- 您现在的位置：买卖IC网 > PDF目录383307 > MA28139 (Dynex Semiconductor Ltd.) OBDH Bus Terminal PDF资料下载
参数资料
| 型号： | MA28139 |
| 厂商： | Dynex Semiconductor Ltd. |
| 英文描述： | OBDH Bus Terminal |
| 中文描述： | OBDH客运站 |
| 文件页数： | 3/34页 |
| 文件大小： | 416K |
| 代理商： | MA28139 |
第1页第2页当前第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页
MA28139
3/34
FUNCTIONAL DESCRIPTION
In RT mode, power up resets the OBT and causes it to
deselect both busses. Two watchdog counters monitor the
Nominal l-bus and the Redundant l-bus. If either bus becomes
active, that bus will be selected. If the selected bus stops, the
OBT watchdog times out and resets both the OBT and the
user. If both busses become active, the Nominal bus will be
selected in preference to the Redundant one. A change in bus
selection will always result in the OBT and the user being
reset. Responses from the user are always returned on the
selected bus. Setting ‘SIMUL’ high causes both BATs to drive
both the Nominal and the Redundant busses irrespective of
the current bus selection. The time-out period may be set to
any desired number of bits by varying the ‘LOSC’ frequency.
The OBT derives all timing from, and is synchronous with, the
selected l-bus. The OBT demodulates the l-bus to the DBI and
decodes commands to the IUB.
The CTpRTn mode pin causes the modem circuits and the
RTU Kernel to be either cascade or isolated. If CTpRTn is low
(RT mode), the RIRSYNC, CLK, DATA and VAL signals are
routed to the RTU Kernel and the associated pins act as
outputs; responses from the RTU Kernel are ORed with those
from the external RRTDATA and RRTEN inputs and can be
independently monitored on the DATARRT and ENRRT pins.
In this mode any reset caused by the Clock Detector
watchdogs is also combined with the power up reset input.
If CTpRTn is high (CT mode), the modem and RTU Kernel
functions are isolated to permit the device to be used as either
a modem within the CTU or an RTU Kernel interfacing to an
external modem where the RIRSYNC, CLK, DATA and VAL
pins act as inputs. The right-hand multiplexer bank is switched
to the upper position so that the CT drives the OBDH via the
CIT and CBT (if used) pins and receives responses/telemetry
via the CRR and CBR (if used) pins. Note: in CT mode, BAT1
must be connected to the l-busses.
In RT mode, the CITSEL, MOD, CLK, SYNC and INV pins
are disabled and the clocks are supplied by the l-bus BAR in
response to the selected bus. In CT mode, the Clock Detector
is functional and drives the TlMEOUTn pin but is unable to
cause internal reset on time-out; in this mode the CT must
supply all clocks and select the operational bus.
The changes depending upon selection of RT mode or CT mode with the CTpRTn pin are defined in the table below:
Functional Signal
CT Mode Source
(CTpRTn = ‘1’)
RT Mode Source
(CTpRTn = ‘0’)
BAT1, 2 modulation clock
CITMOD input pin
Recovered R2F
BAT1, 2 data clock
CITCLK input pin
Recovered RIRCLK
BAT1 data input
RRTDATA input pin
RRTDATA OR DATARRT (RTU Kernel)
BAT1 tx enable
‘1’
RRTEN OR DATAEN (RTU Kernel)
BAT1 sync code tx enable
CITSYNC input pin
‘0’
BAT1 bit invalidate tx enable
CITINV input Pin
‘0’
BAT1, 2 bus selection
CITSEL and SIMUL input pins
Detected active bus and SIMUL input pin
BAT2 data input
RBTDATA input Pin
RBTDATA input pin
BAT2 tx enable
RBTEN input pin
RBTEN input pin
BAT1, 2, BAR1, 2, 3 reset
MRSTn input pin
TlMEOUTn AND MRSTn input pin
RIRSYNC, CLK, DATA,
VAL pin direction
outputs
inputs
BAT/BAR and RTU Kernel
coupling
separated
coupled
相关PDF资料 |
PDF描述 |
|---|---|
| MA28140 | Packet Telecommand Decoder |
| MA28151 | Radiation hard Programmable Communication Interface |
| MA28155 | Radiation Hard Programmable Peripheral Interface |
| MA31750 | High Performance MIL-STD-1750 Microprocessor |
| MA31751 | Memory Management & Block Protection Unit |
相关代理商/技术参数 |
参数描述 |
|---|---|
| MA28140 | 制造商:DYNEX 制造商全称:Dynex Semiconductor 功能描述:Packet Telecommand Decoder |
| MA28150FBB | 功能描述:专用陶瓷电容器 HF CHIP RoHS:否 制造商:Panasonic Electronic Components 电容:470 pF 容差:10 % 电压额定值:250 VAC 工作温度范围:- 25 C to + 125 C 端接类型:SMD/SMT 外壳代码 - in: 外壳代码 - mm: |
| MA28150FBN | 功能描述:专用陶瓷电容器 HF CHIP RoHS:否 制造商:Panasonic Electronic Components 电容:470 pF 容差:10 % 电压额定值:250 VAC 工作温度范围:- 25 C to + 125 C 端接类型:SMD/SMT 外壳代码 - in: 外壳代码 - mm: |
| MA28150GBB | 功能描述:专用陶瓷电容器 HF CHIP RoHS:否 制造商:Panasonic Electronic Components 电容:470 pF 容差:10 % 电压额定值:250 VAC 工作温度范围:- 25 C to + 125 C 端接类型:SMD/SMT 外壳代码 - in: 外壳代码 - mm: |
| MA28150GBN | 功能描述:专用陶瓷电容器 HF CHIP RoHS:否 制造商:Panasonic Electronic Components 电容:470 pF 容差:10 % 电压额定值:250 VAC 工作温度范围:- 25 C to + 125 C 端接类型:SMD/SMT 外壳代码 - in: 外壳代码 - mm: |
发布紧急采购，3分钟左右您将得到回复。