- 您现在的位置：买卖IC网 > PDF目录1840 > MAX17535ETG+T (Maxim Integrated Products)IC SMBUS BATT CHARGER 24TQFN PDF资料下载
参数资料
| 型号： | MAX17535ETG+T |
| 厂商： | Maxim Integrated Products |
| 文件页数： | 23/28页 |
| 文件大小： | 0K |
| 描述： | IC SMBUS BATT CHARGER 24TQFN |
| 产品培训模块： | Lead (SnPb) Finish for COTS Obsolescence Mitigation Program |
| 标准包装： | 2,500 |
| 功能： | 充电管理 |
| 电池化学： | 锂离子（锂离子），多化学 |
| 电源电压： | 8 V ~ 26 V |
| 工作温度： | -40°C ~ 85°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 24-WFQFN 裸露焊盘 |
| 供应商设备封装： | 24-TQFN-EP（4x4） |
| 包装： | 带卷 (TR) |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页当前第23页第24页第25页第26页第27页第28页
High-Frequency,
Low-Cost SMBus Chargers
Table 8. IINPVoltage() (0x3E) (continued)
BIT
10
11
12
13
14
15
BIT NAME
IINP Voltage, DACV 6
IINP Voltage, DACV 7
—
—
—
—
DESCRIPTION
0 = Adds 0mA of IINP voltage.
1 = Adds 828.8mV of IINP voltage.
0 = Adds 0mV of IINP voltage.
1 = Adds 1.6576V of IINP voltage to a maximum of 2.20V.
Not used. Normally a 4096mV weight.
Not used. Normally a 8192mV weight.
Not used. Normally a 16384mV weight.
Not used. Normally a 32768mV weight.
DC-DC Converter
The MAX17435/MAX17535 employ a synchronous step-
down DC-DC converter with an n-channel, high-side
MOSFET switch and an n-channel low-side synchronous
rectifier. The MAX17435/MAX17535 feature a pseudo-
fixed-frequency, current-mode control scheme with cycle-
by-cycle current limit. The controller’s constant off-time
(t OFF ) is calculated based on V DCIN , V CSIN , and a time
constant with a minimum value of 300ns. The MAX17435/
MAX17535 can also operate in discontinuous conduction
mode for improved light-load efficiency. The operation of
the DC-DC controller is determined by the following five
comparators as shown in the block diagram in Figure 2:
U The IMIN comparator sets the peak inductor current
in discontinuous mode. IMIN compares the control
signal (LVC) against 100mV (typ). When LVC voltage
is less than 100mV, DHI and DLO are both low.
U The CCMP comparator is used for current-mode
regulation in continuous conduction mode. CCMP
compares LVC against the charging current feedback
signal (CSI). The comparator output is high and the
high-side MOSFET on-time is terminated when the
CSI voltage is higher than LVC.
U The IMAX comparator provides a cycle-by-cycle
current limit. IMAX compares CSI to 2V (corresponding
to 10A when RS2 = 10m I ). The comparator output is
high and the high-side MOSFET on-time is terminated
when the current-sense signal exceeds 10A. A new
cycle cannot start until the IMAX comparator output
goes low.
U The ZCMP comparator provides zero-crossing
detection during discontinuous conduction. ZCMP
compares the current-sense feedback signal to
500mA (RS2 = 10m I ). When the inductor current
is lower than the 500mA threshold, the comparator
output is high and DLO is turned off.
U The OVP comparator checks for the battery voltage
400mV above the set point and, if that condition is
detected, it disables charging.
CCV, CCI, CCS, and LVC Control Blocks
The MAX17435/MAX17535 control input current (CCS
control loop), charge current (CCI control loop), or
charge voltage (CCV control loop), depending on the
operating condition. The three control loops, CCV, CCI,
and CCS are brought together internally at the lowest
voltage clamp (LVC) amplifier. The output of the LVC
amplifier is the feedback control signal for the DC-DC
controller. The minimum voltage at the CCV, CCI, or CCS
appears at the output of the LVC amplifier and clamps
the other control loops to within 0.3V above the control
point. Clamping the other two control loops close to the
lowest control loop ensures fast transition with minimal
overshoot when switching between different control
loops (see the Compensation section).
Continuous Conduction Mode
With sufficient charge current, the MAX17435/
MAX17535s’ inductor current never crosses zero,
which is defined as continuous conduction mode.
The MAX17435 switches at 850kHz (nominal) and the
MAX17535 switches at 500kHz (nominal) if the charger
is not in dropout (V CSIN < 0.88 x V DCIN ). The controller
starts a new cycle by turning on the high-side MOSFET
and turning off the low-side MOSFET. When the charge
current feedback signal (CSI) is greater than the control
point (LVC), the CCMP comparator output goes high and
the controller initiates the off-time by turning off the high-
side MOSFET and turning on the low-side MOSFET. The
operating frequency is governed by the off-time and is
dependent upon V CSIN and V DCIN .
At the end of the fixed off-time, the controller initiates a
new cycle if the control point (LVC) is greater than 150mV,
and the peak charge current is less than the cycle-by-
cycle current limit. Restated another way, IMIN must be
high, IMAX must be low, and OVP must be low for the
______________________________________________________________________________________
23
相关PDF资料 |
PDF描述 |
|---|---|
| MAX1757EAI+T | IC BATTERY CHRG LI+ 28-SSOP |
| MAX17582GTM+T | IC CTLR PWM 2PH IMVP-6.5 48-TQFN |
| MAX1758EAI+T | IC BATTERY CHRG LI+ 28-SSOP |
| MAX1759EUB | IC REG MULTI CONFIG 0.1A 10UMAX |
| MAX1760EUB | IC REG BST SYNC 3.3V/ADJ 10UMAX |
相关代理商/技术参数 |
参数描述 |
|---|---|
| MAX17535EVKIT+ | 功能描述:电池管理 EVKIT RoHS:否 制造商:Texas Instruments 电池类型:Li-Ion 输出电压:5 V 输出电流:4.5 A 工作电源电压:3.9 V to 17 V 最大工作温度:+ 85 C 最小工作温度:- 40 C 封装 / 箱体:VQFN-24 封装:Reel |
| MAX17552ATB+T | 制造商:Maxim Integrated Products 功能描述: |
| MAX1756AAUT | 制造商:Maxim Integrated Products 功能描述:- Cut Tape Product |
| MAX1756AAUT-T | 制造商:Maxim Integrated Products 功能描述:SOT23 LOCAL TEMPERATURE COMPARATOR WITH SMBUS - Tape and Reel |
| MAX1756BAUT | 制造商:Maxim Integrated Products 功能描述:- Cut Tape Product |
发布紧急采购，3分钟左右您将得到回复。