- 您现在的位置：买卖IC网 > PDF目录80397 > MC68HSC05C8CP (FREESCALE SEMICONDUCTOR INC) 8-BIT, MROM, 4.1 MHz, MICROCONTROLLER, PDIP40 PDF资料下载
参数资料
| 型号： | MC68HSC05C8CP |
| 厂商： | FREESCALE SEMICONDUCTOR INC |
| 元件分类： | 微控制器/微处理器 |
| 英文描述： | 8-BIT, MROM, 4.1 MHz, MICROCONTROLLER, PDIP40 |
| 封装： | PLASTIC, DIP-40 |
| 文件页数： | 44/116页 |
| 文件大小： | 781K |
| 代理商： | MC68HSC05C8CP |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页第37页第38页第39页第40页第41页第42页第43页当前第44页第45页第46页第47页第48页第49页第50页第51页第52页第53页第54页第55页第56页第57页第58页第59页第60页第61页第62页第63页第64页第65页第66页第67页第68页第69页第70页第71页第72页第73页第74页第75页第76页第77页第78页第79页第80页第81页第82页第83页第84页第85页第86页第87页第88页第89页第90页第91页第92页第93页第94页第95页第96页第97页第98页第99页第100页第101页第102页第103页第104页第105页第106页第107页第108页第109页第110页第111页第112页第113页第114页第115页第116页
MC68HC05C8A MC68HCL05C8A MC68HSC05C8A Data Sheet, Rev. 5.1
Freescale Semiconductor
33
Chapter 5
Resets
5.1 Introduction
The microcontroller unit (MCU) can be reset three ways:
1.
Initial power-on reset function
2.
Active low input to the RESET pin
3.
Computer operating properly (COP) reset
5.2 Power-On Reset (POR)
An internal reset is generated on power-up to allow the internal clock generator to stabilize. The power-on
reset is strictly for power turn-on conditions and should not be used to detect a drop in the power supply
voltage. There is a 4064 internal processor clock cycle (tCYC) oscillator stabilization delay after the
oscillator becomes active. If the RESET pin is low after the end of this 4064-cycle delay, the MCU will
remain in the reset condition until RESET goes high.
For additional information, refer to Figure 13-8. Power-On Reset Timing Diagram.
5.3 RESET Pin
The MCU is reset when a logic 0 is applied to the RESET input for a period of one and one-half machine
cycles (tRL).
5.4 Computer Operating Properly (COP) Reset
This device includes a watchdog COP feature as a mask option. The COP is implemented with an 18-bit
ripple counter. This provides a timeout period of 64 milliseconds at a bus rate of 2 MHz. If the COP should
time out, a system reset will occur and the device will be re-initialized in the same fashion as a power-on
reset (POR) or external reset.
5.4.1 Resetting the COP
Preventing a COP reset is done by writing a logic 0 to the COPC bit. This action will reset the counter and
begin the timeout period again. The COPC bit is bit 0 of address $1FF0. A read of address $1FF0 will
result in the user defined ROM data at that location.
5.4.2 COP During Wait Mode
The COP will continue to operate normally during wait mode. The software should pull the device out of
wait mode periodically and reset the COP by writing to the COPC bit to prevent a COP reset.
相关PDF资料 |
PDF描述 |
|---|---|
| MC68HC11A1VFU2 | 8-BIT, MROM, 2 MHz, MICROCONTROLLER, PQFP64 |
| MC68HSC705C8ACFB | 8-BIT, OTPROM, 4 MHz, MICROCONTROLLER, PQFP44 |
| MC908GZ48VFJ | 8-BIT, FLASH, 8 MHz, MICROCONTROLLER, PQFP32 |
| MC9S12C96CFA25 | 16-BIT, FLASH, 25 MHz, MICROCONTROLLER, PQFP48 |
| MC9S12GC16PVFA25 | 16-BIT, FLASH, 25 MHz, MICROCONTROLLER, PQFP48 |
相关代理商/技术参数 |
参数描述 |
|---|---|
| MC68HSC705C8ACFB | 制造商:Rochester Electronics LLC 功能描述:8 BIT MCU, 304 BYTES RAM - Bulk |
| MC68HSC705C8ACP | 制造商:Rochester Electronics LLC 功能描述: 制造商:Freescale Semiconductor 功能描述: |
| MC68HSC705C8ACS | 制造商:Rochester Electronics LLC 功能描述:- Bulk |
| MC68HSC705J1ACDW | 制造商:Rochester Electronics LLC 功能描述:- Bulk |
| MC68HSC705J1ACP | 制造商:Rochester Electronics LLC 功能描述:8 BIT MCU, 64 BYTES RAM - Bulk |
发布紧急采购，3分钟左右您将得到回复。