- 您现在的位置：买卖IC网 > PDF目录1848 > MAX8707ETL+ (Maxim Integrated Products)IC CNTRLR MULTIPHASE 40TQFN PDF资料下载
参数资料
| 型号： | MAX8707ETL+ |
| 厂商： | Maxim Integrated Products |
| 文件页数： | 19/37页 |
| 文件大小： | 0K |
| 描述： | IC CNTRLR MULTIPHASE 40TQFN |
| 产品培训模块： | Lead (SnPb) Finish for COTS Obsolescence Mitigation Program |
| 标准包装： | 50 |
| 应用： | 控制器，AMD Hammer |
| 输入电压： | 4.5 V ~ 5.5 V |
| 输出数： | 4 |
| 输出电压： | 0.8 V ~ 1.55 V |
| 工作温度： | 0°C ~ 85°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 40-WFQFN 裸露焊盘 |
| 供应商设备封装： | 40-TQFN-EP（6x6） |
| 包装： | 管件 |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页当前第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页第37页
Multiphase, Fixed-Frequency Controller for
AMD Hammer CPU Core Power Supplies
Transient-Droop Amplifier
The MAX8707 controller includes a transient-droop
transconductance amplifier to handle the instantaneous
load transients typical of CPU applications. The tran-
Table 1. Component Selection for
Standard Multiphase Applications
MAX8707
sient-droop amplifier sets the correct voltage-positioning
slope during a load transient, complimenting the slower
steady-state voltage-positioning amplifier. The current-
sense inputs differentially sense the voltage across the
CSP_ and CSN_ current-sense element (inductor ’ s DCR
or current-sense resistor). The transconductance amplifi-
er ’ s output connects to the regulator ’ s transient-response
input (TRC), so the resistance between TRC and the ref-
erence voltage (REF) determines the transient voltage-
positioning gain as defined in the Multiphase,
Fixed-Frequency Design Procedure section.
If voltage positioning is not required, R DROOP is
defined by the maximum output-voltage sag with the
worst-case transient load ( ? V OUT / ? I OUT ) and is sub-
ject to stability requirements. TRC is high impedance in
shutdown.
Differential Remote Sense
The multiphase controllers include differential, remote-
sense inputs to eliminate the effects of voltage drops
down the PC board traces and through the processor ’ s
power pins.
The MAX8707 GNDS amplifier adds an offset directly to
the target voltage, adjusting the output voltage to coun-
teract the voltage drop in the ground path. Connect the
feedback sense (FBS), voltage-positioning resistor
(R VPS ), and ground-sense (GNDS) inputs directly to the
processor ’ s core supply remote- sense outputs.
Integrator Amplifier
An integrator amplifier forces the DC average of the
VPS voltage to equal the target voltage. This transcon-
ductance amplifier integrates the feedback voltage and
DESIGNATION
Input Voltage Range
VID Output Voltage (D4 – D0)
SUSV Suspend Voltage
(SUS = High)
Maximum Load Current
Number of Phases ( η TOTAL )
Inductor (Per Phase)
Switching Frequency
(Per Phase)
High-Side MOSFET
(N H , Per Phase)
Low-Side MOSFET
(N L , Per Phase)
Total Input Capacitance (C IN )
Total Output Capacitance
(C OUT )
Current-Sense Resistor
(R SENSE )
AMD HAMMER
COMPONENTS
Circuit of Figure 1
7V to 24V
1.50V (D4 – D0 = 00010)
0.80V
80A
4 phases
(1) MAX8705 + (2) MAX8702
0.56μH, 1.6m ?
Panasonic ETQP4LR56WFC
300kHz (OSC = REF)
Siliconix (1) Si7892DP
Siliconix (2) Si7356DP
(8) 10μF, 25V
TDK C3225X7R1E106M
Taiyo Yuden
TMK325BJ106MN
(6) 330μF, 2.5V, 9m ?
Sanyo 2R5TPE330M9
1.0m ?
Panasonic ERJM1WTJ1M0U
provides a fine adjustment to the regulation voltage
( Figure 2), allowing accurate DC output-voltage regula-
tion regardless of the output ripple voltage. The integra-
tor amplifier has the ability to shift the output voltage by
± 100mV (typ). The differential input voltage range is at
least ± 60mV total, including DC offset and AC ripple.
The integration time constant can be set easily with an
external compensation capacitor at the CCV pin. Use a
470pF x (4 / η PH ) or greater ceramic capacitor.
The MAX8707 disables the integrator by connecting the
amplifier inputs together at the beginning of all transi-
tions done in pulse-skipping mode (SKIP = high). The
integrator remains disabled until 20μs after the transition
is completed (the internal target settles) and the output
is in regulation (edge detected on the error comparator).
When voltage positioning is disabled (VPS = FBS), the
transient droop must be less than the ± 80mV minimum
adjustment range of the integrator amplifier to guaran-
tee proper DC output-voltage accuracy.
Offset Amplifier
The multiphase controllers include a fifth amplifier used
to add small offsets to the voltage-positioned load line.
The offset amplifier sums directly with the target volt-
age, making the offset gain independent of the DAC
code. This amplifier has the ability to offset the output
by ± 100mV. The offset is adjusted using resistive volt-
age-dividers at the OFS input. For inputs from 0 to 0.8V,
the offset amplifier adds a negative offset to the output
that is equal to 1/8th the voltage appearing at the OFS
input (V OFFSET = -0.125 x V OFS ). For inputs from 1.2V
______________________________________________________________________________________
19
相关PDF资料 |
PDF描述 |
|---|---|
| MAX8709BETI+T | IC CNTRLR CCFL HI EFF 28-TQFN |
| MAX8719ETA+T | IC REG LINEAR LP HV 8-TDFN |
| MAX871EUK+TG002 | IC VOLTAGE INV SWCAP SOT23-5 |
| MAX8720ETX+ | IC CNTRL VID STP DWN 36-TQFN |
| MAX8722CEEG+ | IC CCFL BACKLIGHT CTRL 24-QSOP |
相关代理商/技术参数 |
参数描述 |
|---|---|
| MAX8707ETL+ | 功能描述:DC/DC 开关控制器 Multiphase Fixed Frequency Controller RoHS:否 制造商:Texas Instruments 输入电压:6 V to 100 V 开关频率: 输出电压:1.215 V to 80 V 输出电流:3.5 A 输出端数量:1 最大工作温度:+ 125 C 安装风格: 封装 / 箱体:CPAK |
| MAX8707ETL+T | 功能描述:DC/DC 开关控制器 Multiphase Fixed Frequency Controller RoHS:否 制造商:Texas Instruments 输入电压:6 V to 100 V 开关频率: 输出电压:1.215 V to 80 V 输出电流:3.5 A 输出端数量:1 最大工作温度:+ 125 C 安装风格: 封装 / 箱体:CPAK |
| MAX8707ETL-T | 功能描述:DC/DC 开关控制器 RoHS:否 制造商:Texas Instruments 输入电压:6 V to 100 V 开关频率: 输出电压:1.215 V to 80 V 输出电流:3.5 A 输出端数量:1 最大工作温度:+ 125 C 安装风格: 封装 / 箱体:CPAK |
| MAX8708ETJ | 制造商:Maxim Integrated Products 功能描述:AMD CPU CORE SUPPLY - Rail/Tube |
| MAX8708ETJ-T | 制造商:Maxim Integrated Products 功能描述:AMD CPU CORE SUPPLY - Tape and Reel |
发布紧急采购，3分钟左右您将得到回复。