- 您现在的位置：买卖IC网 > PDF目录14847 > MIC4724YMME (Micrel Inc)IC REG BUCK ADJ 3A 10MSOP PDF资料下载
参数资料
| 型号： | MIC4724YMME |
| 厂商： | Micrel Inc |
| 文件页数： | 11/19页 |
| 文件大小： | 0K |
| 描述： | IC REG BUCK ADJ 3A 10MSOP |
| 标准包装： | 100 |
| 类型： | 降压（降压） |
| 输出类型： | 可调式 |
| 输出数： | 1 |
| 输出电压： | 可调至 1V |
| 输入电压： | 3 V ~ 6 V |
| 频率 - 开关： | 2MHz |
| 电流 - 输出： | 3A |
| 同步整流器： | 无 |
| 工作温度： | -40°C ~ 125°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 10-TFSOP，10-MSOP（0.118"，3.00mm 宽）裸露焊盘 |
| 包装： | 管件 |
| 供应商设备封装： | 10-MSOP 裸露焊盘 |
| 产品目录页面： | 1093 (CN2011-ZH PDF) |
| 其它名称： | 576-3120-5 |
Micrel, Inc.
losses on the Schottky diode.
Inductor conduction losses (P L ) can be calculated by
multiplying the DC resistance (DCR) times the square of
the output current;
P L = DCR × I OUT 2
Also, be aware that there are additional core losses
associated with switching current in an inductor. Since
most inductor manufacturers do not give data on the
type of material used, approximating core losses
becomes very difficult, so verify inductor temperature
rise.
Switching losses occur twice each cycle, when the
switch turns on and when the switch turns off. This is
caused by a non-ideal world where switching transitions
are not instantaneous, and neither are currents. Figure 6
demonstrates how switching losses due to the
transitions dissipate power in the switch.
MIC4724
Figure 6. Switching Transition Losses
Normally, when the switch is on, the voltage across the
switch is low (virtually zero) and the current through the
switch is high. This equates to low power dissipation.
When the switch is off, voltage across the switch is high
and the current is zero, again with power dissipation
being low. During the transitions, the voltage across the
switch (V S-D ) and the current through the switch (I S-D ) are
at middle, causing the transition to be the highest
instantaneous power point. During continuous mode,
these losses are the highest. Also, with higher load
currents, these losses are higher. For discontinuous
operation, the transition losses only occur during the “off”
transition since the “on” transitions there is no current
flow through the inductor.
June 2008
11
M9999-062408-A
相关PDF资料 |
PDF描述 |
|---|---|
| MIC4684YM | IC REG BUCK ADJ 2A 8SOIC |
| LGU2F221MELA | CAP ALUM 220UF 315V 20% SNAP |
| LM2575-12YN | IC REG BUCK 12V 1A 16DIP |
| LM2576-12WU | IC REG BUCK 12V 3A TO263-5 |
| PM2110-6R8M | INDUCTOR TOROID 6.8UH 20% SMD |
相关代理商/技术参数 |
参数描述 |
|---|---|
| MIC4724YMME TR | 功能描述:直流/直流开关调节器 3A 2MHz Buck Regulator in Epad MSOP-10 RoHS:否 制造商:International Rectifier 最大输入电压:21 V 开关频率:1.5 MHz 输出电压:0.5 V to 0.86 V 输出电流:4 A 输出端数量: 最大工作温度: 安装风格:SMD/SMT 封装 / 箱体:PQFN 4 x 5 |
| MIC47300 | 制造商:MICREL 制造商全称:Micrel Semiconductor 功能描述:3A, Low Voltage, Adjustable LDO Regulator with Dual Input Supply |
| MIC47300WD | 制造商:Micrel 功能描述:Micrel MIC47300WD, Low-Dropout (LDO) Voltage Regulators |
| MIC47300WD TR | 功能描述:低压差稳压器 - LDO 3A Low Voltage, ADJ. High Bandwidth LDO Regulator with Dual Input Supplies RoHS:否 制造商:Texas Instruments 最大输入电压:36 V 输出电压:1.4 V to 20.5 V 回动电压（最大值）:307 mV 输出电流:1 A 负载调节:0.3 % 输出端数量: 输出类型:Fixed 最大工作温度:+ 125 C 安装风格:SMD/SMT 封装 / 箱体:VQFN-20 |
| MIC47300WD-TR | 功能描述:Linear Voltage Regulator IC Positive Adjustable 1 Output Adj to 0.9V 3A TO-252-5 制造商:microchip technology 系列:- 包装:剪切带（CT） 零件状态:停产 稳压器拓扑:正，可调式 电压 - 输出:可调至 0.9V 电流 - 输出:3A 电压 - 跌落（典型值）:0.23V @ 3A 稳压器数:1 电压 - 输入:1.4 V ~ 6.5 V 电流 - 限制（最小值）:- 工作温度:-40°C ~ 125°C 安装类型:表面贴装 封装/外壳:TO-252-6，DPak（5 引线 + 接片） 供应商器件封装:TO-252-5 标准包装:1 |
发布紧急采购，3分钟左右您将得到回复。