- 您现在的位置：买卖IC网 > PDF目录19751 > MAX5980GTJ+T (Maxim Integrated)IC CTRLR PD IEEE 802.3AF 32TQFN PDF资料下载
参数资料
| 型号： | MAX5980GTJ+T |
| 厂商： | Maxim Integrated |
| 文件页数： | 17/49页 |
| 文件大小： | 0K |
| 描述： | IC CTRLR PD IEEE 802.3AF 32TQFN |
| 标准包装： | 2,500 |
| 类型： | 以太网供电控制器 PD 开关（PoE） |
| 应用： | 供电设备（PSE） |
| 内部开关： | * |
| 电流限制： | * |
| 电源电压： | * |
| 工作温度： | -40°C ~ 105°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 32-WFQFN 裸露焊盘 |
| 供应商设备封装： | 32-TQFN-EP（5x5） |
| 包装： | 带卷 (TR) |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页当前第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页第37页第38页第39页第40页第41页第42页第43页第44页第45页第46页第47页第48页第49页
Quad, IEEE 802.3at/af PSE Controller
for Power-over-Ethernet
To prevent damage to non-PD devices, and to protect
itself from an output short circuit, the device limits the
current into OUT_ to less than 2mA (max) during PD
detection. In midspan mode, after every failed detection
cycle, the device waits at least 2.0s before attempting
another detection cycle.
High-Capacitance Detection
High-capacitance detection for legacy PDs is soft-
ware programmable. To use the software to enable
high-capacitance detection, set LEG_EN_ (Port GPMD
registers, Table 39) to 1 during normal operation. If high-
capacitance detection is enabled, PD signature capaci-
tances up to 100 F F (typ) are accepted.
Power Device Classification
(PD Classification)
During PD classification, the device forces a probe volt-
age between 15V and 20V at OUT_ and measures the
current into OUT_. The measured current determines the
class of the PD.
After each classification cycle, the device sets
CLS_ (R04h[7:4] and R05h[7:4], Table 9) to 1 and reports
the classification results in the classification status bits
(see Table 13). The CLS_ bits are reset to 0 when read
If EN_CL5 is left unconnected, the device will classify the
PD based on Table 33-9 of the IEEE 802.3at standard
(see Table 2). If the measured current exceeds 51mA,
the device will not power the PD, but will report an over-
current classification result and will return to IDLE state
before attempting a new detection cycle.
Class 5 PD Classification
The device supports high power beyond the IEEE
802.3at standard by providing an additional classifica-
tion (Class 5) if needed. To enable Class 5, connect
EN_CL5 to V DD and initiate a global reset or use the soft-
ware to individually enable Class 5 classification for each
port (R1Ch[3:0], Table 29). Once Class 5 is enabled,
during classification, if the device detects currents in
excess of the Class 4 upper-limit threshold, the PD will
be classified as a Class 5 powered device. The PD is
guaranteed to be classified as a Class 5 device for any
classification current from 51mA up to the classification
current-limit threshold. The Class 5 overcurrent threshold
and current limit will be set automatically with ICUT_[5:0]
and ILIM_ (see Tables 40 and 41). Leave EN_CL5
unconnected to disable Class 5 detection and to be fully
compliant to IEEE 802.3at standard classification.
through the CoR (clear on read) register (R05h) or after
a reset event.
Table 2. PSE Classification of a PD (Table 33-9 of the IEEE 802.3at Standard)
MEASURED I CLASS (mA)
0 to 5
> 5 and < 8
8 to 13
> 13 and < 16
16 to 21
> 21 and < 25
25 to 31
> 31 and < 35
35 to 45
> 45 and < 51
CLASSIFICATION
Class 0
May be Class 0 or 1
Class 1
Either Class 1 or 2
Class 2
Either Class 2 or 3
Class 3
Either Class 3 or 4
Class 4
Either Class 4 or Invalid
17
相关PDF资料 |
PDF描述 |
|---|---|
| VI-25Z-CY-F1 | CONVERTER MOD DC/DC 2V 20W |
| MAX5927AETJ+T | IC HOT SWAP CTLR QUAD 32-TQFN |
| VE-B6V-CY-B1 | CONVERTER MOD DC/DC 5.8V 50W |
| MIC29201-12BU | IC REG LDO 12V .4A TO-263-5 |
| VI-25Z-CX-F4 | CONVERTER MOD DC/DC 2V 30W |
相关代理商/技术参数 |
参数描述 |
|---|---|
| MAX5980UTJ+ | 功能描述:电源开关 IC - POE / LAN 0-16V Hot-Swap Controller RoHS:否 制造商:Fairchild Semiconductor 开关数量:Single 开关配置:SPST 开启电阻（最大值）:7.3 Ohms 串话: 带宽: 开启时间（最大值）:13 ns 关闭时间（最大值）:20 ns 切换电压（最大）: 工作电源电压:8 V to 26 V 最大工作温度:+ 125 C 安装风格:Through Hole 封装 / 箱体:TO-220F-6 |
| MAX5980UTJ+T | 功能描述:电源开关 IC - POE / LAN 0-16V Hot-Swap Controller RoHS:否 制造商:Fairchild Semiconductor 开关数量:Single 开关配置:SPST 开启电阻（最大值）:7.3 Ohms 串话: 带宽: 开启时间（最大值）:13 ns 关闭时间（最大值）:20 ns 切换电压（最大）: 工作电源电压:8 V to 26 V 最大工作温度:+ 125 C 安装风格:Through Hole 封装 / 箱体:TO-220F-6 |
| MAX5981AETE+ | 功能描述:热插拔功率分布 IEEE 802.3af/at PDIC Controller RoHS:否 制造商:Texas Instruments 产品:Controllers & Switches 电流限制: 电源电压-最大:7 V 电源电压-最小:- 0.3 V 工作温度范围: 功率耗散: 安装风格:SMD/SMT 封装 / 箱体:MSOP-8 封装:Tube |
| MAX5981AETE+T | 功能描述:热插拔功率分布 IEEE 802.3af/at PDIC Controller RoHS:否 制造商:Texas Instruments 产品:Controllers & Switches 电流限制: 电源电压-最大:7 V 电源电压-最小:- 0.3 V 工作温度范围: 功率耗散: 安装风格:SMD/SMT 封装 / 箱体:MSOP-8 封装:Tube |
| MAX5981AEVKIT# | 制造商:Maxim Integrated Products 功能描述:EVKIT FOR POWERED DEVICE INTERFACE CONTROLLERS WITH INTEGRAT - Boxed Product (Development Kits) 制造商:Maxim Integrated Products 功能描述:KIT EVAL INTERFACE CONTROLLER |
发布紧急采购，3分钟左右您将得到回复。