参数资料
型号: MAX5980GTJ+T
厂商: Maxim Integrated
文件页数: 4/49页
文件大小: 0K
描述: IC CTRLR PD IEEE 802.3AF 32TQFN
标准包装: 2,500
类型: 以太网供电控制器 PD 开关(PoE)
应用: 供电设备(PSE)
内部开关: *
电流限制: *
电源电压: *
工作温度: -40°C ~ 105°C
安装类型: 表面贴装
封装/外壳: 32-WFQFN 裸露焊盘
供应商设备封装: 32-TQFN-EP(5x5)
包装: 带卷 (TR)
Quad, IEEE 802.3at/af PSE Controller
for Power-over-Ethernet
ELECTRICAL CHARACTERISTICS (continued)
(V AGND = 32V to 60V, V EE = V DGND = 0V, T A = -40 N C to +105 N C. All voltages are referenced to V EE , unless otherwise noted. Typical
values are at V AGND = 54V, T A = +25 N C, and default register settings. Currents are positive when entering the pin, and negative
otherwise.) (Note 2)
PARAMETER
SYMBOL
CONDITIONS
MIN
TYP
MAX
UNITS
PGOOD Hysteresis
PG HYS
220
mV
PGOOD Low-to-High Glitch Filter
t PGOOD
Time V OUT_ - V EE has to exceed PGTH to
set the PGOOD_ bit in register 10h
2
4
ms
LOAD DISCONNECT
Minimum V SENSE_ allowed before
DC Load Disconnect Threshold
V DCTH
disconnect (DC disconnect active),
1.25
1.875
2.5
mV
V OUT_ = 0V
Load Disconnect Time
t DISC
Time from V SENSE_ < V DCTH to gate
shutdown (Note 5)
300
400
ms
DETECTION
Detection Probe Voltage (First
Phase)
Detection Probe Voltage
(Second Phase)
Current-Limit Protection
V DPH1
V DPH2
I DLIM
V AGND - V DET during the first detection
phase
V AGND - V DET during the second detection
phase
V OUT_ = V AGND , current measured through
OUT_ during detection
3.8
8.8
1.50
4
9.1
4.2
9.4
2
V
V
mA
If V AGND - V OUT_ < V DCP after the first
Short-Circuit Threshold
V DCP
detection phase, a short circuit to AGND is
1.5
V
detected
Open-Circuit Threshold
I D_OPEN
First point measurement current threshold
for open condition
12.5
F A
Resistor Detection Window
Resistor Rejection Window
R DOK
R DBAD
(Note 5)
Detection rejects lower values
Detection rejects higher values
19
32
26.5
15.2
k I
k I
CLASSIFICATION
Classification Probe Voltage
V CL
V AGND - V OUT_ during classification
15.5
20
V
Current-Limit Protection
Classification Event Timing
Mark Event Voltage
Mark Event Current Limit
Mark Event Timing
I CL_LIM
t CL_E
V MARK
I MARK_LIM
t MARK_E
V OUT_ = V AGND , current measured
through OUT_
V AGND - V DET durin g mark event
V DET = V AGND , during mark event
measure current through DET
65
14
8
34
7
75
18
40
9
86
22
9.6
46
11
mA
ms
V
mA
ms
Class 0, Class 1
5.5
6.5
7.5
Classification Current Thresholds
I CL
Classification
current thresholds
between classes
Class 1, Class 2
Class 2, Class 3
Class 3, Class 4
Class 4 upper limit
(Note 6)
13.0
21
31
45
14.5
23
33
48
16.0
25
35
51
mA
4
相关PDF资料
PDF描述
VI-25Z-CY-F1 CONVERTER MOD DC/DC 2V 20W
MAX5927AETJ+T IC HOT SWAP CTLR QUAD 32-TQFN
VE-B6V-CY-B1 CONVERTER MOD DC/DC 5.8V 50W
MIC29201-12BU IC REG LDO 12V .4A TO-263-5
VI-25Z-CX-F4 CONVERTER MOD DC/DC 2V 30W
相关代理商/技术参数
参数描述
MAX5980UTJ+ 功能描述:电源开关 IC - POE / LAN 0-16V Hot-Swap Controller RoHS:否 制造商:Fairchild Semiconductor 开关数量:Single 开关配置:SPST 开启电阻(最大值):7.3 Ohms 串话: 带宽: 开启时间(最大值):13 ns 关闭时间(最大值):20 ns 切换电压(最大): 工作电源电压:8 V to 26 V 最大工作温度:+ 125 C 安装风格:Through Hole 封装 / 箱体:TO-220F-6
MAX5980UTJ+T 功能描述:电源开关 IC - POE / LAN 0-16V Hot-Swap Controller RoHS:否 制造商:Fairchild Semiconductor 开关数量:Single 开关配置:SPST 开启电阻(最大值):7.3 Ohms 串话: 带宽: 开启时间(最大值):13 ns 关闭时间(最大值):20 ns 切换电压(最大): 工作电源电压:8 V to 26 V 最大工作温度:+ 125 C 安装风格:Through Hole 封装 / 箱体:TO-220F-6
MAX5981AETE+ 功能描述:热插拔功率分布 IEEE 802.3af/at PDIC Controller RoHS:否 制造商:Texas Instruments 产品:Controllers & Switches 电流限制: 电源电压-最大:7 V 电源电压-最小:- 0.3 V 工作温度范围: 功率耗散: 安装风格:SMD/SMT 封装 / 箱体:MSOP-8 封装:Tube
MAX5981AETE+T 功能描述:热插拔功率分布 IEEE 802.3af/at PDIC Controller RoHS:否 制造商:Texas Instruments 产品:Controllers & Switches 电流限制: 电源电压-最大:7 V 电源电压-最小:- 0.3 V 工作温度范围: 功率耗散: 安装风格:SMD/SMT 封装 / 箱体:MSOP-8 封装:Tube
MAX5981AEVKIT# 制造商:Maxim Integrated Products 功能描述:EVKIT FOR POWERED DEVICE INTERFACE CONTROLLERS WITH INTEGRAT - Boxed Product (Development Kits) 制造商:Maxim Integrated Products 功能描述:KIT EVAL INTERFACE CONTROLLER