M41T93 Series 5.5 V Serial SPI Bus RTC with Battery Switchover - SOX-18 |
| M41T93RQA6E | 制造商:STMICROELECTRONICS 制造商全称:STMicroelectronics 功能描述:Serial SPI bus RTC with battery switchover |
| M41T93RQA6F | 功能描述:实时时钟 SPI RTC 32.768 kHz 365nA 2.0V to 5.5V RoHS:否 制造商:Microchip Technology 功能:Clock, Calendar. Alarm RTC 总线接口:I2C 日期格式:DW:DM:M:Y 时间格式:HH:MM:SS RTC 存储容量:64 B 电源电压-最大:5.5 V 电源电压-最小:1.8 V 最大工作温度:+ 85 C 最小工作温度: 安装风格:Through Hole 封装 / 箱体:PDIP-8 封装:Tube |
| M41T93RQA6F-CUT TAPE | 制造商:ST 功能描述:M41T93 Series 5.5 V Serial SPI Bus RTC With Battery Switchover -QFN-16 |
发布紧急采购，3分钟左右您将得到回复。