- 您现在的位置：买卖IC网 > PDF目录9817 > MAX3302EEWA+T (Maxim Integrated Products)IC USB OTG TXRX/CHRG PUMP 25-WLP PDF资料下载
参数资料
| 型号： | MAX3302EEWA+T |
| 厂商： | Maxim Integrated Products |
| 文件页数： | 15/38页 |
| 文件大小： | 0K |
| 描述： | IC USB OTG TXRX/CHRG PUMP 25-WLP |
| 产品培训模块： | Lead (SnPb) Finish for COTS Obsolescence Mitigation Program |
| 标准包装： | 2,500 |
| 类型： | 收发器 |
| 驱动器/接收器数： | 1/1 |
| 规程： | USB 2.0 |
| 电源电压： | 3 V ~ 4.5 V |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 25-WFBGA，WLCSP |
| 供应商设备封装： | 25-WLP |
| 包装： | 带卷 (TR) |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页当前第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页第37页第38页
MAX3301E/MAX3302E
USB On-the-Go Transceivers and Charge Pumps
22
______________________________________________________________________________________
REGISTER
MEMORY ADDRESS
DESCRIPTION
Vendor ID
00h, 01h
Read only. The contents of registers 00h and 01h are 6Ah and 0Bh, respectively.
Product ID
02h, 03h
Read only. The contents of registers 02h and 03h are 01h and 33h, respectively.
Control 1
04h (set)
05h (clear)
Sets operating modes, maximum data rate, and direction of data transfer.
Control 2
06h (set)
07h (clear)
Controls D+/D- pullup/pulldown resistor connections, ID_IN state, and VBUS
behavior.
Interrupt source
08h (read)
Read only.
Unused*
09h
Not used.
Interrupt latch
0Ah (set)
0Bh (clear)
Indicates which interrupts have occurred.
Interrupt-enable
Falling edge
0Ch (set)
0Dh (clear)
Enables interrupts for high-to-low transitions.
Interrupt-enable
Rising edge
0Eh (set)
0Fh (clear)
Enables interrupts for low-to-high transitions.
Unused*/Special
Function 2
10h (set)
11h (clear)
MAX3301E: Not used.
MAX3302E: Alternate register addresses for special-function register 2. This
register is also accessible from 16h and 17h.
Special function 1
12h (set)
13h (clear)
Enables hardware/software control of the MAX3301E's behavior, interrupt activity,
and operating modes.
Revision ID
14h, 15h
Read only. The contents of registers 14h and 15h are 77h and 41h, respectively.
Special function 2
16h (set)
17h (clear)
Sets operating modes,
INT output configuration, D+/D- behavior in audio mode,
and TRM source.
Unused*
18h–Fh
Not used.
Table 6. Register Map
Burst-Mode Read Byte Format
The MAX3301E/MAX3302E allow a master device to
read data from sequential registers with the burst-mode
read byte protocol (see Figure 21). The master device
first sends the slave address, followed by a 0. The
MAX3301E/MAX3302E then sends an acknowledge bit.
Next, the master sends the register address to the
MAX3301E/MAX3302E, which then generates another
acknowledge bit. The master then sends a stop condi-
tion to the MAX3301E/MAX3302E. Next, the master
sends a start condition, followed by the MAX3301E/
MAX3302E’s slave address, and then a 1 to indicate a
read command. The MAX3301E/MAX3302E then sends
data to the master device, one byte at a time. The mas-
ter sends an acknowledge bit to the MAX3301E/
MAX3302E after each data byte, and the register
address of the MAX3301E/MAX3302E increments after
each byte. This continues until the master sends a stop
condition. If an unsupported register address is encoun-
tered, the MAX3301E/MAX3302E send a byte of zeros.
Registers
Control Registers
There are two read/write control registers. Control regis-
ter 1 (Table 7) sets operating modes, sets the data rate,
and controls the direction of data transfer. Control regis-
ter 2 (Table 8) connects the D+/D- pullup or pulldown
resistors, sets the VBUS charge/discharge conditions,
and grounds ID_IN. The control registers have two
addresses that implement write-one-set and write-one-
clear features for each of these registers. Writing a 1 to
the set address sets that bit to 1. Writing a 1 to the clear
address resets that bit to 0. Writing a 0 to either address
has no effect on the bits.
*
When writing to an unused register, the device generates a NACK and the register index does not increment.
相关PDF资料 |
PDF描述 |
|---|---|
| MAX201EWE+T | IC TXRX RS-232 W/CAP 16-SOIC |
| VE-2TK-MX-F3 | CONVERTER MOD DC/DC 40V 75W |
| VE-2TK-MX-F2 | CONVERTER MOD DC/DC 40V 75W |
| MAX3483ECSA+T | IC TXRX RS485/422 250KBPS 8-SOIC |
| SY100S314JZ | IC LINE RCVR QUINT DIFF 28-PLCC |
相关代理商/技术参数 |
参数描述 |
|---|---|
| MAX3311CUB | 功能描述:RS-232接口集成电路 RoHS:否 制造商:Exar 数据速率:52 Mbps 工作电源电压:5 V 电源电流:300 mA 工作温度范围:- 40 C to + 85 C 安装风格:SMD/SMT 封装 / 箱体:LQFP-100 封装: |
| MAX3311CUB+ | 功能描述:RS-232接口集成电路 460kbps 1uA Transceiver RoHS:否 制造商:Exar 数据速率:52 Mbps 工作电源电压:5 V 电源电流:300 mA 工作温度范围:- 40 C to + 85 C 安装风格:SMD/SMT 封装 / 箱体:LQFP-100 封装: |
| MAX3311CUB+T | 功能描述:RS-232接口集成电路 460kbps 1uA Transceiver RoHS:否 制造商:Exar 数据速率:52 Mbps 工作电源电压:5 V 电源电流:300 mA 工作温度范围:- 40 C to + 85 C 安装风格:SMD/SMT 封装 / 箱体:LQFP-100 封装: |
| MAX3311CUB-T | 功能描述:RS-232接口集成电路 RoHS:否 制造商:Exar 数据速率:52 Mbps 工作电源电压:5 V 电源电流:300 mA 工作温度范围:- 40 C to + 85 C 安装风格:SMD/SMT 封装 / 箱体:LQFP-100 封装: |
| MAX3311ECUB | 功能描述:RS-232接口集成电路 RoHS:否 制造商:Exar 数据速率:52 Mbps 工作电源电压:5 V 电源电流:300 mA 工作温度范围:- 40 C to + 85 C 安装风格:SMD/SMT 封装 / 箱体:LQFP-100 封装: |
发布紧急采购，3分钟左右您将得到回复。