- 您现在的位置：买卖IC网 > PDF目录9442 > MCP47DA1T-A0E/OT (Microchip Technology)IC DGTL POT 30K 1CH SOT-23-6 PDF资料下载
参数资料
| 型号： | MCP47DA1T-A0E/OT |
| 厂商： | Microchip Technology |
| 文件页数： | 18/54页 |
| 文件大小： | 0K |
| 描述： | IC DGTL POT 30K 1CH SOT-23-6 |
| 标准包装： | 1 |
| 接片： | 65 |
| 电阻（欧姆）： | 30k |
| 电路数： | 1 |
| 温度系数： | 标准值 150 ppm/°C |
| 存储器类型： | 易失 |
| 接口： | I²C |
| 电源电压： | 1.8 V ~ 5.5 V，2.7 V ~ 5.5 V |
| 工作温度： | -40°C ~ 125°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | SOT-23-6 |
| 供应商设备封装： | SOT-23-6 |
| 包装： | 标准包装 |
| 其它名称： | MCP47DA1T-A0E/OTDKR |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页当前第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页第37页第38页第39页第40页第41页第42页第43页第44页第45页第46页第47页第48页第49页第50页第51页第52页第53页第54页
Micrel, Inc.
KSZ8041NL/RNL
September 2010
25
M9999-090910-1.4
Receive Data Valid (RXDV)
RXDV is driven by the PHY to indicate that the PHY is presenting recovered and decoded nibbles on RXD[3:0].
In 10Mbps mode, RXDV is asserted with the first nibble of the SFD (Start of Frame Delimiter), “5D”, and remains
asserted until the end of the frame.
In 100Mbps mode, RXDV is asserted from the first nibble of the preamble to the last nibble of the frame.
RXDV transitions synchronously with respect to RXC.
Receive Data [3:0] (RXD[3:0])
RXD[3:0] transitions synchronously with respect to RXC. For each clock period in which RXDV is asserted, RXD[3:0]
transfers a nibble of recovered data from the PHY.
Receive Error (RXER)
RXER is asserted for one or more RXC periods to indicate that a Symbol Error (e.g. a coding error that a PHY is capable
of detecting, and that may otherwise be undetectable by the MAC sub-layer) was detected somewhere in the frame
presently being transferred from the PHY.
RXER transitions synchronously with respect to RXC. While RXDV is de-asserted, RXER has no effect on the MAC.
Carrier Sense (CRS)
CRS is asserted and de-asserted as follows:
In 10Mbps mode, CRS assertion is based on the reception of valid preambles. CRS de-assertion is based on the
reception of an end-of-frame (EOF) marker.
In 100Mbps mode, CRS is asserted when a start-of-stream delimiter, or /J/K symbol pair is detected. CRS is de-
asserted when an end-of-stream delimiter, or /T/R symbol pair is detected. Additionally, the PMA layer de-asserts
CRS if IDLE symbols are received without /T/R.
Collision (COL)
COL is asserted in half-duplex mode whenever the transmitter and receiver are simultaneously active on the line. This is
used to inform the MAC that a collision has occurred during its transmission to the PHY.
COL transitions asynchronously with respect to TXC and RXC.
Reduced MII (RMII) Data Interface
The Reduced Media Independent Interface (RMII) specifies a low pin count Media Independent Interface (MII). It provides
a common interface between physical layer and MAC layer devices, and has the following key characteristics:
Supports 10Mbps and 100Mbps data rates.
Uses a 50MHz reference clock.
Provides independent 2-bit wide (di-bit) transmit and receive data paths.
Contains two distinct groups of signals: one for transmission and the other for reception.
The KSZ8041NL is configured in RMII mode after it is power-up or reset with the following:
A 50MHz reference clock connected to REFCLK (pin 9).
CONFIG[2:0] (pins 18, 29, 28) set to ‘001’.
The KSZ8041RNL is configured in RMII mode and outputs the 50MHz RMII reference clock to the MAC on REF_CLK (pin
19) after it is power-up or reset with the following:
A 25MHz crystal connected to XI (pin 9) and XO (pin 8), or a 25MHz reference clock connected to XI (pin 9).
CONFIG[2:0] (pins 18, 29, 28) set to ‘001’.
In RMII mode, unused MII signals, TXD[3:2] (pins 27, 26), are tied to ground.
相关PDF资料 |
PDF描述 |
|---|---|
| MCP4531T-103E/MF | IC DGTL POT 10K 128TAPS 8-DFN |
| MCP40D19T-503E/LT | IC DGTL POT 50K 128TAPS SC70-5 |
| MS27473P16A6P | CONN PLUG 6POS STRAIGHT W/PINS |
| MS27468P13A4S | CONN RCPT 4POS JAM NUT W/SCKT |
| MS27656T23A35PA | CONN RCPT 100POS WALL MNT W/PINS |
相关代理商/技术参数 |
参数描述 |
|---|---|
| MCP47DA1T-A1E/OT | 功能描述:数模转换器- DAC 6-bit windowed DAC voltage margining RoHS:否 制造商:Texas Instruments 转换器数量:1 DAC 输出端数量:1 转换速率:2 MSPs 分辨率:16 bit 接口类型:QSPI, SPI, Serial (3-Wire, Microwire) 稳定时间:1 us 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:SOIC-14 封装:Tube |
| MCP4801-E/MC | 功能描述:数模转换器- DAC Sngl 8-bit DAC w/SPI interface intnl Vref RoHS:否 制造商:Texas Instruments 转换器数量:1 DAC 输出端数量:1 转换速率:2 MSPs 分辨率:16 bit 接口类型:QSPI, SPI, Serial (3-Wire, Microwire) 稳定时间:1 us 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:SOIC-14 封装:Tube |
| MCP4801-E/MS | 功能描述:数模转换器- DAC Sngl 8-bit DAC w/SPI interface intnl Vref RoHS:否 制造商:Texas Instruments 转换器数量:1 DAC 输出端数量:1 转换速率:2 MSPs 分辨率:16 bit 接口类型:QSPI, SPI, Serial (3-Wire, Microwire) 稳定时间:1 us 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:SOIC-14 封装:Tube |
| MCP4801-E/P | 功能描述:数模转换器- DAC Sngl 8-bit DAC w/SPI interface intnl Vref RoHS:否 制造商:Texas Instruments 转换器数量:1 DAC 输出端数量:1 转换速率:2 MSPs 分辨率:16 bit 接口类型:QSPI, SPI, Serial (3-Wire, Microwire) 稳定时间:1 us 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:SOIC-14 封装:Tube |
| MCP4801-E/SN | 功能描述:数模转换器- DAC Sngl 8-bit DAC w/SPI interface intnl Vref RoHS:否 制造商:Texas Instruments 转换器数量:1 DAC 输出端数量:1 转换速率:2 MSPs 分辨率:16 bit 接口类型:QSPI, SPI, Serial (3-Wire, Microwire) 稳定时间:1 us 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:SOIC-14 封装:Tube |
发布紧急采购，3分钟左右您将得到回复。