- 您现在的位置：买卖IC网 > PDF目录80527 > MPC755CVT350 (FREESCALE SEMICONDUCTOR INC) 32-BIT, 350 MHz, RISC PROCESSOR, PBGA360 PDF资料下载
参数资料
| 型号： | MPC755CVT350 |
| 厂商： | FREESCALE SEMICONDUCTOR INC |
| 元件分类： | 微控制器/微处理器 |
| 英文描述： | 32-BIT, 350 MHz, RISC PROCESSOR, PBGA360 |
| 封装： | 25 X 25 MM, 2.77MM HEIGHT, 1.27 MM PITCH, LEAD FREE, PLASTIC, BGA-360 |
| 文件页数： | 33/56页 |
| 文件大小： | 1521K |
| 代理商： | MPC755CVT350 |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页当前第33页第34页第35页第36页第37页第38页第39页第40页第41页第42页第43页第44页第45页第46页第47页第48页第49页第50页第51页第52页第53页第54页第55页第56页
MPC755 RISC Microprocessor Hardware Specifications, Rev. 8
Freescale Semiconductor
39
System Design Information
These capacitors should have a value of 0.01 or 0.1 F. Only ceramic SMT (surface mount technology)
capacitors should be used to minimize lead inductance, preferably 0508 or 0603 orientations where
connections are made along the length of the part.
In addition, it is recommended that there be several bulk storage capacitors distributed around the PCB,
feeding the VDD, L2OVDD, and OVDD planes, to enable quick recharging of the smaller chip capacitors.
These bulk capacitors should have a low ESR (equivalent series resistance) rating to ensure the quick
response time necessary. They should also be connected to the power and ground planes through two vias
to minimize inductance. Suggested bulk capacitors:100–330 F (AVX TPS tantalum or Sanyo OSCON).
8.4
Connection Recommendations
To ensure reliable operation, it is highly recommended to connect unused inputs to an appropriate signal
level through a resistor. Unused active low inputs should be tied to OVDD. Unused active high inputs
should be connected to GND. All NC (no connect) signals must remain unconnected.
Power and ground connections must be made to all external VDD, OVDD, L2OVDD, and GND pins of the
MPC755. Note that power must be supplied to L2OVDD even if the L2 interface of the MPC755 will not
be used; it is recommended to connect L2OVDD to OVDD and L2VSEL to BVSEL if the L2 interface is
unused. (This requirement does not apply to the MPC745 since it has neither an L2 interface nor L2OVDD
pins.)
8.5
Output Buffer DC Impedance
The MPC755 60x and L2 I/O drivers are characterized over process, voltage, and temperature. To measure
Z0, an external resistor is connected from the chip pad to (L2)OVDD or GND. Then, the value of each
The output impedance is the average of two components, the resistances of the pull-up and pull-down
devices. When data is held low, SW2 is closed (SW1 is open), and RN is trimmed until the voltage at the
pad equals (L2)OVDD/2. RN then becomes the resistance of the pull-down devices. When data is held high,
SW1 is closed (SW2 is open), and RP is trimmed until the voltage at the pad equals (L2)OVDD/2. RP then
becomes the resistance of the pull-up devices.
相关PDF资料 |
PDF描述 |
|---|---|
| MPC8255ZUIGAXXX | 32-BIT, 200 MHz, RISC PROCESSOR, PBGA480 |
| MPC8260CZUIGAXXX | 32-BIT, 200 MHz, RISC PROCESSOR, PBGA480 |
| MPC859PVR133A | 32-BIT, 133 MHz, RISC PROCESSOR, PBGA357 |
| MPC859PZP100A | 32-BIT, 100 MHz, RISC PROCESSOR, PBGA357 |
| MC68HC908EY16KFAE | 8-BIT, FLASH, 8 MHz, MICROCONTROLLER, PQFP32 |
相关代理商/技术参数 |
参数描述 |
|---|---|
| MPC755CVT350LE | 功能描述:微处理器 - MPU GF RV2.8,4A,105C,6W RoHS:否 制造商:Atmel 处理器系列:SAMA5D31 核心:ARM Cortex A5 数据总线宽度:32 bit 最大时钟频率:536 MHz 程序存储器大小:32 KB 数据 RAM 大小:128 KB 接口类型:CAN, Ethernet, LIN, SPI,TWI, UART, USB 工作电源电压:1.8 V to 3.3 V 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:FBGA-324 |
| MPC755CVT400LE | 功能描述:微处理器 - MPU GF RV2.84A105C RoHS:否 制造商:Atmel 处理器系列:SAMA5D31 核心:ARM Cortex A5 数据总线宽度:32 bit 最大时钟频率:536 MHz 程序存储器大小:32 KB 数据 RAM 大小:128 KB 接口类型:CAN, Ethernet, LIN, SPI,TWI, UART, USB 工作电源电压:1.8 V to 3.3 V 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:FBGA-324 |
| MPC76 | 制造商:未知厂家 制造商全称:未知厂家 功能描述:Metal Plate Cement Resistors |
| MPC76-0.05HK | 制造商:FUKUSHIMA 功能描述: |
| MPC76-103J | 制造商:未知厂家 制造商全称:未知厂家 功能描述:Metal Plate Cement Resistors |
发布紧急采购，3分钟左右您将得到回复。