- 您现在的位置：买卖IC网 > PDF目录19707 > MC34652EFR2 (Freescale Semiconductor)IC CTRLR HOT SWAP NEG V 16-SOIC PDF资料下载
参数资料
| 型号： | MC34652EFR2 |
| 厂商： | Freescale Semiconductor |
| 文件页数： | 18/26页 |
| 文件大小： | 1802K |
| 描述： | IC CTRLR HOT SWAP NEG V 16-SOIC |
| 标准包装： | 2,500 |
| 类型： | 热交换开关 |
| 应用： | 通用 |
| 内部开关： | 是 |
| 电流限制： | 2A |
| 电源电压： | 15 V ~ 80 V |
| 工作温度： | -40°C ~ 85°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 16-SOIC（0.154"，3.90mm 宽） |
| 供应商设备封装： | 16-SOIC N |
| 包装： | 带卷 (TR) |
Analog Integrated Circuit Device Data
18
Freescale Semiconductor
34652
TYPICAL APPLICATIONS
rchived by Freescale Semiconductor, Inc., 2008
TYPICAL APPLICATIONS
The 34652 resides on the plug-in board (see Figures 18
and 19
), allowing the board to be safely inserted or removed
without damaging electrical equipment. The 34652 can be
operated with no external components other than the power
good output signal pull-up resistor if the default mode was
selected for all the programmable features. This is one of the
great advantages of the 34652: it operates with minimal user
interface and minimal external component count and still
offers complete hot swapping functionality with all the
necessary protection features, from undervoltage/
overvoltage detection, to current limiting, to short circuit
protection and power good output signaling. The default
values were chosen to be sufficient for many standard
applications.
Figure 18
is a typical application diagram depicting the
default mode and using the power good output signal pull-up
resistor. Refer to the static and dynamic electrical
characteristics tables on pages 6
through 9
for the various
default values.
Figure 18. Typical Application Diagram with Default
Settings and Minimal External Components
The 34652 can be also programmed for different values of
the Overcurrent Limit, the Charging Current Limit, the Start-
Up and Retry Delay Timer, and the UV / OV detection
thresholds using external components connected to the
device. Figure 19
shows the 34652 with the required external
components that allow access to all programmable features
in the device.
Figure 19. Typical Application Diagram with External
Components Necessary to Program the Device
UNDERVOLTAGE AND OVERVOLTAGE
DETECTION
The UV and OV pins are used to monitor the input voltage
to ensure that it is within the operating range and that there
are no overvoltage or undervoltage conditions, and to quickly
turn off the Power MOSFET if there are. The pins are
connected to internal comparators that compare the voltages
at the UV and OV pins with a reference voltage. The UV and
OV pins can be left unconnected for the default threshold
values of their trip point or the user can set the threshold
values externally with a simple voltage divider using resistors
between VPWR and VIN (resistors R
1
, R
2
, and R
3
in
Figure 19
). For the default mode, the 34652 is equipped with
an internal resistor divider that acts the same as the external
one. The typical default values of 37 V for the UV turn-off
threshold (falling threshold) and 78 V for the OV turn-off
threshold (rising threshold) will give a typical operating range
of 38 V to 76 V. This range is suitable for telecom industry
standards.
When the device passes the UVLO threshold, it checks if
there is any external resistor divider connected to the OV and
UV pins. If there is, it determines the value of the UV/OV
thresholds accordingly. If there is not, it defaults to the
internal resistor divider. It then uses the UV/OV detection
circuits to check the input supply levels before turning on the
Power MOSFET during the Start-Up Timer delay and
thereafter. As long as the voltage on the UV pin is above its
falling threshold and the voltage on the OV pin is below its
rising threshold, the supply is within operating range and the
Power MOSFET is allowed to turn on and stay on. If the UV
pin drops below its falling threshold or the OV pin rises above
its rising threshold, then one of the start-up conditions (refer
to page
12
for list) is violated and the Power MOSFET turns
off, the power good signals deactivate, and a new start-up
VPWR
UV
VIN
TIMER ICHG ILIM
VOUT
(2)
PG
PG
33652
(4)
GND
-48 V
DC/DC
Converter
Application
Dependent
Enable/Enable
C
LOAD
44 k?/DIV>
PLUG-IN CARD
DISABLE
OV
VPWR
UV
VIN
TIMER ICHG ILIM
VOUT
(2)
PG
33652
(4)
GND
-48 V
DC/DC
Converter
Application
Dependent
Enable/Enable
C
LOAD
44 k?/DIV>
PLUG-IN CARD
DISABLE
OV
R
2
R
1
R
3
PG
相关PDF资料 |
PDF描述 |
|---|---|
| CR2450 | BATTERY LITHIUM COIN 3V CELL |
| VI-243-CY-F4 | CONVERTER MOD DC/DC 24V 50W |
| V48A3V3E264BG3 | CONVERTER MOD DC/DC 3.3V 264W |
| VI-243-CY-F3 | CONVERTER MOD DC/DC 24V 50W |
| PAF600F280-28/T | DC-DC CONVERTR 28VDC 602W 21.5A |
相关代理商/技术参数 |
参数描述 |
|---|---|
| MC34653 | 制造商:SPC Multicomp 功能描述:HEADER R/A SQ PIN 2.54MM 10WAY 制造商:SPC Multicomp 功能描述:HEADER, R/A, SQ PIN, 2.54MM, 10WAY 制造商:SPC Multicomp 功能描述:WIRE-BOARD CONN, HEADER, 10POS, 2.54MM; Connector Type:Wire to Board; Series:2217; Contact Termination:Through Hole Right Angle; Gender:Header; No. of Contacts:10; No. of Rows:1; Pitch Spacing:2.54mm; Contact Plating:Tin ;RoHS Compliant: Yes |
| MC34653EF | 功能描述:热插拔功率分布 1A 8-LD NVHS RoHS:否 制造商:Texas Instruments 产品:Controllers & Switches 电流限制: 电源电压-最大:7 V 电源电压-最小:- 0.3 V 工作温度范围: 功率耗散: 安装风格:SMD/SMT 封装 / 箱体:MSOP-8 封装:Tube |
| MC34653EFR2 | 功能描述:热插拔功率分布 1A 8-LD NVHS RoHS:否 制造商:Texas Instruments 产品:Controllers & Switches 电流限制: 电源电压-最大:7 V 电源电压-最小:- 0.3 V 工作温度范围: 功率耗散: 安装风格:SMD/SMT 封装 / 箱体:MSOP-8 封装:Tube |
| MC34655 | 制造商:SPC Multicomp 功能描述:HEADER SQUARE PIN 2.54MM 5WAY 制造商:SPC Multicomp 功能描述:HEADER, SQUARE PIN, 2.54MM, 5WAY 制造商:SPC Multicomp 功能描述:WIRE-BOARD CONNECTOR HEADER 5POS, 2.54MM; Connector Type:Wire to Board; Series:2217; Contact Termination:Through Hole Vertical; Gender:Header; No. of Contacts:5; No. of Rows:1; Pitch Spacing:2.54mm; Contact Plating:Tin ;RoHS Compliant: Yes |
| MC34657 | 制造商:SPC Multicomp 功能描述:HEADER VERTICAL 2WAY 制造商:SPC Multicomp 功能描述:HEADER, VERTICAL, 2WAY 制造商:SPC Multicomp 功能描述:WIRE-BOARD CONNECTOR, RCPT, 2POS, 4.2MM; Series:2266(5566)S; Pitch Spacing:4.2mm; Contact Termination:Through Hole Vertical; No. of Contacts:2; No. of Rows:2; Connector Mounting:PCB; Gender:Receptacle; Contact Material:Copper Alloy ;RoHS Compliant: Yes |
发布紧急采购，3分钟左右您将得到回复。