参数资料
型号: NCP5021MUTXG
厂商: ON Semiconductor
文件页数: 11/17页
文件大小: 0K
描述: IC WHITE LED DVR HV AMB 16-UQFN
产品变化通告: Product Obsolescence 07/Jul/2010
标准包装: 3,000
拓扑: PWM,升压(升压)
输出数: 1
内部驱动器:
类型 - 主要: 背光,闪灯/白光
类型 - 次要: 白色 LED
频率: 1.13MHz ~ 1.47MHz
电源电压: 2.7 V ~ 5.5 V
输出电压: 32V
安装类型: 表面贴装
封装/外壳: 16-UFQFN 裸露焊盘
供应商设备封装: 16-UQFN-EP(3x3)
包装: 带卷 (TR)
工作温度: -40°C ~ 85°C
NCP5021
100
HORUS : Iout %= F(Step)
Iout %
10
1
0.1
? 0.1
10
STEP
20.1
30.2
Figure 9. Typical ILED Programming Curve
ILEDREG[0..7] I ? LED PEAK CURRENT
B7
B6
B5
B4
B3
B2
B1
B0
step
RESET
0
0
0
0
0
0
ILED16
0
ILED8
0
ILED4
0
ILED2
0
ILED1
0
Bits [B7:B5] : Reserved for future use
Bits [B4:B0] : ILED peak current setup
Inductor Peak Current
The peak current flowing into the inductor during normal
application is set up by the external resistor R PCA
connected between the I PK pin and ground.
The maximum I PK current is given by the internal current
mirror ratio (multiplier ? kk ? ) typically equal to 9700. In
other word, to get a 750 mA maximum peak current in the
inductor, the reference current shall be 750 mA/9700 =
79 m A. This current is used to calculate the resistor
connected between the I PK pin and GND: R REF = 1.144 /
79e ? 6 = 14.4 k W .
The concept depicted in the ILED peak current
paragraph applies as well and cares must be observed to
avoid any voltage source connection to the IPK pin.
Gradual Dimming
The purpose of that function is to gradually Increase or
Decrease the brightness of the backlight / keyboard LED
upon command from the external MCU. The function is
activated and controlled by means of the I2C protocol.
The period (either upward or downward) is equal to the
time defined for each step, multiplied by the number of
steps. The number of step is derived from the value
associated with the target current.
To operate such a function, the MCU will provide three
information:
1. The target current level (either upward or
downward)
2. The time per step
3. The Upward or Downward mode of operation
When a new gradual dimming sequence is requested, the
output current increases, according to the logarithmic
curve, from the existing start value to the end value. The
end current value is defined by the contain of the Upward
or Downward register, the width of each step is defined by
the third register, the number of step being in the 1 to 32
range ($00 to $1F). In the event of software error, the
system checks that neither the maximum output current
(25 mA), nor the zero level are forced out of their
respective bounds. Similarly, software errors shall not
force NCP5021 into an uncontrolled mode of operation.
The dimming is built with 32 steps and the time delay
encoded into the third byte of the I2C transaction.
When the gradual dimming is not requested (register
selection = $01), the output current is straightforwardly set
up to the level defined by the contain of the related register
upon acknowledge of the output current byte.
The gradual dimming sequence must be set up before a
new output current data byte is send to NCP5021. At this
point, the brightness sequence takes place when the new
data byte is acknowledged by the internal I2C decoder.
Since the six registers are loaded on independent byte flow
associated to the I2C address, any parameter of the
NCP5021 chip can be updated ahead of the next function.
http://onsemi.com
11
相关PDF资料
PDF描述
NCP5050MTTXG IC LED DRIVR PHOTO FLASH 10-WDFN
NCP5111DR2G IC DRIVER HI/LOW SIDE HV 8-SOIC
NCP5304DR2G IC DRIVER HI/LOW SIDE HV 8-SOIC
NCP5355DG IC DRVR SYNC BUCK MOSF 12A 8SOIC
NCP5359ADR2G IC MOSFET GATE DVR DUAL 8-SOIC
相关代理商/技术参数
参数描述
NCP502ASQ15T1 制造商:ONSEMI 制造商全称:ON Semiconductor 功能描述:80 mA CMOS Low Iq Voltage Regulator in an SC70−5
NCP502ASQ15T1G 制造商:ONSEMI 制造商全称:ON Semiconductor 功能描述:80 mA CMOS Low Iq, Low−Dropout Voltage Regulator
NCP502ASQ18T1 制造商:ONSEMI 制造商全称:ON Semiconductor 功能描述:80 mA CMOS Low Iq Voltage Regulator in an SC70−5
NCP502ASQ18T1G 制造商:ONSEMI 制造商全称:ON Semiconductor 功能描述:80 mA CMOS Low Iq, Low−Dropout Voltage Regulator
NCP502ASQ25T1 制造商:ONSEMI 制造商全称:ON Semiconductor 功能描述:80 mA CMOS Low Iq Voltage Regulator in an SC70−5