- 您现在的位置：买卖IC网 > PDF目录6028 > OP484FSZ-REEL7 (Analog Devices Inc)IC OPAMP GP R-R 4.25MHZ 14SOIC PDF资料下载
参数资料
| 型号： | OP484FSZ-REEL7 |
| 厂商： | Analog Devices Inc |
| 文件页数： | 10/24页 |
| 文件大小： | 0K |
| 描述： | IC OPAMP GP R-R 4.25MHZ 14SOIC |
| 标准包装： | 1 |
| 放大器类型： | 通用 |
| 电路数： | 4 |
| 输出类型： | 满摆幅 |
| 转换速率： | 4 V/µs |
| 增益带宽积： | 4.25MHz |
| 电流 - 输入偏压： | 80nA |
| 电压 - 输入偏移： | 250µV |
| 电流 - 电源： | 2.25mA |
| 电流 - 输出 / 通道： | 10mA |
| 电压 - 电源，单路/双路(±)： | 3 V ~ 36 V，±1.5 V ~ 18 V |
| 工作温度： | -40°C ~ 125°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 14-SOIC（0.154"，3.90mm 宽） |
| 供应商设备封装： | 14-SO |
| 包装： | 剪切带 (CT) |
| 其它名称： | OP484FSZ-REEL7CT |
OP184/OP284/OP484
Rev. J | Page 18 of 24
HIGH-SIDE CURRENT MONITOR
In the design of power supply control circuits, a great deal of design
effort is focused on ensuring the long-term reliability of a pass
transistor over a wide range of load current conditions. As a result,
monitoring and limiting device power dissipation is of prime
importance in these designs. The circuit shown in Figure 55 is
an example of a 3 V, single-supply, high-side current monitor that
can be incorporated into the design of a voltage regulator with
fold-back current limiting or a high current power supply with
crowbar protection. This design uses an OP284 rail-to-rail input
voltage range to sense the voltage drop across a 0.1 Ω current shunt.
A P-channel MOSFET, used as the feedback element in the circuit,
converts the differential input voltage of the op amp into a current.
This current is applied to R2 to generate a voltage that is a linear
representation of the load current. The transfer equation for the
current monitor is given by
Monitor Output =
L
SENSE
I
R1
R
R2
×
×
For the element values shown, the transfer characteristic of the
monitor output is 2.5 V/A.
00293-
055
RSENSE
0.1
IL
8
1
4
3
3V
G
S
D
2
M1
SI9433
MONITOR
OUTPUT
3V
1/2
OP284
R1
100
R2
2.49k
0.1F
Figure 55. High-Side Load Current Monitor
CAPACITIVE LOAD DRIVE CAPABILITY
The OP284 exhibits excellent capacitive load driving capabilities.
It can drive up to 1 nF, as shown in Figure 30. Even though the
device is stable, a capacitive load does not come without penalty in
bandwidth. The bandwidth is reduced to less than 1 MHz for loads
greater than 2 nF. A snubber network on the output does not
increase the bandwidth, but it does significantly reduce the amount
of overshoot for a given capacitive load.
A snubber consists of a series R-C network (RS, CS), as shown in
Figure 56, connected from the output of the device to ground.
This network operates in parallel with the load capacitor, CL, to
provide the necessary phase lag compensation. The value of the
resistor and capacitor is best determined empirically.
00293-
056
RS
50
0.1F
CL
1nF
CS
100nF
5V
VIN
100mV p-p
VOUT
1/2
OP284
Figure 56. Snubber Network Compensates for Capacitive Load
The first step is to determine the value of Resistor RS. A good
starting value is 100 Ω (typically, the optimum value is less than
100 Ω). This value is reduced until the small-signal transient
response is optimized. Next, CS is determined; 10 μF is a good
starting point. This value is reduced to the smallest value for
acceptable performance (typically, 1 μF). For the case of a 10 nF
load capacitor on the OP284, the optimal snubber network is
a 20 Ω in series with 1 μF. The benefit is immediately apparent,
as shown in the scope photo in Figure 57. The top trace was taken
with a 1 nF load, and the bottom trace was taken with the 50 Ω,
100 nF snubber network in place. The amount of overshoot and
ringing is dramatically reduced. Table 7 shows a few sample
snubber networks for large load capacitors.
00293-
057
2s
100
90
10
0%
50mV
1nF LOAD
ONLY
SNUBBER
IN
CIRCUIT
DLY
5.49s
50mV
B
W
Figure 57. Overshoot and Ringing Are Reduced by Adding a Snubber
Network in Parallel with the 1 nF Load
Table 7. Snubber Networks for Large Capacitive Loads
Load Capacitance (CL)
Snubber Network (RS, CS)
1 nF
50 , 100 nF
10 nF
20 , 1 F
100 nF
5 , 10 F
相关PDF资料 |
PDF描述 |
|---|---|
| AD8221BRZ | IC AMP INSTRUMENT PREC HP 8SOIC |
| OP293ESZ | IC OPAMP GP 35KHZ DUAL 8SOIC |
| PBC12SFDN | CONN HEADER .100 SINGL STR 12POS |
| AD8250ARMZ | IC AMP INST ICMOS LDRIFT 10MSOP |
| 929836-05-01-RK | CONN HEADER .100 DUAL STR 2POS |
相关代理商/技术参数 |
参数描述 |
|---|---|
| OP490 | 制造商:AD 制造商全称:Analog Devices 功能描述:Low Voltage Micropower Quad Operational Amplifier |
| OP4900046S | 制造商:Rochester Electronics LLC 功能描述:- Bulk |
| OP490019S | 制造商:Analog Devices 功能描述: |
| OP490-019S | 制造商:Analog Devices 功能描述: |
| OP490ATC/883 | 制造商:AD 制造商全称:Analog Devices 功能描述:Low Voltage Micropower Quad Operational Amplifier |
发布紧急采购，3分钟左右您将得到回复。