- 您现在的位置：买卖IC网 > PDF目录80397 > MPE603ERX100TX (FREESCALE SEMICONDUCTOR INC) 32-BIT, 100 MHz, RISC PROCESSOR, CBGA255 PDF资料下载
参数资料
| 型号： | MPE603ERX100TX |
| 厂商： | FREESCALE SEMICONDUCTOR INC |
| 元件分类： | 微控制器/微处理器 |
| 英文描述： | 32-BIT, 100 MHz, RISC PROCESSOR, CBGA255 |
| 封装： | 21 X 21 MM, 3 MM HEIGHT, 1.27 MM PITCH, CERAMIC, BGA-255 |
| 文件页数： | 18/32页 |
| 文件大小： | 250K |
| 代理商： | MPE603ERX100TX |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页当前第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页
PID6-603e Hardware Specifications, Rev 2
25
1.8.2 PLL Power Supply Filtering
The AVdd power signal is provided on the 603e to provide power to the clock generation phase-locked loop.
To ensure stability of the internal clock, the power supplied to the AVdd input signal should be ltered using
a circuit similar to the one shown in Figure 13. The circuit should be placed as close as possible to the AVdd
pin to ensure it lters out as much noise as possible.
Figure 13. PLL Power Supply Filter Circuit
1.8.3 Decoupling Recommendations
Due to the 603e’s dynamic power management feature, large address and data buses, and high operating
frequencies, the 603e can generate transient power surges and high frequency noise in its power supply,
especially while driving large capacitive loads. This noise must be prevented from reaching other
components in the 603e system, and the 603e itself requires a clean, tightly regulated source of power.
Therefore, it is strongly recommended that the system designer place at least one decoupling capacitor at
each Vdd and OVdd pin of the 603e. It is also recommended that these decoupling capacitors receive their
power from separate Vdd, OVdd, and GND power planes in the PCB, utilizing short traces to minimize
inductance.
These capacitors should vary in value from 220 pF to 10
F to provide both high- and low-frequency
ltering, and should be placed as close as possible to their associated Vdd or OVdd pin. Suggested values
for the Vdd pins—220 pF (ceramic), 0.01 F (ceramic), and 0.1 F (ceramic). Suggested values for the
OVdd pins—0.01 F (ceramic), 0.1 F (ceramic), and 10 F (tantalum). Only SMT (surface mount
technology) capacitors should be used to minimize lead inductance.
In addition, it is recommended that there be several bulk storage capacitors distributed around the PCB,
feeding the Vdd and OVdd planes, to enable quick recharging of the smaller chip capacitors. These bulk
capacitors should also have a low ESR (equivalent series resistance) rating to ensure the quick response time
necessary. They should also be connected to the power and ground planes through two vias to minimize
inductance. Suggested bulk capacitors—100 F (AVX TPS tantalum) or 330 F (AVX TPS tantalum).
1.8.4 Connection Recommendations
To ensure reliable operation, it is recommended to connect unused inputs to an appropriate signal level.
Unused active low inputs should be tied to Vdd. Unused active high inputs should be connected to GND.
All NC (no-connect) signals must remain unconnected.
1.8.5 Pull-up Resistor Requirements
The 603e requires high-resistive (weak: 10 KOhms) pull-up resistors on several control signals of the bus
interface to maintain the control signals in the negated state after they have been actively negated and
released by the 603e or other bus master. These signals are—TS, ABB, DBB, ARTRY.
In addition, the 603e has three open-drain style outputs that require pull-up resistors (weak or stronger:
4.7 KOhms–10 KOhms) if they are used by the system. These signals are—APE, DPE, and CKSTP_OUT.
Vdd
AVdd
10
10 F
0
.1 F
GND
F
re
e
sc
a
le
S
e
m
ic
o
n
d
u
c
to
r,
I
Freescale Semiconductor, Inc.
For More Information On This Product,
Go to: www.freescale.com
n
c
..
.
相关PDF资料 |
PDF描述 |
|---|---|
| MC68HC08GP32VFB | 8-BIT, MROM, 8.2 MHz, MICROCONTROLLER, PQFP44 |
| MC68HSC05C9AP | 8-BIT, MROM, 4.1 MHz, MICROCONTROLLER, PDIP40 |
| MC9S08RD32FG | 8-BIT, FLASH, 8 MHz, MICROCONTROLLER, PQFP44 |
| MC9S08RG60CFG | 8-BIT, FLASH, 8 MHz, MICROCONTROLLER, PQFP44 |
| MC68HC11E0VFU2 | 8-BIT, 2 MHz, MICROCONTROLLER, PQFP64 |
相关代理商/技术参数 |
参数描述 |
|---|---|
| MPE603ERX133LN | 制造商:未知厂家 制造商全称:未知厂家 功能描述:PowerPC 603e RISC Microprocessor Family: PID6-603e (Stretch) Part Number Specifications |
| MPE603RRX200LC | 制造商:Freescale Semiconductor 功能描述: |
| MPE603RRX266LC | 制造商:Motorola Inc 功能描述: |
| MPE-60S | 制造商:MPD 制造商全称:MicroPower Direct, LLC 功能描述:Single Output, 60W Compact, Enclosed AC/DC Power Supplies |
| MPE-60S-05 | 制造商:MPD 制造商全称:MicroPower Direct, LLC 功能描述:Single Output, 60W Compact, Enclosed AC/DC Power Supplies |
发布紧急采购，3分钟左右您将得到回复。