- 您现在的位置：买卖IC网 > PDF目录299551 > NCP362BMUTBG (ON SEMICONDUCTOR) OVP/OCP + TVS PDF资料下载
参数资料
| 型号： | NCP362BMUTBG |
| 厂商： | ON SEMICONDUCTOR |
| 元件分类： | 参考电压二极管 |
| 英文描述： | OVP/OCP + TVS |
| 中文描述： | UNIDIRECTIONAL, SILICON, TVS DIODE |
| 封装： | 2.50 X 2 MM, LEAD FREE, CASE 517AV-01, 10 PIN |
| 文件页数： | 3/16页 |
| 文件大小： | 722K |
| 代理商： | NCP362BMUTBG |
NCP362
http://onsemi.com
11
Operation
NCP362 provides overvoltage protection for positive
voltage, up to 20 V. A PMOS FET protects the systems
(i.e.: VBUS) connected on the Vout pin, against positive
overvoltage. The Output follows the VBUS level until
OVLO threshold is overtaken.
Undervoltage Lockout (UVLO)
To ensure proper operation under any conditions, the
device has a builtin undervoltage lock out (UVLO)
circuit. During Vin positive going slope, the output remains
disconnected from input until Vin voltage is above 3.0 V
nominal. The FLAG output is pulled to low as long as Vin
does not reach UVLO threshold. This circuit has a 70 mV
hysteresis to provide noise immunity to transient condition.
Figure 24. Output Characteristic vs. Vin
Vin (V)
20 V
OVLO
UVLO
0
Vout
OVLO
UVLO
0
Overvoltage Lockout (OVLO)
To protect connected systems on Vout pin from
overvoltage, the device has a builtin overvoltage lock out
(OVLO) circuit. During overvoltage condition, the output
remains disabled until the input voltage exceeds 6.0 V.
FLAG output is tied to low until Vin is higher than
OVLO. This circuit has a 100 mV hysteresis to provide
noise immunity to transient conditions.
Overcurrent Protection (OCP)
The NCP362 integrates overcurrent protection to
prevent system/battery overload or defect. The current
limit threshold is internally set at 750 mA. This value can
be changed from 150 mA to 750 mA by a metal tweak,
please contact your ON Semiconductor representative for
availability. During current fault, the internal PMOS FET
is automatically turned off (5
ms) if the charge current
exceeds Ilim. NCP362 goes into turn on and turn off mode
as long as defect is present. The internal ton delay (4 ms
typical) allows limiting thermal dissipation. The Flag pin
goes to low level when an overcurrent fault appears. That
allows the microcontroller to count defect events and turns
off the PMOS with EN pin.
Vout
I
t
toff
ton
Ilimit
Figure 25. Overcurrent Event Example
Overcurrent
Retrieve normal
operation
FLAG Output
NCP362 provides a FLAG output, which alerts external
systems that a fault has occurred.
This pin is tied to low as soon as: 1.2 V < Vin < UVLO,
Vin > OVLO, Icharge > Ilimit, TJ > 150°C. When NCP362
recovers normal condition, FLAG is held high. The pin is
an open drain output, thus a pull up resistor (typically 1 M
W
Minimum 10 k
W) must be provided to VCC. FLAG pin is
an open drain output.
EN Input
To enable normal operation, the EN pin shall be forced
to low or connected to ground. A high level on the pin
disconnects OUT pin from IN pin. EN does not overdrive
an OVLO or UVLO fault.
Internal PMOS FET
The NCP362 includes an internal PMOS FET to protect
the systems, connected on OUT pin, from positive
overvoltage. Regarding electrical characteristics, the
RDS(on), during normal operation, will create low losses on
Vout pin, characterized by Vin versus Vout dropout.
相关PDF资料 |
PDF描述 |
|---|---|
| NCT1008DMT3R2G | %2B-1℃ temperature monitor with series resistance cancellation |
| NCV4275ADS50G | 450 mA, 5.0V, LDO w/Reset and Delay |
| NCV4275ADS50R4G | 450 mA, 5.0V, LDO w/Reset and Delay |
| NCV4275ADT33RKG | 450 mA, 3.3 V, LDO w/Reset and Delay |
| NCV4275ADT50RKG | 450 mA, 5.0V, LDO w/Reset and Delay |
相关代理商/技术参数 |
参数描述 |
|---|---|
| NCP362CMUTBG | 功能描述:监控电路 POSITIVE OVP + ESD RoHS:否 制造商:STMicroelectronics 监测电压数: 监测电压: 欠电压阈值: 过电压阈值: 输出类型:Active Low, Open Drain 人工复位:Resettable 监视器:No Watchdog 电池备用开关:No Backup 上电复位延迟（典型值）:10 s 电源电压-最大:5.5 V 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:UDFN-6 封装:Reel |
| NCP362GEVB | 功能描述:BOARD EVAL FOR NCP362G RoHS:是 类别:编程器，开发系统 >> 评估演示板和套件 系列:* 标准包装:1 系列:PCI Express® (PCIe) 主要目的:接口，收发器，PCI Express 嵌入式:- 已用 IC / 零件:DS80PCI800 主要属性:- 次要属性:- 已供物品:板 |
| NCP367DPMUECTBG | 功能描述:电池管理 OCP OVP USB AND AC/DC RoHS:否 制造商:Texas Instruments 电池类型:Li-Ion 输出电压:5 V 输出电流:4.5 A 工作电源电压:3.9 V to 17 V 最大工作温度:+ 85 C 最小工作温度:- 40 C 封装 / 箱体:VQFN-24 封装:Reel |
| NCP367DPMUEETBG | 功能描述:电池管理 OCP OVP USB AND AC/DC RoHS:否 制造商:Texas Instruments 电池类型:Li-Ion 输出电压:5 V 输出电流:4.5 A 工作电源电压:3.9 V to 17 V 最大工作温度:+ 85 C 最小工作温度:- 40 C 封装 / 箱体:VQFN-24 封装:Reel |
| NCP367DPMUELTBG | 功能描述:电池管理 OCP OVP USB AND AC/DC RoHS:否 制造商:Texas Instruments 电池类型:Li-Ion 输出电压:5 V 输出电流:4.5 A 工作电源电压:3.9 V to 17 V 最大工作温度:+ 85 C 最小工作温度:- 40 C 封装 / 箱体:VQFN-24 封装:Reel |
发布紧急采购，3分钟左右您将得到回复。