参数资料
| 型号： | NCP1280DR2G |
| 厂商： | ON Semiconductor |
| 文件页数： | 12/17页 |
| 文件大小： | 0K |
| 描述： | IC CTRLR PWM PROG OVP HV 16SOIC |
| 产品变化通告： | Product Obsolescence 01/Jul/2009 |
| 标准包装： | 1 |
| 输出隔离： | 隔离 |
| 频率范围： | 140kHz ~ 320kHz |
| 输入电压： | 7 V ~ 25 V |
| 工作温度： | -40°C ~ 150°C |
| 封装/外壳： | 16-SOIC（0.154"，3.90mm 宽） |
| 供应商设备封装： | 16-SOIC N |
| 包装： | 剪切带 (CT) |
| 其它名称： | NCP1280DR2GOSCT |
NCP1280
V in
I START
V AUX
I START
To auxiliary supply
Line Under/Overvoltage Shutdown
The NCP1280 incorporates line undervoltage and
I AUX
C AUX
I supply
overvoltage shutdown (UV/OV) circuits. The under voltage
(UV) threshold is 1.52 V and the overvoltage threshold
Disable
Figure 29. Recommended V AUX Configuration
Power to the controller while operating in the self ? bias or
DSS mode is provided by C AUX . Therefore, C AUX must be
sized such that a V AUX voltage greater than 7 V is
maintained while the outputs are switching and the
converter reaches regulation. Also, the V AUX discharge time
(from 11 V to 7 V) must be greater that the soft ? start charge
period to assure the converter turns ON.
The startup circuit is rated at a maximum voltage of 700 V.
If the device operates in the DSS mode, power dissipation
should be controlled to avoid exceeding the maximum
power dissipation of the controller.
V AUX(on)
V AUX
V AUX(off)
0V
V OV
UV/OV Voltage
V UV
0V
(OV) is 3.61 V, for a ratio of 1:2.4. If the input voltage range
exceeds the pre ? set OV threshold, the OV function can be
disabled by connecting a Zener from this pin to ground. The
Zener voltage should be less than 3.6 V.
The UV/OV circuit can be biased using an external
resistor divider from the input line. The resistor divider must
be sized to enable the controller once V in is within the
required operating range. If the UV or OV threshold is
reached, the soft ? start capacitor is discharged, and the
outputs are immediately disabled with no overlap delay as
shown in Figure 30. Also, if an UV condition is detected, the
5.0 V Reference Supply is disabled.
UV or OV Fault
Propagation delay to
outputs (t UV or t OV )
OUT2
0V
OUT1
0V
Figure 30. UV/OV Fault Timing Diagram
Once the UV or OV condition is removed and V AUX
reaches 11 V, the controller initiates a soft ? start cycle.
Figure 31 shows the relationship between the UV/OV
The UV/OV pin can also be used to implement a remote
enable/disable function. Biasing the UV/OV pin below its
UV threshold disables the converter.
voltage, the outputs and the soft ? start voltage.
http://onsemi.com
12
相关PDF资料 |
PDF描述 |
|---|---|
| NCP1282BDR2G | IC REG CTRLR BST FLYBK VM 16SOIC |
| NCP1288BD65R2G | IC REG CTRLR FLYBACK PWM 7SOIC |
| NCP1294EDR2G | IC PWM CTLR FLYBACK 16SOIC |
| NCP1308DR2G | IC REG CTRLR FLYBACK PWM 8-SOIC |
| NCP1337DR2G | IC REG CTRLR FLYBK ISO PWM 7SOIC |
相关代理商/技术参数 |
参数描述 |
|---|---|
| NCP1282 | 制造商:ONSEMI 制造商全称:ON Semiconductor 功能描述:Power Factor Controllers |
| NCP1282BDR2G | 功能描述:电压模式 PWM 控制器 HI PRF RSET PWM CNTR RoHS:否 制造商:Texas Instruments 输出端数量:1 拓扑结构:Buck 输出电压:34 V 输出电流: 开关频率: 工作电源电压:4.5 V to 5.5 V 电源电流:600 uA 最大工作温度:+ 125 C 最小工作温度:- 40 C 封装 / 箱体:WSON-8 封装:Reel |
| NCP1288 | 制造商:ONSEMI 制造商全称:ON Semiconductor 功能描述:Fixed Frequency Current Mode Controller for Flyback Converters |
| NCP1288_11 | 制造商:ONSEMI 制造商全称:ON Semiconductor 功能描述:Fixed Frequency Current Mode Controller for Flyback Converters |
| NCP1288BD65R2G | 功能描述:功率因数校正 IC NODSS AUTOR SOCP 65KHZ RoHS:否 制造商:Fairchild Semiconductor 开关频率:300 KHz 最大功率耗散: 最大工作温度:+ 125 C 安装风格:SMD/SMT 封装 / 箱体:SOIC-8 封装:Reel |
发布紧急采购，3分钟左右您将得到回复。