参数资料
型号: MRF1507T1
元件分类: 功率晶体管
英文描述: UHF BAND, Si, N-CHANNEL, RF POWER, MOSFET
封装: POWER, PLASTIC, CASE 466-02, 4 PIN
文件页数: 2/12页
文件大小: 173K
代理商: MRF1507T1
LIFETIME
BUY
LAST
ORDER
30JUN02
LAST
SHIP
30DEC0
2
MRF1507
10
MOTOROLA RF DEVICE DATA
DC BIAS
Since the MRF1507 is an enhancement mode FET, drain
current flows only when the gate is at a higher potential than
the source. RF power FETs operate optimally with a quiescent
drain current (IDQ), whose value is application dependent. The
MRF1507 was characterized at IDQ = 150 mA, which is the
suggested value of bias current for typical applications. For
special applications such as linear amplification, IDQ may have
to be selected to optimize the critical parameters.
The gate is a dc open circuit and draws no current.
Therefore, the gate bias circuit may generally be just a simple
resistive divider network. Some special applications may
require a more elaborate bias system.
GAIN CONTROL
Power output of the MRF1507 may be controlled to some
degree with a low power dc control signal applied to the gate,
thus facilitating applications such as manual gain control,
ALC/AGC and modulation systems. This characteristic is very
dependent on frequency and load line.
MOUNTING
The specified maximum thermal resistance of 2
°C/W
assumes a majority of the 0.065
″ x 0.180″ source contact on
the back side of the package is in good contact with an
appropriate heat sink. As with all RF power devices, the goal
of the thermal design should be to minimize the temperature
at the back side of the package.
AMPLIFIER DESIGN
Impedance matching networks similar to those used with
bipolar transistors are suitable for the MRF1507. For exam-
ples see Motorola Application Note AN721, “Impedance
Matching Networks Applied to RF Power Transistors.” Large–
signal impedances are provided, and will yield a good first
pass approximation.
Since RF power MOSFETs are triode devices, they are not
unilateral. This coupled with the very high gain of the
MRF1507 yields a device capable of self oscillation. Stability
may be achieved by techniques such as drain loading, input
shunt resistive loading, or output to input feedback. The RF
test fixture implements a parallel resistor and capacitor in
series with the gate, and has a load line selected for a higher
efficiency, lower gain, and more stable operating region.
Tw o–port stability analy s i s with the MRF1507
S–parameters provides a useful tool for selection of loading or
feedback circuitry to assure stable operation. See Motorola
Application Note AN215A, “RF Small–Signal Design Using
Two–Port Parameters” for a discussion of two port network
theory and stability.
相关PDF资料
PDF描述
MRF1508 UHF BAND, Si, N-CHANNEL, RF POWER, MOSFET
MRF1508T1 UHF BAND, Si, N-CHANNEL, RF POWER, MOSFET
MRF1508 UHF BAND, Si, N-CHANNEL, RF POWER, MOSFET
MRF1511NT1 VHF BAND, Si, N-CHANNEL, RF POWER, MOSFET
MRF1511T1 VHF BAND, Si, N-CHANNEL, RF POWER, MOSFET
相关代理商/技术参数
参数描述
MRF15090 制造商:MOTOROLA 制造商全称:Motorola, Inc 功能描述:RF POWER TRANSISTOR
MRF150J 功能描述:射频MOSFET电源晶体管 RoHS:否 制造商:Freescale Semiconductor 配置:Single 晶体管极性: 频率:1800 MHz to 2000 MHz 增益:27 dB 输出功率:100 W 汲极/源极击穿电压: 漏极连续电流: 闸/源击穿电压: 最大工作温度: 封装 / 箱体:NI-780-4 封装:Tray
MRF150MP 制造商:M/A-COM Technology Solutions 功能描述:RF POWER TRANSISTOR MOSFET
MRF151 功能描述:射频MOSFET电源晶体管 5-175MHz 150Watts 50Volt Gain 18dB RoHS:否 制造商:Freescale Semiconductor 配置:Single 晶体管极性: 频率:1800 MHz to 2000 MHz 增益:27 dB 输出功率:100 W 汲极/源极击穿电压: 漏极连续电流: 闸/源击穿电压: 最大工作温度: 封装 / 箱体:NI-780-4 封装:Tray
MRF1511N 制造商:FREESCALE 制造商全称:Freescale Semiconductor, Inc 功能描述:RF Power Field Effect Transistor