参数资料
| 型号： | NCS36000DG |
| 厂商： | ON Semiconductor |
| 文件页数： | 4/8页 |
| 文件大小： | 0K |
| 描述： | IC PIR DETECTOR CTLR 14SOIC |
| 标准包装： | 55 |
| 类型： | 检测器控制器 |
| 输入类型： | 数字 |
| 输出类型： | 数字 |
| 接口： | CMOS |
| 电流 - 电源： | 50µA |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 14-SOIC（0.154"，3.90mm 宽） |
| 供应商设备封装： | 14-SOICN |
| 包装： | 托盘 |
NCS36000
http://onsemi.com
4
APPLICATIONS INFORMATION
Oscillator
The oscillator uses an external resistor and capacitor to set
the system clock frequency. Multiple clock frequencies can
be selected using different combinations of resistors and
capacitors. Figure 2 shows a simplifier block diagram for
the system oscillator.
+
+
OSC
13
Q
SET
CLR
S
R
14
VDD
Figure 2. Block Diagram of System Oscillator Circuit
LDO Regulator
The LDO regulator provides the reference voltage for the
sensor and all other analog blocks within the system. The
nominal voltage reference for the sensor is 2.7 V
±5%. An
external capacitor is needed on the VREF pin to guarantee
stability of the regulator.
Differential Amplifiers
The two differential amplifiers can be configured as a
bandpass filter to condition the PIR sensor signal for the post
digital signal processing. The cutoff frequencies and
passband gain are set by the external components. See
Figure 5.
10
1
10
0
10
1
20
30
40
50
60
70
80
Figure 3. Plot Showing Typical Magnitude Response
of Differential Amplifiers When Configured as a
Bandpass Filter
Window Comparator
The window comparator compares the voltage from the
second differential amplifier to two reference voltages from
the LDO regulator. COMP_P triggers if OP2_O is greater
than the Vh voltage and COMP_N triggers if OP2_O is
Vh
Vl
Vdd
Vss
Comp_P
Vdd
Vss
Comp_N
OP2_O
Vm
Figure 4. Plot Showing Functionality of Window Comparator for an Analog Input OP2_O
相关PDF资料 |
PDF描述 |
|---|---|
| NCS6415DWR2G | IC VIDEO SWITCH 8X6 20SOIC |
| NCS6416DWR2G | IC VIDEO SWITCH 8X6 20SOIC |
| NCS6433DTBR2G | IC VIDEO SW QUAD 2:1 16-TSSOP |
| NCV1124DG | IC SENSOR DUAL VAR-RELUCT 8-SOIC |
| NCV7001DWG | IC SENSOR VAR RELUCT QUAD 24SOIC |
相关代理商/技术参数 |
参数描述 |
|---|---|
| NCS36000DRG | 功能描述:LED照明驱动器 PIR ASSP RoHS:否 制造商:STMicroelectronics 输入电压:11.5 V to 23 V 工作频率: 最大电源电流:1.7 mA 输出电流: 最大工作温度: 安装风格:SMD/SMT 封装 / 箱体:SO-16N |
| NCS37000 | 制造商:ONSEMI 制造商全称:ON Semiconductor 功能描述:Ground Fault Circuit Interrupter (GFCI) |
| NCS37000DBG | 制造商:ON Semiconductor 功能描述:GFCI NON ST TSSOP - Rail/Tube |
| NCS37000DBRG | 制造商:ON Semiconductor 功能描述:GFCI NON ST TSSOP - Tape and Reel |
| NCS37000MNG | 功能描述:电流和电力监控器、调节器 GFCI ST ASSP RoHS:否 制造商:STMicroelectronics 产品:Current Regulators 电源电压-最大:48 V 电源电压-最小:5.5 V 工作温度范围:- 40 C to + 150 C 安装风格:SMD/SMT 封装 / 箱体:HPSO-8 封装:Reel |
发布紧急采购，3分钟左右您将得到回复。