- 您现在的位置：买卖IC网 > PDF目录9404 > MAX5418LETA+T (Maxim Integrated Products)IC POT DGTL 256-TAP I2C 8-TDFN PDF资料下载
参数资料
| 型号： | MAX5418LETA+T |
| 厂商： | Maxim Integrated Products |
| 文件页数： | 3/14页 |
| 文件大小： | 0K |
| 描述： | IC POT DGTL 256-TAP I2C 8-TDFN |
| 产品培训模块： | Lead (SnPb) Finish for COTS Obsolescence Mitigation Program |
| 标准包装： | 1 |
| 接片： | 256 |
| 电阻（欧姆）： | 100k |
| 电路数： | 1 |
| 温度系数： | 标准值 35 ppm/°C |
| 存储器类型： | 非易失 |
| 接口： | I²C（设备位址） |
| 电源电压： | 2.7 V ~ 5.25 V |
| 工作温度： | -40°C ~ 85°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 8-WDFN 裸露焊盘 |
| 供应商设备封装： | 8-TDFN-EP（3x3） |
| 包装： | 标准包装 |
| 产品目录页面： | 1399 (CN2011-ZH PDF) |
| 其它名称： | MAX5418LETA+TDKR |
MAX5417/MAX5418/MAX5419
256-Tap, Nonvolatile, I2C-Interface,
Digital Potentiometers
______________________________________________________________________________________
11
Message Format for Writing
A write to the MAX5417/MAX5418/MAX5419 consists of
the transmission of the device’s slave address with the
8th bit set to zero, followed by at least 1 byte of infor-
mation (Figure 7). The 1st byte of information is the
command byte. The bytes received after the command
byte are the data bytes. The 1st data byte goes into the
internal register of the MAX5417/MAX5418/MAX5419 as
selected by the command byte (Figure 8).
Command Byte
Use the command byte to select the source and desti-
nation of the wiper data (nonvolatile or volatile memory
registers) and swap data between nonvolatile and
volatile memory registers (see Table 2).
Command Descriptions
VREG: The data byte writes to the volatile memory reg-
ister and the wiper position updates with the data in the
volatile memory register.
NVREG: The data byte writes to the nonvolatile memo-
ry register. The wiper position is unchanged.
NVREGxVREG: Data transfers from the nonvolatile
memory register to the volatile memory register (wiper
position updates).
VREGxNVREG: Data transfers from the volatile memo-
ry register into the nonvolatile memory register.
A
0
SLAVE ADDRESS
CONTROL BYTE
DATA BYTE
ACKNOWLEDGE FROM
MAX5417/MAX5418/MAX5419
NOP/W
1 BYTE
ACKNOWLEDGE FROM
MAX5417/MAX5418/MAX5419
ACKNOWLEDGE FROM
MAX5417/MAX5418/MAX5419
D15
D14 D13 D12 D11 D10
D9
D8
D1
D0
D3
D2
D5
D4
D7
D6
HOW CONTROL BYTE AND DATA BYTE MAP INTO
MAX5417/MAX5418/MAX5419 REGISTERS
S
A
P
S
A
0
SLAVE ADDRESS
CONTROL BYTE
ACKNOWLEDGE FROM
MAX5417/MAX5418/MAX5419
NOP/W
ACKNOWLEDGE FROM
MAX5417/MAX5418/MAX5419
D15
D14
D13
D12
D11
D10
D9
D8
CONTROL BYTE IS STORED ON RECEIPT OF STOP CONDITION
AP
Figure 7. Command Byte Received
Figure 8. Command and Single Data Byte Received
相关PDF资料 |
PDF描述 |
|---|---|
| MS27466T23A35S | CONN RCPT 100POS WALL MNT W/SCKT |
| MS27466E23A35S | CONN RCPT 100POS WALL MNT W/SCKT |
| MS27474E8A98PA | CONN RCPT 3POS JAM NUT W/PINS |
| DS1670E+ | IC CTRLR SYSTEM PORTABLE 20TSSOP |
| DS12C887+ | IC RTC W/RAM 128 BYTE 24-EDIP |
相关代理商/技术参数 |
参数描述 |
|---|---|
| MAX5418META | 制造商:Maxim Integrated Products 功能描述:MAXIM MAX5418META, DIGITAL POTENTIOMETERS - Rail/Tube 制造商:Rochester Electronics LLC 功能描述: 制造商:Maxim Integrated Products 功能描述:Maxim MAX5418META, 100Kohm Digital Potentiometer 256-Tap 2.7V-5.25V 8-pin TDFN |
| MAX5418META+ | 制造商:Maxim Integrated Products 功能描述:DGTL POTENTIOMETER 256POS 100KOHM SGL 8TDFN EP - Rail/Tube |
| MAX5418META+T | 功能描述:数字电位计 IC 256-Tap Nonvolatile I2C-Interface RoHS:否 制造商:Maxim Integrated 电阻:200 Ohms 温度系数:35 PPM / C 容差:25 % POT 数量:Dual 每 POT 分接头:256 弧刷存储器:Volatile 缓冲刷: 数字接口:Serial (3-Wire, SPI) 描述/功能:Dual Volatile Low Voltage Linear Taper Digital Potentiometer 工作电源电压:1.7 V to 5.5 V 电源电流:27 uA 最大工作温度:+ 125 C 安装风格:SMD/SMT 封装 / 箱体:TQFN-16 封装:Reel |
| MAX5418META-T | 功能描述:数字电位计 IC RoHS:否 制造商:Maxim Integrated 电阻:200 Ohms 温度系数:35 PPM / C 容差:25 % POT 数量:Dual 每 POT 分接头:256 弧刷存储器:Volatile 缓冲刷: 数字接口:Serial (3-Wire, SPI) 描述/功能:Dual Volatile Low Voltage Linear Taper Digital Potentiometer 工作电源电压:1.7 V to 5.5 V 电源电流:27 uA 最大工作温度:+ 125 C 安装风格:SMD/SMT 封装 / 箱体:TQFN-16 封装:Reel |
| MAX5418NETA | 制造商:Maxim Integrated Products 功能描述:256-TAP NONVOLATILE 2-WIRE INTERF - Rail/Tube |
发布紧急采购，3分钟左右您将得到回复。