参数资料
型号: MIC4724YMME
厂商: Micrel Inc
文件页数: 9/19页
文件大小: 0K
描述: IC REG BUCK ADJ 3A 10MSOP
标准包装: 100
类型: 降压(降压)
输出类型: 可调式
输出数: 1
输出电压: 可调至 1V
输入电压: 3 V ~ 6 V
频率 - 开关: 2MHz
电流 - 输出: 3A
同步整流器:
工作温度: -40°C ~ 125°C
安装类型: 表面贴装
封装/外壳: 10-TFSOP,10-MSOP(0.118",3.00mm 宽)裸露焊盘
包装: 管件
供应商设备封装: 10-MSOP 裸露焊盘
产品目录页面: 1093 (CN2011-ZH PDF)
其它名称: 576-3120-5
V OUT 2 ?
? V OUT ? ?
? ?
V IN ?
I OUT =
V OUT
T ON =
Micrel, Inc.
Application Information
The MIC4724 is a 3A PWM non-synchronous buck
regulator. By switching an input voltage supply, and
filtering the switched voltage through an Inductor and
capacitor, a regulated DC voltage is obtained. Figure 1
shows a simplified example of a non-synchronous buck
converter.
Figure 1. Example of non-synchronous buck converter
For a non-synchronous buck converter, there are two
modes of operation; continuous and discontinuous.
Continuous or discontinuous refer to the inductor
current. If current is continuously flowing through the
inductor throughout the switching cycle, it is in
continuous operation. If the inductor current drops to
zero during the off time, it is in discontinuous operation.
Critically continuous is the point where any decrease in
output current will cause it to enter discontinuous
operation. The critically continuous load current can be
calculated as follows;
?
?
2.0MHz × 2 × L
Continuous or discontinuous operation determines how
we calculate peak inductor current.
MIC4724
switch is turned on, current flows from the input supply
through the inductor and to the output. The inductor
current is:
Figure 3. On-Time
charged at the rate;
( V IN ? V OUT )
L
To determine the total on-time, or time at which the
inductor charges, the duty cycle needs to be calculated.
The duty cycle can be calculated as;
D =
V IN
and the On time is;
D
2.0MHz
Therefore, peak to peak ripple current is;
( V IN ? V OUT ) × V OUT
Continuous Operation
Figure 2 illustrates the switch voltage and inductor
current during continuous operation.
I pk ? pk =
V IN
2.0MHz × L
Since the average peak to peak current is equal to the
load current. The actual peak (or highest current the
inductor will see in a steady-state condition) is equal to
the output current plus ? the peak-to-peak current.
( V IN ? V OUT ) × V OUT
I pk = I OUT +
V IN
2 × 2.0MHz × L
Figure 2. Continuous Operation
The output voltage is regulated by pulse width
modulating (PWM) the switch voltage to the average
required output voltage. The switching can be broken up
into two cycles; On and Off.
During the on-time, Figure 3 illustrates the high side
Figure 4 demonstrates the off-time. During the off-time,
the high-side internal P-channel MOSFET turns off.
Since the current in the inductor has to discharge, the
current flows through the free-wheeling Schottky diode
to the output. In this case, the inductor discharge rate is
(where V D is the diode forward voltage);
June 2008
9
M9999-062408-A
相关PDF资料
PDF描述
MIC4684YM IC REG BUCK ADJ 2A 8SOIC
LGU2F221MELA CAP ALUM 220UF 315V 20% SNAP
LM2575-12YN IC REG BUCK 12V 1A 16DIP
LM2576-12WU IC REG BUCK 12V 3A TO263-5
PM2110-6R8M INDUCTOR TOROID 6.8UH 20% SMD
相关代理商/技术参数
参数描述
MIC4724YMME TR 功能描述:直流/直流开关调节器 3A 2MHz Buck Regulator in Epad MSOP-10 RoHS:否 制造商:International Rectifier 最大输入电压:21 V 开关频率:1.5 MHz 输出电压:0.5 V to 0.86 V 输出电流:4 A 输出端数量: 最大工作温度: 安装风格:SMD/SMT 封装 / 箱体:PQFN 4 x 5
MIC47300 制造商:MICREL 制造商全称:Micrel Semiconductor 功能描述:3A, Low Voltage, Adjustable LDO Regulator with Dual Input Supply
MIC47300WD 制造商:Micrel 功能描述:Micrel MIC47300WD, Low-Dropout (LDO) Voltage Regulators
MIC47300WD TR 功能描述:低压差稳压器 - LDO 3A Low Voltage, ADJ. High Bandwidth LDO Regulator with Dual Input Supplies RoHS:否 制造商:Texas Instruments 最大输入电压:36 V 输出电压:1.4 V to 20.5 V 回动电压(最大值):307 mV 输出电流:1 A 负载调节:0.3 % 输出端数量: 输出类型:Fixed 最大工作温度:+ 125 C 安装风格:SMD/SMT 封装 / 箱体:VQFN-20
MIC47300WD-TR 功能描述:Linear Voltage Regulator IC Positive Adjustable 1 Output Adj to 0.9V 3A TO-252-5 制造商:microchip technology 系列:- 包装:剪切带(CT) 零件状态:停产 稳压器拓扑:正,可调式 电压 - 输出:可调至 0.9V 电流 - 输出:3A 电压 - 跌落(典型值):0.23V @ 3A 稳压器数:1 电压 - 输入:1.4 V ~ 6.5 V 电流 - 限制(最小值):- 工作温度:-40°C ~ 125°C 安装类型:表面贴装 封装/外壳:TO-252-6,DPak(5 引线 + 接片) 供应商器件封装:TO-252-5 标准包装:1