- 您现在的位置：买卖IC网 > PDF目录18780 > MAX7042ATJ+ (Maxim Integrated)IC RCVR RF LP FSK 32-TQFN-EP PDF资料下载
参数资料
| 型号： | MAX7042ATJ+ |
| 厂商： | Maxim Integrated |
| 文件页数： | 11/17页 |
| 文件大小： | 0K |
| 描述： | IC RCVR RF LP FSK 32-TQFN-EP |
| 其它有关文件： | Automotive Product Guide |
| 产品培训模块： | Lead (SnPb) Finish for COTS Obsolescence Mitigation Program |
| 标准包装： | 60 |
| 频率： | 308MHz，315MHz，418MHz，433.92MHz |
| 灵敏度： | -110dBm |
| 数据传输率 - 最大： | 66 kbps |
| 调制或协议： | FSK |
| 应用： | 门禁控制，AMR，ISM，RKE，TPM |
| 电流 - 接收： | 7.2mA |
| 数据接口： | PCB，表面贴装 |
| 天线连接器： | PCB，表面贴装 |
| 电源电压： | 2.4 ~ 3.6 V & 4.5 ~ 5.5 V |
| 工作温度： | -40°C ~ 125°C |
| 封装/外壳： | 32-WFQFN 裸露焊盘 |
| 供应商设备封装： | 32-TQFN-EP（5x5） |
| 包装： | 管件 |
| 产品目录页面： | 1424 (CN2011-ZH PDF) |
308MHz/315MHz/418MHz/433.92MHz
Low-Power, FSK Superheterodyne Receiver
TO FSK
BASEBAND FILTER
AND DATA SLICER
IF
LIMITING
AMPS
PHASE
DETECTOR
CHARGE
PUMP
LOOP
FILTER
10.7MHz VCO
2.1mV/kHz
Figure 1. FSK Demodulator PLL Block Diagram
Mixer
A unique feature of the MAX7042 is the integrated image
rejection of the mixer. This device is designed to elimi-
nate the need for a costly front-end SAW filter in many
applications. The advantages of not using a SAW filter
are increased sensitivity, simplified antenna matching,
less board space, and lower cost.
The mixer cell is a pair of double-balanced mixers that
perform an IQ downconversion of the RF input to the
10.7MHz intermediate frequency (IF) with low-side
injection (i.e., f LO = f RF - f IF ). The image-rejection circuit
then combines these signals to achieve a typical image
rejection of approximately 45dB. Low-side injection is
required as high-side injection is not possible due to
the on-chip image rejection. The IF output is driven by
a source follower, biased to create a driving imped-
ance of 330 ? to interface with an off-chip 330 ? ceram-
ic IF filter. Note that MIXIN+ and MIXIN- are functionally
identical.
Phase-Locked Loop (PLL)
The PLL block contains a phase detector, charge
pump/integrated loop filter, voltage-controlled oscillator
(VCO), asynchronous 32x frequency divider, and crys-
tal oscillator. This PLL does not require any external
components. The relationship between the RF, IF, and
crystal reference frequencies is given by:
Intermediate Frequency (IF)
The IF section presents a differential 330 ? load to pro-
vide matching for the off-chip ceramic filter. The inter-
nal six AC-coupled limiting amplifiers produce an
overall gain of approximately 65dB. The limiting ampli-
fiers have a bandpass-filter-type response centered
near the 10.7MHz IF frequency with a 3dB bandwidth
of approximately 10MHz. The limiter output is fed into a
PLL to demodulate the IF, producing a baseband volt-
age with a demodulation slope of 2.1mV/kHz. The RSSI
circuit produces a DC output proportional to the log of
the IF signal level with a slope of approximately
16mV/dB.
FSK Demodulator
The FSK demodulator uses an integrated 10.7MHz PLL
that tracks the input RF modulation and determines the
difference between frequencies as logic ones and
zeros. The PLL is illustrated in Figure 1. The input to the
PLL comes from the output of the IF limiting amplifiers.
The PLL control voltage responds to changes in the fre-
quency of the input signal with a nominal gain of
2.1mV/kHz. For example, an FSK peak-to-peak devia-
tion of 50kHz generates a 105mV P-P signal on the con-
trol line. This control line is then filtered and sliced by
the FSK baseband circuitry.
The FSK demodulator PLL requires calibration to over-
come variations in process, voltage, and temperature.
f XTAL =
(f RF ? f IF )
32
The maximum calibration time is 120μs, which is includ-
ed in the startup time. Recalibration is necessary after a
significant change in temperature or supply voltage.
For additional information on proper crystal selection,
see the Crystal Oscillator and Frequency Tolerance
sections.
Calibration occurs automatically each time the
MAX7042 is powered up. Drive EN low and then high to
force a recalibration. EN must be driven from low to
high after the MAX7042 supply voltage is stable for
proper initial FSK calibration.
______________________________________________________________________________________
11
相关PDF资料 |
PDF描述 |
|---|---|
| MAX2112CTI+ | IC TUNER DIR-CONV DVB-S2 28TQFN |
| 0639016101 | CONDUCTOR PUNCH |
| D2VW-5-2MS | MINIATURE BASIC SWITCH |
| 6492 | OSCILLOSCOPE PROBE 350 MHZ X10 |
| FXO-HC736R-60 | OSC 60.00 MHZ 3.3V SMD |
相关代理商/技术参数 |
参数描述 |
|---|---|
| MAX7042ATJ+ | 功能描述:射频接收器 308/315/418/433.9MHz FSK Superhtrdyne Rec RoHS:否 制造商:Skyworks Solutions, Inc. 类型:GPS Receiver 封装 / 箱体:QFN-24 工作频率:4.092 MHz 工作电源电压:3.3 V 封装:Reel |
| MAX7042ATJ+T | 功能描述:射频接收器 308/315/418/433.9MHz FSK Superhtrdyne Rec RoHS:否 制造商:Skyworks Solutions, Inc. 类型:GPS Receiver 封装 / 箱体:QFN-24 工作频率:4.092 MHz 工作电源电压:3.3 V 封装:Reel |
| MAX7042ATJ-T | 制造商:Maxim Integrated Products 功能描述:308MHZ/315MHZ/418MHZ/434MHZ LOW-POWER, FSK SU - Tape and Reel |
| MAX7042EVKIT-315 | 功能描述:射频开发工具 RoHS:否 制造商:Taiyo Yuden 产品:Wireless Modules 类型:Wireless Audio 工具用于评估:WYSAAVDX7 频率: 工作电源电压:3.4 V to 5.5 V |
| MAX7042EVKIT-315+ | 功能描述:射频开发工具 MAX7042 Eval Kit RoHS:否 制造商:Taiyo Yuden 产品:Wireless Modules 类型:Wireless Audio 工具用于评估:WYSAAVDX7 频率: 工作电源电压:3.4 V to 5.5 V |
发布紧急采购，3分钟左右您将得到回复。